Instruction/ maintenance manual of the product 1085144 Invacare
Go to page of 8
1 1. Secure the frame to the floor with the suction cups or by standing on the frame base during removal of the seat. 2. Press the UP button on the pendant to raise the seat all the way up (DET AIL "A"). 3. Grasp the handgrip on the battery pack and pull upwards to remove it from the motor shroud as shown in DET AIL "B".
2 FIGURE 2 - REMOVING THE FRAME FROM THE BA THTUB TIL T FRAME FORWARDS Frame Bathtub Suction Cup Loop Suction Cup Self-Locking Screws (STEP 2) Mounting Screw (STEP 2) Washer (STEP 2) Washers (STEP 2) .
3 Removing the Battery Connector (FIGURE 5 ) 1. Remove the two (2) mounting screws and nuts securing the battery connector to the motor shroud as shown in FIGURE 5.
4 Installing the Battery Connector (FIGURE 7) CAUTION The BLUE (-) and YELLOW (+) wires MUST be installed properly, otherwise, serious damage to the electrical system of the bath lift may occur. 1. Position the BLUE (-) wire through the FRONT hole and the YELLOW (+) wire through the REAR hole as shown in DET AIL "D" of FIGURE 7.
5 1. Connect the spade connector wires to the motor in the following manner: A . BLACK spade connector wire to lower spade. B . RED spade connector wire to upper spade. CAUTION DO NOT secure the pendant cable be- yond the middle of the cable (measur- ing from the current limit device to the pendant), otherwise damage to the cable may result.
6 Installing the Bath Lift into the Bathtub (FIGURE 9) W ARNING AL W A YS lower the bath lift frame to the lowest position BEFORE per forming this procedure. Otherwise, the bath lift frame may tip during installation and injury or damage may occur. The frame MUST be placed into an EMPTY bathtub.
7 Installing the Seat (FIGURE 10) WARNING T o prevent pinching injury between seat back and motor shroud when removing/ installing the seat, DO NOT grasp seat any- where other than at the recess at the top, the opening at the bottom of the seat or the lip at the top of the seat.
LIMITED WARRANTY PLEASE NOTE: THE W ARRANTY BELOW HAS BEEN DRAFTED TO COMPL Y WITH FEDERAL LA W APPLICABLE TO PRODUCTS MANUF ACTURED AFTER JUL Y 4, 1975.
An important point after buying a device Invacare 1085144 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Invacare 1085144 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Invacare 1085144 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Invacare 1085144 you will learn all the available features of the product, as well as information on its operation. The information that you get Invacare 1085144 will certainly help you make a decision on the purchase.
If you already are a holder of Invacare 1085144, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Invacare 1085144.
However, one of the most important roles played by the user manual is to help in solving problems with Invacare 1085144. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Invacare 1085144 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
