Instruction/ maintenance manual of the product DWF-7589 Husqvarna
Go to page of 16
INSTRUCTION MANUAL ■ First applying the Air Bubble Washing System in the world. ■ Applying One-Touch Operation System. ■ Realizing calm washing through the innovational low-noise design. ■ Before operating this washer, please read this instruction completely.
2 • GROUND WIRE In case of 3-wire power cord, ground wire will not be provided • POWER CORD • HOSE DRAIN • LINT FILTER • COLD WATER TAP After using the washer, close the water tap • DETERGENT CASE • PULSATOR • POWER SWITCH • CONTROL PANEL • BLEACH INLET • HOT WATER TAP After using the washer, close the water tap.
3 Read all instructions before using your washer Save these instructions Your safety is important to us. To reduce the risk of fire, electrical shock, or injury when using your washer, follow basic precautions including the following: Understanding your responsibilities • Do not wash items that are soiled with vegetable or cooking oil.
4 Non-Pump Model Pump Model Location of washer Check location where washer will be installed. Make sure you have everything necessary for correct installation. Proper installation is your responsibility. • Do not place or store your washer below 0 ° C (32 ° F) to avoid any damage from freezing.
5 Recommended earthing method W ARNING Laundry tub drain system Standpipe drain system Pump Model Non-Pump Model 1 In case that it goes over a door sill. Don’t let the height of the drain hose exceed 20cm from the bottom of washe r . 2 In case of extending the drain hose.
6 Be careful not to confuse hot water inlet and cold water inlet. In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet valve. For Screw-Shaped Tap For Ordinary Tap INLET HOSE CONNECTION 1 Pull down the collar of the inlet hose to separate it from the water tap adapter.
7 Loading Sorting Preparing clothes for washing To obtain the best wahing results, you must operate your washer properly. This section gives you this important information. OPERATING YOUR WASHER • Close zippers, snaps, and hooks to avoid snagging other items.
8 THE FUNCTIONS OF THE CONTROL PANEL START HOLD POWER WATER LEVEL COURSE RES. PROCESS WASH TEMP. HIGH COLD MEDIUM LOW SMALL HOT WASH TEMP. DETERGENT FUZZY REMAIN RINSE SPRAY RINSE SPI N WASH RES. MIN. BLANKET ECONOMY SUIT SOAK CONTROL ONLY SPIN • Press this switch to turn the power on or off.
9 FULL AUTOMATIC COURSE 1. FUZZY COURSE (SENSOR); • This selection is for general washing except extraordinary clothes. • Artificial brain sensor selects properly the various kind of washing condition such as washing time, rinse times, spin time and water level.
10 WASH TIME CONTROL • As the control button is pressed, wash time will be repeated as following; 14 ➝ 18 ➝ 0 ➝ 6 ➝ 10min. • If you do n t want wash process, you must adjust wash time to 0 min.
11 GENERAL PROCEDURE FOR OPERATION 1. Add measured detergent to the washer, (Follow manufacturer’s directions for safe use) 2. OPTIONAL STEP If desired, add measured liquid chlorine bleach to the bleach inlet. use only liquid chlorine in the bleach inlet * Follow manufacturer’s direction for safe use.
12 To winterize washer To use washer again Exterior Interior CARING FOR YOUR WASHER Proper care of your washer can extend its life. This section explains how to care for your washer properly and safely. Cleaning your washer W inter storage or moving care Install and store your washer where it will not freeze.
13 HOW TO CLEAN THE FILTER Cleaning the Lint Filter Cleaning the drain filter • In case "Pump-Model" drain hose, this filter’s equipped at the back side of washer. • This drain filter is to screen the foreign stuffs such as threads, coins, pins, buttons etc .
14 Stained, heavily-soiled, or greasy items may need to be prewashed or soaked for best results. Soaking helps remove protein-type stains like blood, milk, or grass. Prewashing helps loosen soil before washing. Stain removal rules • Use warm water for soaking or prewashing stained laundry.
15 PROBLEM CHECK POINT • These cases are not malfunctions • The sound "wing" heard during water supply is the operating sound made by the water inlet valve. • The sound "sha" heard in stopping the tub is the sound that comes from the autobalancer of the tub.
SPECIFIC A TIONS NO . ITEM DWF-1089 DWF-9289 DWF-8089 DWF-7589 1 POWER SOURCE AV AILABLE IN ALL LOCAL AC VO L T AGE AND CYCLE 2 POWER CONSUMPTION 3 MACHINE NON-PUMP WEIGHT PUMP 4 DIMENSION (WXHXD) 628.
An important point after buying a device Husqvarna DWF-7589 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Husqvarna DWF-7589 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Husqvarna DWF-7589 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Husqvarna DWF-7589 you will learn all the available features of the product, as well as information on its operation. The information that you get Husqvarna DWF-7589 will certainly help you make a decision on the purchase.
If you already are a holder of Husqvarna DWF-7589, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Husqvarna DWF-7589.
However, one of the most important roles played by the user manual is to help in solving problems with Husqvarna DWF-7589. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Husqvarna DWF-7589 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
