Instruction/ maintenance manual of the product BERWICK M968641 American Standard
Go to page of 6
7430.101 7431.101 BER WICK ™ / BOULEV ARD 6 4 COLLAR ON MOUNTING NUT 7 5 Figure B M968641 REV .1.2 Cer tified to comply with ANSI A112.18.1 Installation Instr uctions MONOBLOCK LA VA TORY FAUCET wi.
M968641 REV .1.2 Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain body. F ig. A. Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3). F ig. B. POP-UP DRAIN Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY.
M968641 REV .1.2 Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes. Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.
M968641 REV .1.2 1 4 10 TEST INST ALLED FITTING With HANDLE (1) in OFF position, turn on W A TER SUPPLIES (2) and check all connections for leaks. Remove AERA TOR (3) . Operate HANDLE (1) to flush water lines thoroughly . Replace AERA TOR (3) . 3 CHECK DRAIN CONNECTIONS Operate POP-UP KNOB (4) and fill lavator y with water .
M968641 REV .1.2 Speed Connect™ Drain Troubleshooting Guide Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A. Look at the area on the Drain Body where the Cable was attached and locate the component labeled as “Cam” and “Cam Cap” in the illustration.
M968641 REV .1.2 STOPPER INSTALLATION PROCEDURE Locked Mode: Look at the Plastic Loop at the bottom of the Stopper and notice that the Loop is on one side of the Stopper.
An important point after buying a device American Standard BERWICK M968641 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought American Standard BERWICK M968641 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data American Standard BERWICK M968641 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, American Standard BERWICK M968641 you will learn all the available features of the product, as well as information on its operation. The information that you get American Standard BERWICK M968641 will certainly help you make a decision on the purchase.
If you already are a holder of American Standard BERWICK M968641, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime American Standard BERWICK M968641.
However, one of the most important roles played by the user manual is to help in solving problems with American Standard BERWICK M968641. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device American Standard BERWICK M968641 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
