Instruction/ maintenance manual of the product GX560 Husqvarna
Go to page of 11
GX560 5119617-01 GB Operator’ s Manual Read the operator’ s manual careful- ly and make sure that y ou under- stand the contents bef ore using the lawnmo wer .
1 Carton Contents Choke Control Lever Operator Presence Control Upper Handle Cable Tie Wrap Handle Knob W asher W asher Handle Knob Bolt Hook Assembly Lower Handle Spark Plug Lead Lower Handle Retaini.
2 Explanation of Symbols on the GX560 Warning Read the user instructions carefully to make sure you understand all the controls and what they do . Always k eep the lawnmower on the ground when mowing. Tilting or lifting the lawnmow er may cause stones to be thrown out Keep b ystanders away .
3 Fitting the Lower Handle to the Lawnmower 1. Feed the hook (A2) attached to the low er handle (A1) halfway through the centre slot of the guide (A3) , in the direction indicated by the arrow (A4) .
1. Fit the lower handle (E1) to the deck with the lower handle pin (E2) as illustrated in Fig E . 2. Attach the wheels (F1) to the wheel frame (F2) with the wheel retaining clips (F3) as illustrated in Fig F .
Starting and Stopping T o Start your Lawnmower 1. Move the handle to the parking position (C2) . 2. Connect the spark plug lead. (K) . 3. Open the fuel tap (L) . 4. Move the Chok e control lever to the ‘Choke’ position (M) when starting from cold, and to the ‘Run’ position (N) when starting from hot.
6 Adjusting the cutting height Adjusting the Cutting Height • Never use more than 2 cutting height spacers. • Spacers can only be fitted between the blade and the fan and never between blade and the bolt (R). 1. Ensure the Operator Presence Control is released, when the engine has stopped rotating - disconnect the spark plug lead.
Cleaning the Air Filter Nev er run the engine without a filter or with a dir ty filter . This will greatly reduce engine efficiency and lead to engine damage. Y our lawnmower is fitted with an Air Cleaner , the mainte- nance for which is as f ollows:- • Check the filter before each use.
Fault Finding Engine Will Not Start 1. Ensure that the Operator Presence Control is gripped firmly to the upper handle. 2. Check that there is sufficient fuel in the fuel tank and the fuel tap is open 3.
Electrolux Outdoor Products Aycliff e Industr ial Park NEWTON A YCLIFFE Co.Durham DL5 6UP ENGLAND T elephone - (00) 44 1325 300303 Fax - (00) 44 1325 310339 Our policy of continuous improvement means that the specification of products ma y be altered from time to time without prior no tice.
We hope you find the links below useful. For further ga rdening information visit www.GardenResources.c o.uk Blower Vacs Brush cutters Brushcutters Chainsaws Chain saws Cultivators Cylinder lawn mower.
An important point after buying a device Husqvarna GX560 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Husqvarna GX560 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Husqvarna GX560 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Husqvarna GX560 you will learn all the available features of the product, as well as information on its operation. The information that you get Husqvarna GX560 will certainly help you make a decision on the purchase.
If you already are a holder of Husqvarna GX560, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Husqvarna GX560.
However, one of the most important roles played by the user manual is to help in solving problems with Husqvarna GX560. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Husqvarna GX560 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
