Instruction/ maintenance manual of the product LC 2000 HP (Hewlett-Packard)
Go to page of 7
HP NetServer LC 2000 with NetRAID-3Si (HP Rack Storage/12) Cluster Configuration Guide 14 November 2000 (see Versions at the end of this document) Introduction This document defines the supported HP NetServer LC 2000 configuration with HP Rack Storage/12s and Microsoft Cluster Server.
2 supply (UPS) using any power conditioner or UPS. Redundant power distribution units (PDU’s) are strongly recommended. System software: Navigator version L.
3 SCSI IDs 6, 7 Channels 0, 1, 2 RAID level 1, 5, 10, 50 Logical disks 1 per RAID array 8 maximum per NetRAID-3Si adapter Configuration options: Cluster mode on Cache write-policy to Write-thru Set any other options as desired Cabinet RAID arrays A RAID array (logical disk) must be composed of all the same disk model (i.
4 NIC: Model Embedded NIC Any that is on both the HP Tested Products List and the Microsoft Hardware Compatibility List. Driver Hptxnt.sys 3.27.00.0001 or later The vendor supported driver. NOTE If the NIC used is the same type as the embedded NIC (D5013A/B), then the Client LAN NIC must use the same driver as the Intra-cluster NIC.
NOTES: 1. 2. Another NetRAID-xSi Adapter may be installed in server for local storage.This diagram depicts using slot P5 for the shared storage NetRAID-3Si. 3. Cables between the servers and shared storage cabinets can be any HP LVD SCSI (offset) cable up to 10 meters.
6 Power Cabling to Separate Power Sources.
7 Versions 14 November 2000 Added 1000 MHz. Corrected mraid35x.sys to mraidnt.sys. 5 September 2000 Removed draft status 25 August 2000 Changed introduction, added 800, 933 MHz, new boot device definition boot order, driver info and Ultra3 HDDs. Rolled 3Si firmware/BIOS.
An important point after buying a device HP (Hewlett-Packard) LC 2000 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought HP (Hewlett-Packard) LC 2000 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data HP (Hewlett-Packard) LC 2000 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, HP (Hewlett-Packard) LC 2000 you will learn all the available features of the product, as well as information on its operation. The information that you get HP (Hewlett-Packard) LC 2000 will certainly help you make a decision on the purchase.
If you already are a holder of HP (Hewlett-Packard) LC 2000, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime HP (Hewlett-Packard) LC 2000.
However, one of the most important roles played by the user manual is to help in solving problems with HP (Hewlett-Packard) LC 2000. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device HP (Hewlett-Packard) LC 2000 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
