Instruction/ maintenance manual of the product PRO-9642CH JAMO
Go to page of 8
128-6623A 1 of 8 Page 1 Model PRO-9642CH Installation Manual Note : When both Passive Arming and V oltage Sensing are selected, you must hardwire the driver’s door pin switch in order to begin the passive arming sequence. RF Programmable Features : Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps Default 1st Door L/UL 1 Sec.
128-6623A 2 of 8 Page 2 or Eight Press and release the valet switch 2 chirps = horn chirp output 16mS Press transmitter Lock button to change 3 chirps = horn chirp output 30mS Press transmitter Lock b.
128-6623A 3 of 8 Page 3 The valet switch can be mounted to the lower side of the dash by drilling a ¼ " diameter hole in the selected location. Be sure to check behind the dash for adequate clearance for the body of the switch, and to confirm that the drill will not damage any existing components as it p asses through the dash.
128-6623A 4 of 8 Page 4 Black Wire: CHASSIS GROUND Connect this wire to a solid, metal part of the vehicle’s chassis. Do not confuse this wire with the thin black antenna wire that exits the control module independently .
128-6623A 5 of 8 Page 5 Dark Blue w/Black T race Wire: Alternate Channel 3 Output (Dbl. Push Required) This wire is controlled from the transmitter button programmed to the receiver's channel 3. By double pressing this the transmitter button, this output will become active for 1 second.
128-6623A 6 of 8 Page 6 3 Wire Ground Switched Single Step Door Locks In this application, the red wire provides a ground pulse during arming or the pulsed ground lock output. Connect the red wire to the wire that provides a low current ground signal from the factory door lock switch to the factory door lock control relay .
128-6623A 7 of 8 Page 7 door lock/unlock motor legs rest at ground, and switch +12 volts to the door lock/unlock motor legs for opera- tion, if this is the case in the vehicle you are working on, connect the remaining terminal, 87, to a fused + 12 volt source.
128-6623A 8 of 8 Page 8 © 2006 Audiovox Electronics Corp., Hauppauge, N.Y. 11788 128-6623A.
An important point after buying a device JAMO PRO-9642CH (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought JAMO PRO-9642CH yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data JAMO PRO-9642CH - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, JAMO PRO-9642CH you will learn all the available features of the product, as well as information on its operation. The information that you get JAMO PRO-9642CH will certainly help you make a decision on the purchase.
If you already are a holder of JAMO PRO-9642CH, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime JAMO PRO-9642CH.
However, one of the most important roles played by the user manual is to help in solving problems with JAMO PRO-9642CH. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device JAMO PRO-9642CH along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
