Instruction/ maintenance manual of the product 22-44 Pro-3 Jet
Go to page of 4
JET 22-44 Pro-3 Drum Sander Our JET 22-44 Pro-3 Drum Sander quickly became a favorite of wood workers because of its durability, huge capacity, ease of use and exceptional surface smoothing capabilities.
Motors and Switching The JET 22-44 Pro-3 Drum Sander uses two independent motors, one turning the sanding drum and the other the conveyor belt. The larger motor for the drum produces 3 HP on 1 phase, 230V (only) power.
permanently lubricated ball bearings. The drum assembly is mounted in a truss-like carriage arm for superior strength and rigidity. This system also make s alig ning the drum to the tab le surface easy. That means consis tent perform ance with minimal adjusting by the operator.
Table Height A large, 7 ¾”-diameter cast-iron handwheel adjusts the table height within its 4” range. Each full turn of the handwheel changes table height by 3/32" for ultra precise sanding thickness contro l. The handwheel operates a screw and gear drive that controls both ends of the table to keep it level for maximum sanding accuracy.
An important point after buying a device Jet 22-44 Pro-3 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Jet 22-44 Pro-3 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Jet 22-44 Pro-3 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Jet 22-44 Pro-3 you will learn all the available features of the product, as well as information on its operation. The information that you get Jet 22-44 Pro-3 will certainly help you make a decision on the purchase.
If you already are a holder of Jet 22-44 Pro-3, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Jet 22-44 Pro-3.
However, one of the most important roles played by the user manual is to help in solving problems with Jet 22-44 Pro-3. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Jet 22-44 Pro-3 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
