Instruction/ maintenance manual of the product SP-UXP5 JVC
Go to page of 28
GVT0053-001A [J] For Customer Use: Enter below the Model No . and Serial No. which are located either on the rear , bot- tom or side of the cabinet. Retain this inf or mation f or future reference . Model No . Se r ia l N o. FS-P5 — Consists of CA-FSP5 and SP-UXP5.
– G-1 – W arnings, Cautions and Others Mises en garde, précautions et indications diverses CAUTION T o reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture.
– G-2 – GROUND CLAMP ELECTRIC SERVICE EQUIPMENT NEC — NA TIONAL ELECTRICAL CODE POWER SER VICE GROUNDING ELECTRODE SYSTEM (NEC ART 250. P ART H) GROUND CLAMPS GROUNDING CONDUCTORS (NEC SECTION 8.
– 1 – Introduction About This Manual This manual is org anized as follows: • The manual mainly explains operations using the b uttons on the remote contr ol. Y ou can use the buttons both on the r emote control and on the unit f or the same operations if they ha ve the same or similar names (or marks), unless mentioned otherwise.
– 2 – Contents Location of the Buttons and Controls ....................... 3 Front Panel ................................................................. 3 Remote Control .......................................................... 5 Getting Started .
– 3 – COMPACT DIGITAL AUDIO CD T APE FM/AM COMPACT COMPONENT SYSTEM FS-P5 CD-R/RW PLA YBACK MD/AUX TIMER CLOCK STANDBY / ON STANDBY / ON VOLUME FUNCTION SOUND DIRECT OPERA TING AHB PRO REC REV .
– 4 – See pages in the parentheses for details. Front Panel 1 Remote sensor 2 (ST ANDBY/ON) button and ST ANDBY/ON lamp (9, 14, 19) 3 T APE 2 3 button (9, 15, 16) Pr essing this button also turns on the unit. 4 CD 3 / 8 (play/pause) b utton (9, 12, 17) Pr essing this button also turns on the unit.
– 5 – SLEEP ST ANDBY/ON MD/AUX FM/AM T APE CD DISPLA Y DIMMER REPEA T RANDOM PROG FM MODE AUTO PRESET SOUND MODE CD CANCEL MUL TI KEY SET RM-SUXP5U REMOTE CONTROL VOLUME AHB PRO 5 6 7 8 9 q 4 1 3 .
– 6 – Getting Started Supplied Accessories Make sure that y ou have all the follo wing items. The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) If anything is missing, consult your dealer immediately .
– 7 – RIGHT LEFT MAIN SPEAKERS SPEAKER IMPEDANCE MIN 6 1 Connect the AM loop antenna to the AM LOOP terminals as illustrated. • If the AM loop antenna wire is cov ered with vinyl, remo ve the vinyl by twisting it as shown in the dia gram. 2 T urn the AM loop antenna until you ha ve the best r eception.
– 8 – Speaker grille T o remove the speak er grille, inserting your fing ers at the top of the speaker grille, pull to wards y ou. Then pull the bottom to wards you. T o attach the speaker grille, put the projections of the speaker grille into the holes of the speak er .
– 9 – Common Operations T urning On the Power When you press the play b utton — CD 3 / 8 , T APE 2 3 , or the source selecting button — FM/AM, and MD/A UX, the unit automatically turns on and starts playback if the source is ready . T o turn on the unit, press (ST ANDBY/ON).
– 10 – Reinforcing the Bass Sound Y ou can reinfor ce the bass sound to maintain rich (“ AHB 1” and “ AHB 2”), full bass at low v olume. This function only affects the pla yback sound, but does not af fect your recording. T o get the effect, press AHB (Activ e Hyper Bass) PR O until “ AHB 1” or “ AHB 2” appears on the display .
– 11 – Listening to FM and AM Broadcasts T uning in a Station 1 Pr ess FM/AM. The unit automatically turns on and tunes in the previously tuned sta tion (either FM or AM). • Each time you press the button, the band alternates between FM and AM. 2 Pr ess and hold ¢ or 4 f or more than 1 second.
– 12 – Playing Back CDs (CD/CD-R/CD-RW) This unit has been designed to playback the follo wing CDs: •C D • CD-R • CD-R W Continued use of irregular shape CDs (heart-shape, octagonal, etc.) can damage the unit. General Notes In general, you will hav e the best performance by keeping your CDs and the mechanism clean.
– 13 – MULTI KEY T rack number Program step number PRGM PRGM SET Programming the Playing Order of the T racks — Program Play Y ou can arrange the order in which tracks play before y ou start playing. Y ou can program up to 20 tracks. On the r emote control ONL Y : 1 Load a CD .
– 14 – Prohibiting Disc Ejection — T ray Lock Y ou can lock the disc tr ay and prohibit to eject the CD. • This is possible only while the unit is turned on. On the unit ONL Y : T o prohibit disc ejection, press (ST ANDBY/ON) while holding 7 .
– 15 – Playing Back T apes Y ou can play back type I, type II, and type IV tapes without changing any settings. Playing Back a T ape 1 Pr ess 0 for cassette deck. 2 Put a cassette in with the exposed part of the tape down. 3 Close the cassette holder gently .
– 16 – Recording Recording on a T ape On the unit ONL Y : 1 Put a recordable cassette in with the e xposed part of the tape down. 2 Close the cassette holder gently . • If you want to record on both sides of a tape, see “T o record on both sides — Re verse Mode.
– 17 – CD Direct Recording Everything on the CD goes onto the tape in the order it is on the CD, or according to the order you ha ve made for Program play . On the unit ONL Y : 1 Put a r ecordable cassette in with the exposed part of the tape down.
– 18 – Using the T imers Continued There are three timers a vailable — Daily T imer, Recor ding T imer , and Sleep Timer . Before using the timers, you need to set the clock built in the unit (see page 9).
– 19 – 6 Pr ess TIMER to complete the timer setting . 7 Pr ess (ST ANDBY/ON) to turn off the unit (on standby) if y ou ha ve set the timer with the unit turned on. • When the timer turns on the unit, the timer ( ) indicator and the selected timer mode indicator (D AIL Y or REC) start flashing.
– 20 – If you are ha ving a problem with your unit, check this list for a possible solution before calling for service. If you cannot solve the problem from the hints gi ven here, or the unit has been ph ysically damaged, call a qualified person, such as your dealer , for service.
– 21 – Maintenance T o get the best perfor mance of the unit, keep your discs, tapes, and mechanism c lean. Handling cassette tapes • If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating.
– 22 – Specifications FS-P5 (CA-FSP5 and SP-UXP5) Amplifier Output Power 50 W per channel, min. RMS , driven into 6 Ω at 1 kHz with no more than 10 % total harmonic distortion. Audio input sensitivity/Impedance (a t 1 kHz) A UX: 400 mV/48 k Ω Audio output lev el A UX: 260 mV/5.
BT -51001-5 (0301) QUALITY SER VICE HOW TO LOCA TE YOUR JVC SER VICE CENTER Dear Customer , In order to receive the most satisfaction from your purchase,please read the instruction booklet before operating the unit.
THIS LIMITED W ARRANTY IS V ALID ONL Y IN THE FIFTY (50) UNITED ST A TES, THE DISTRICT OF COLUMBIA AND IN COMMONWEAL TH OF PUERTO RICO. WHA T WE WILL DO: If this product is found to be defective, JVC will repair or replace defective parts at no charge to the original owner .
VICT OR COMP ANY OF JAP AN, LIMITED EN 0401MWMMDWJEM FS-P5[J]_Cover 01.3.27, 2:39 PM 2.
An important point after buying a device JVC SP-UXP5 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought JVC SP-UXP5 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data JVC SP-UXP5 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, JVC SP-UXP5 you will learn all the available features of the product, as well as information on its operation. The information that you get JVC SP-UXP5 will certainly help you make a decision on the purchase.
If you already are a holder of JVC SP-UXP5, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime JVC SP-UXP5.
However, one of the most important roles played by the user manual is to help in solving problems with JVC SP-UXP5. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device JVC SP-UXP5 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
