Instruction/ maintenance manual of the product 7021RES Husqvarna
Go to page of 22
7021RES Owner’s Manual 532 40 38-15 01.23.06 BY Printed in U.S.A..
2 W ARNING: Battery posts, terminals and related ac ces so ries contain lead and lead compounds, chemicals known to the State of Cal i for nia to cause can cer and birth defects or oth er re pro duc tive harm.
3 SAFETY RULES ......................................................... 2-3 PRODUCT SPECIFICA TIONS ....................................... 3 CUSTOMER RESPONSIBILITIES................................. 3 ASSEMBL Y .....................................
4 ASSEMBL Y FIG. 2 HANDLE BRACKET HAN DLE PIN SQUEEZE FIG. 1 OPERA TOR PRESENCE CONTROL BAR HANDLE KNOB LIFT UP LIFT UP LOWER HANDLE MOWING PO SI TION UPPER HANDLE Read these instructions and this man u al in its entirety before you attempt to assemble or operate your new lawn mow er.
5 TO ASSEMBLE GRASS CA TCHER (See Fig. 3) 1. Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top. 2. Slip vinyl bindings over frame. NOTE : If vinyl bindings are too stiff, hold them in warm water for a few minutes.
6 KNOW YOUR LA WN MOWER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR LA WN MOWER. Compare the illustrations with your lawn mower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.
7 DRIVE CONTROL ADJUSTMENT Over time, the drive control system may become “loose”, resulting in decreased speed. There is a turnbuckle on the un der side of the drive control housing to increase tension on the drive cable. Pro ceed as follows: 1. T urn unit off and disconnect spark plug wire from spark plug.
8 SIDE DIS CHARG ING (See Fig. 10) • Mulcher plug must be installed into rear discharge open ing of mower. • Open mulcher door and install discharge defl ector un der door as shown. • Mower is now ready for discharging operation. • T o convert to mulching or bagging operation, dis charge defl ector must be removed and mulcher door closed.
9 OPERA TION BEFORE ST ARTING ENGINE ADD OIL (See Fig. 1 1) Y our lawnmower is shipped without oil in the engine. For type and grade of oil to use, see “EN GINE” in the Mainte- nance section of this manual. CAUTION: DO NOT overfi ll engine with oil, or it will smoke on startup.
10 ADD GASOLINE (See Fig. 1 1) • Fill fuel tank to bottom of tank fi ller neck. Do not over- fi ll. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mix oil with gasoline. Purchase fuel in quan ti ties that can be used within 30 days to assure fuel freshness.
11 ➁ ENGINE OIL ➀ HANDLE BRACK ET MOUNT ING PINS ➀ REAR DOOR HINGE ➀ MULCHER DOOR HINGE PIN LUBRICA TION CHART GENERAL RECOMMENDA TIONS The warranty on this lawn mower does not cover items that have been subjected to operator abuse or negligence.
12 LA WN MOWER Always observe safety rules when performing any main- te nance. TIRES • Keep tires free of gasoline, oil, or insect control chem- i cals which can harm rubber . • Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.
13 MAINTENANCE TO CLEAN AIR FIL TER 1. Loosen screws and re move cover. 2. Carefully remove cartridge. 3. Clean by gently tapping on a fl at surface. If very dirty , replace car tridge. CAUTION: Pe tro leum solvents, such as ker o sene, are not to be used to clean car tridge.
14 LA WN MOWER TO ADJUST CUTTING HEIGHT See “TO ADJUST CUTTING HEIGHT” in the Operation section of this manual. REAR DEFLECTOR The rear defl ector , attached between the rear wheels of your mower , is provided to minimize the possibility that objects will be thrown out of the rear of the mower into the operator's mowing position.
15 FIG. 18 HIGH MED. LOW HANDLE BRACKET HANDLE PIN SQUEEZE TO ADJUST HANDLE (See Fig. 18) The handle on your lawn mower has three (3) height posi- tions - adjust to height that suits you. • Squeeze the bottom ends of lower handle towards each other until the pin in handle can be inserted into one of the three height adjustment holes.
16 ST ORAGE HANDLE PIN SQUEEZE HANDLE BRACKET FIG. 20 ENGINE FUEL SYSTEM IMPORT ANT : IT IS IMPORT ANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM P ARTS SUCH AS CARBURETOR, FUEL FIL TER, FUEL HOSE, OR T ANK DURING STORAGE.
17 TROUBLESHOOTING POINTS Does not start 1. Dirty air fi lter . 1. Clean/replace air fi lter . 2. Out of fuel. 2. Fill fuel tank. 3. Stale fuel. 3. Empty fuel tank and refi ll tank with fresh, clean gas oline. 4. Water in fuel. 4. Empty fuel tank and r efi ll tank with fresh, clean gas oline.
18 ROT AR Y LA WN MOWER - - MODEL NUMBER 7021RES (96143001800) - PRODUCT NUMBER 961 43 00-18.
19 ROT AR Y LA WN MOWER - - MODEL NUMBER 7021RES (96143001800) - PRODUCT NUMBER 961 43 00-18 NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORT ANT : Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mo wer and void your warranty .
20 ROT AR Y LA WN MOWER - - MODEL NUMBER 7021RES (96143001800) - PRODUCT NUMBER 961 43 00-18.
21 ROT AR Y LA WN MOWER - - MODEL NUMBER 7021RES (96143001800) - PRODUCT NUMBER 961 43 00-18 NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORT ANT : Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mo wer and void your warranty .
22 S E C T I ON 1: L I MIT E D W A R R A N T Y Husqvarna Forest & Garden Compan y (“Husqvarna”) warrants Husqvarna product to the origin al pur- chaser to be free from defects in material and .
An important point after buying a device Husqvarna 7021RES (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Husqvarna 7021RES yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Husqvarna 7021RES - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Husqvarna 7021RES you will learn all the available features of the product, as well as information on its operation. The information that you get Husqvarna 7021RES will certainly help you make a decision on the purchase.
If you already are a holder of Husqvarna 7021RES, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Husqvarna 7021RES.
However, one of the most important roles played by the user manual is to help in solving problems with Husqvarna 7021RES. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Husqvarna 7021RES along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
