Instruction/ maintenance manual of the product VR182 Jensen
Go to page of 16
VR182 Inst allation and Operation Manual MOBILE AUDIO SYSTEM.
VR182 2 SAFETY INFORMA TION When Driving Keep the volume level Iow enough to be aware of the road a nd traffic conditions. Protect from Water Do not expose the product to water , as this c an cause electrical shorts, fire or other damage.
VR182 3 DISC NOTES Depending on the recording status, conditions of the disc, and the equipment used for recording, some CD-Rs/CD-RWs may not play on this unit. For more reliable playback, please adhere to the following recommendations: • Use CD-RWs with speed 1x to 4x and write with speed 1x to 2x.
VR182 4 INSTALLATION Before You Begin 1. Disconnect Battery Before you begin, always disconnect the battery negative terminal. 2. Remove T ransport Screws and discard. Important Notes • Before final installation, test the wiring co nnections to make sure the unit is connected properly and the system works.
VR182 5 Ford Vehicle Mount 1. Remove the mounting sleeve (see step 1 of “DIN Fron t Mount” on page 4). The mounting sleeve is not used in this application. 2. Use the supplied mounting screw and the rear installation bracket to secure the unit in place.
VR182 6 WIRING Power Antenna Connect to power antenna or amplifier . If not used, tape bare end of wire. CD Changer Connector Antenna Connection 0.5A FUSE 15A FUSE (RED WIRE) (YELLOW WIRE) (YELLOW WIRE) Aux-In RCA Connections IR Remote Connector iPOD Connector Chassis Ground Connect to ground terminal or clean unpainted metal part of chassis.
VR182 7 BASIC OPERATION Power On/Off Press any button (except the eject button (23)) to turn the unit ON. Press the VOLUME/ON/ OFF button (1) to turn the unit OFF . Volume Control T o increase the volume, rotate the volume cont rol (1) clockwise. Th e maximum level is “46”.
VR182 8 System Menu 1. Press and hold the MENU/AUDIO button (3) for more than 3 seconds to enter the system menu. 2. Rotate the VOLUME control (1) to highlight the desired item. 3. Press the VOLUME button (1) to select the highlighted item. 4. Rotate the VOLUME control to select a value.
VR182 9 T UNER OPER ATION Select a Band Press the BAND button (16) on th e control panel to change between two FM bands and one AM band. In WB, CD, CDC, AUX IN or IPOD mode, press the BAND button to automatically switch to radio mode. Tuning Rotate the TUNE ADJUST knob (22) clockwise or counter- cl ockwise to tune up or down in one step increments.
VR182 10 CD/MP3/WMA OPERATION Inserting and Eje cting a Disc Insert a disc, label-side up, into the disc slot (24) with th e unit turned on. The unit will automatically draw the disc in and play the first track on the d isc. Press the eject button (23) to stop disc play and eject the disc.
VR182 11 SIRIUS RADIO OPERATION Switching to SIRIUS Mode Press the MODE button (4) to change th e mode to Sirius Satellite Radio mode. Activating Sirius Satellite Radio In Sirius mode, press and hold the S-MOD button (22) to select DIRECT mode. The LCD will display “DIRECT _ _ _” upon entry .
VR182 12 IPOD OPER ATION If AUTO IPOD “ON” is selected in the system menu, your iPod will play automatically when connected to the unit. “IPOD” will appear in the upper left corner of the display . If AUTO IPOD “OFF” is selected in the system menu, your iPod will not play automatically when connected.
VR182 13 CD CHANGER OPERATION After an optional CD changer has been instal led and properly connected, p ress the reset button (1 1) to initialize the in stallation. Refer to the owner ’s manual included with the CD changer for instructions on installin g , loading and using the CD magazine.
VR182 14 REMOTE CONTROLLER S Steering Wheel Remote (SOLD SEPARATELY) Installing the Steering Wheel Remote Use the mounting bracket to attach the remote control to the steering wheel: 1. Use the screwdriver to remove the two screws on the bottom of the mounting cabinet and remove the cabinet.
VR182 15 Credit Card Remote (SOLD SEPARATELY) • POWER : Powers on/off. • MOD : Cycles through al l available play modes (Radio, CDP , CDC, SA T , iPod, Aux) . • VOL : Adjusts volume lev el. • AUD (MENU) : Accesses Audio and System Menu. • ENT (S-MOD) : Enter key .
VR182 16 T R OUBLESHOOTING SPECIFICATIONS CD Signal to Noise Ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 60dB Channel Separation. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
An important point after buying a device Jensen VR182 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Jensen VR182 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Jensen VR182 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Jensen VR182 you will learn all the available features of the product, as well as information on its operation. The information that you get Jensen VR182 will certainly help you make a decision on the purchase.
If you already are a holder of Jensen VR182, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Jensen VR182.
However, one of the most important roles played by the user manual is to help in solving problems with Jensen VR182. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Jensen VR182 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
