Instruction/ maintenance manual of the product C-130 JBM electronic
Go to page of 19
Page -1- Copyright © 2007 JBM Electronics, Inc. C-130 Quick Start Guide.
Page -2- Copyright © 2007 JBM Electronics, Inc. Table of Contents Quick Start Guide ............................................................................................................. .. 3 Unpacking Instructions ........................
Page -3- Copyright © 2007 JBM Electronics, Inc. Quick Start Guide Unpacking Instructions 1. Unpack the C130. 2. Verify the following components are enclosed (Figure A) . 3. If any items are missing, please contact JBM at 1-800-489-7781 . Preparation 1.
Page -4- Copyright © 2007 JBM Electronics, Inc. 2. Using the instructions that accompanied the card, verify that the card is properly activated and functioning correc tly prior to installin g the car into the JBM Gateway: • Install the software that came with the air card on a laptop.
Page -5- Copyright © 2007 JBM Electronics, Inc. Note: This example shows cabling to a PC. The link LED is not lit for ETH1. Without a link LED lit either Method 1 mu st be used or the cabling must be checked.
Page -6- Copyright © 2007 JBM Electronics, Inc. NOTE: The screens and instructions displaye d are based on Windows XP. Your system may be different. If you have any problems contact your system adm in. • Scroll down to the bottom of the following items and select “Internet Protocol (TCP/IP)” (as shown to the left).
Page -7- Copyright © 2007 JBM Electronics, Inc. METHOD 2: PC to ETH1 • Select “Use the following IP address” and fill in the blank fields with the information below: • IP address: 192.168.1.2 • Subnet mask: 255.255.255.0 • Default gatewa:y 192.
Page -8- Copyright © 2007 JBM Electronics, Inc. • METHOD 1 should display an IP of 192.168.0.2 • METHOD 2 should display an IP of 192.168.1.2 Step 3: Access JBM Webserver • Open a web browser and enter the following in the address bar: METHOD 1: http://192.
Page -9- Copyright © 2007 JBM Electronics, Inc. Cellular Card Configuration Your JBM Gateway is able to detect m any cellular car ds, but others must still be configured manually.
Page -10- Copyright © 2007 JBM Electronics, Inc. Step 1: Cellular Carrier Selection • Select the cellular carrier you ar e using from the drop-down menu.
Page -11- Copyright © 2007 JBM Electronics, Inc. • Select the Aircard you are using:.
Page -12- Copyright © 2007 JBM Electronics, Inc. Step 2: Set the Userid, password and APN • If you are using a GPRS, Edge, or HSDP A based card, enter the userid, password, and APN that was provided by your cellu lar carrier. This information should have been packaged with your card.
Page -13- Copyright © 2007 JBM Electronics, Inc. Note: Depending on the provisioning of you r card, particularly in corporate applications in which the JBM Gateway is providing cellular backup connectivity to wired circuits, your card may be restrict ed from Internet access.
Page -14- Copyright © 2007 JBM Electronics, Inc. Verifying IP Connectivity First, let’s check to make sure that you car d is connecting to th e cellular network and obtaining an IP address. Navigate to the GAU screen shown below: If your screen looks similar to the one shown above, you are having signal reception difficulties.
Page -15- Copyright © 2007 JBM Electronics, Inc. Minimal Reception On occasion, you can find yourself in a situation where you have just enough signal to be able to communicate with the cellular tower, and obtain an IP addr ess, but not enough reception to be able to sustain a viable connection .
Page -16- Copyright © 2007 JBM Electronics, Inc. Re-verify your userid, password, and APN information. Be sure to pay close attention, as all three of these items are case specific and m ust be entered exactly in order to prop erly log into the cellular network.
Page -17- Copyright © 2007 JBM Electronics, Inc. HARDWARE STATUS LEDS Power: Yellow – Power Connection Status (P WR) ON Power is being received b y the C130 OFF Power is not being received by the C.
Page -18- Copyright © 2007 JBM Electronics, Inc. Software Licensing Terms and Conditions Software supplied with each JBM Electronics ' product remains the ex clusive property of JBM Electronics.
Page -19- Copyright © 2007 JBM Electronics, Inc. Warranty JBM Electronics provides a limited hardware warranty for the Gateway, which consists of the following: • This warranty is effective for one year fro m the delivery date of the Gateway to the purchaser.
An important point after buying a device JBM electronic C-130 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought JBM electronic C-130 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data JBM electronic C-130 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, JBM electronic C-130 you will learn all the available features of the product, as well as information on its operation. The information that you get JBM electronic C-130 will certainly help you make a decision on the purchase.
If you already are a holder of JBM electronic C-130, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime JBM electronic C-130.
However, one of the most important roles played by the user manual is to help in solving problems with JBM electronic C-130. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device JBM electronic C-130 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
