Instruction/ maintenance manual of the product TS200FR Husqvarna
Go to page of 18
O WNER’S MANU AL 169689 Re v . 2 4.11.03 TR Printed in U .S.A. 8 H.P . 30" (76,2 cm) SLEEVE HITCH TILLER A TT A CHMENT MODEL NUMBER TS200FR 02480 TS 20.
2 SAFETY R ULES Safe Operation Practices f or Tiller Attachments. TRAINING • Read the operating and service instruction manual care fully . Be thoroughly familiar with the controls and the proper use of the equipment. Know how to stop the unit and disengage the controls quickly .
3 GASOLINE CAP ACITY : 1 GALLON (3,6L) UNLEADED REG U LAR OIL : SAE30W (ABO VE 32°F/0°C) (CAP ACITY : 24 OZ. [0.7L]) 5W-30 (BELO W 32°F/0°C) TRANSMISSION OIL : SAE 30W (CAP ACITY : 40 OZ. [1,2L]) SP ARK PLUG : CHAMPION (GAP: .030" [0.76MM]) RJ19LM PRODUCT SPECIFICA TIONS CUST OMER RESPONSIBILITIES • Read and obser v e the saf ety rules.
4 ASSEMBL Y When R.H., (Right Hand) or L.H. (Left Hand) are used, it means from a position behind the steering wheel as If you were seated on the tractor seat and f acing f orw ard. NO TE: Remov e mo wer dec k from tractor bef ore mounting tiller attachment.
5 OPERA TION FIG. 3 IMPORT ANT : READ THE “R ULES FOR SAFE OP ER A TION” CAREFULL Y BEFORE OPERA TING Y OUR TILLER A TT ACHMENT . HO W T O USE Y OUR TILLER ST OPPING (See Fig. 3) TINES • Mov e tine clutch le v er to “DISENGA GED” position. ENGINE • Mov e engine throttle le v er to “ST OP” position.
6 OPERA TION NO TE: If at a high altitude (Abov e 3000 f eet) or in cold temperatures (below 32°F), the carb uretor fuel mixture ma y need to be adjusted f or best engine perf or mance. See “T O ADJUST CARBURET OR” in the Ser vice and Ad just ments section of this manual.
7 CUST OMER RESPONSIBILITIES GENERAL RECOMMEND A TIONS The warr anty on this attachment does not cov er items that hav e been subjected to operator ab use or negligence . T o receive full v alue from the w arranty , operator must main tain unit as instructed in this manual.
8 CUST OMER RESPONSIBILITIES T O CHANGE ENGINE OIL (See Figs. 6 and 7) Deter mine temperature r ange e xpected bef ore oil change. All oil must meet API service classifi cation SF or SG. • Be sure tiller engine is le vel. • Oil will drain more freely when warm.
9 CUST OMER RESPONSIBILITIES COOLING SYSTEM (See Fig. 9) Y our engine is air cooled. For proper engine perf ormance and long lif e keep y our engine clean. • Clean air screen frequently using a stiff bristled brush. • Remov e b lower housing and clean as necessary .
10 SER VICE AND ADJUSTMENTS CA UTION: Disconnect spark plug wires from spark plug and place wire where it cannot come into contact with plug. TILLER T O ADJUST GA UGE WHEELS See “T O ADJUST TILLING DEPTH” in Oper ation section of this manual. T O ADJUST BEL T (See Fig.
11 SER VICE AND ADJUSTMENTS IDLE RPM ADJUSTMENT - • With engine at idle speed, tur n the idle adjust screw slowly countercloc kwise until the engine begins to f alter . • Then raise the engine speed by turning the idle ad- just screw cloc kwise until the engine holds a smooth con stant speed.
12 Immediately prepare your tiller f or stor age at the end of the season or if the unit will not be used f or 30 da ys or more. CA UTION: Never store the tiller with gasoline in the tank inside a build ing where fumes may reac h an open fl ame or spark.
13 Will not star t 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly . 2. See “T O ST ART ENGINE” in Operation section. 3. Engine fl ooded. 3. W ait se veral min utes bef ore attempting to star t. 4. Dir ty air cleaner . 4. Replace air cleaner car tridge.
14 REP AIR P AR TS 8 HP TILLER A TT A CHMENT - - MODEL NUMBER TS200FR ENGINE AND TINES.
15 KEY P ART DESCRIPTION NO . NO . REP AIR P AR TS 8 HP TILLER A TT A CHMENT - - MODEL NUMBER TS200FR ENGINE AND TINES KEY P ART DESCRIPTION NO . NO . 1 124533X Control Throttle 2 6924J Brac k et, Thr.
16 REP AIR P AR TS 8 HP TILLER A TT A CHMENT - - MODEL NUMBER TS200FR TRANSMISSION AND GA UGE WHEELS.
17 REP AIR P AR TS 8 HP TILLER A TT A CHMENT - - MODEL NUMBER TS200FR TRANSMISSION AND GA UGE WHEELS 1 634A562 T ransmission 2 9135R Retainer Spr ing 3 4929H Dr illed P an Head Riv et 3/8 x 1-3/4 4 63.
02480.
An important point after buying a device Husqvarna TS200FR (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Husqvarna TS200FR yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Husqvarna TS200FR - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Husqvarna TS200FR you will learn all the available features of the product, as well as information on its operation. The information that you get Husqvarna TS200FR will certainly help you make a decision on the purchase.
If you already are a holder of Husqvarna TS200FR, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Husqvarna TS200FR.
However, one of the most important roles played by the user manual is to help in solving problems with Husqvarna TS200FR. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Husqvarna TS200FR along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
