Instruction/ maintenance manual of the product Drive Motor & Gear Reducer Jackson
Go to page of 7
Drive Motor & Gear Reducer Replacement 07610-003-08-78 A July 5, 2005 Rack Conveyor Dishmachine Maintenance Instructions.
The drive motor and the gear reducer of your Jackson rack conveyor are responsible for moving racks of ware through the dishmachine. If needed to be replaced, these instructions will show you how to get your machine up and running in the shortest possible time.
4. Remove the bottom and set to the side so that it does not become a trip hazard. 5. With the cover removed you may now remove the bolts used to connect the drive motor to the gear reducer. Note: you need to support the motor as you remove the bolts; failure to do so could result in the motor falling to the ground and becoming damaged.
11. Once the wire nuts are removed, separate the wires. 12. With the flathead screwdriver and the hammer, loosen the con - duit nut. Once loosened, pull the conduit away from the motor. The motor may now be disposed of. 13. Remove the access cover off of the new motor.
22. Once the drive hub bolt & bearing are removed, loosen the set screw on the drive hub. There is no need to remove it. 23. Remove the gear drive by using the 9/16” socket and ratchet, as well as the combination wrench as required, to remove the nuts holding it to the mounting plate.
www.jacksonmsc.com Rack Conveyor Drive Motor and Gear Reducer Replacement Instructions Revision A (07/05/2005) 6 30. Once the motor is securely fastened to the gear reducer, care - fully lift the assembly up and mount it on the fasteners. Be sure to use proper lifting techniques to prevent injury.
www.jacksonmsc.com Rack Conveyor Drive Motor and Gear Reducer Replacement Instructions Revision A (07/05/2005) 7 Drive Motor Gear Reducer Drive Hub Bearing & Bolt Drive Assembly (with Adjust-A-Pea.
An important point after buying a device Jackson Drive Motor & Gear Reducer (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Jackson Drive Motor & Gear Reducer yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Jackson Drive Motor & Gear Reducer - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Jackson Drive Motor & Gear Reducer you will learn all the available features of the product, as well as information on its operation. The information that you get Jackson Drive Motor & Gear Reducer will certainly help you make a decision on the purchase.
If you already are a holder of Jackson Drive Motor & Gear Reducer, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Jackson Drive Motor & Gear Reducer.
However, one of the most important roles played by the user manual is to help in solving problems with Jackson Drive Motor & Gear Reducer. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Jackson Drive Motor & Gear Reducer along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
