Instruction/ maintenance manual of the product HP21WR Hotpoint
Go to page of 24
Thank you for selecting Hotpoint air conditioners. Please read this manual carefully before operation and keep it for further reference. Room Air Conditioner OPERA TING INST R .
.
Please read this op erating manual care- fully before operat ing the unit . Thank you for choosing a Hotpoint air conditioner. Our design is based on the best efficiency and the lowest noise operation and it can keep the room comfortable. Please read this operating manual carefully before operating the unit and keep it for consultation.
1 Function Introduction W indow type room air conditioners of Hotpoint can regulate the room temperature and dry the room. It is convenient for your work,study and life. It can be widely used in residence, shop, hotel, office, library and laboratory, and so on.
2 2 Operating Condition Please operate air conditioner in the correct conditions as follow s . Power requirement (15Amp/15Amp Circuit) COOL mode operatio n DRY mode operation Outdoor temperature should be in range of 18 to 43 , otherwise it is possible for air conditioner to breakdown.
The distance of obstructions from window unit inside should be upper 300mm, lower 1500mm, left 500mm,right 500mm, front1500mm. 3 Installation Installation precaution: W indow type conditioner is so va.
Sunshade board Wall Wooden frame Rubber plate Support 4 Horizontal line Horizontal line Drain water: T o get the maximum cooling efficiency , the air conditioner is designed to splash the condensation water on the condenser coil.
5 Notes for i nstallation Remove Before removing air conditioner to an other place, you should contact the installer first. Then it must be done under the direction of a licenced technician. In addition, the charge of this must be paid. Noise Electric wiring Install in a location that is firm enough to avoid the enlargement of noise and vibration.
6 P A R T IDENTIFIC A TION Vertical airflow direction vane (Airfl o w di r ection adjustment up and down). The vertical airflow direction vane is controlled by positioning the vane to discharge the air upwards, downwards or straight out.
Main switch operation procedure 1.Main Control Knob Set to Low Cool,Med Cool or High Cool as desired(FAN setting operates the fan only.) CAUTION:If the main control knob is turned off of changed to a fan setting from a cooling operation setting.
ON/OFF button ON/OFF Remote control Signal transmitter AUTO COOL DRY FAN Middle fan ● Press this button, Auto, Cool,Dry, Fan, Heat mode can be selected circularly.
Name and function of wireless remote control Note: This wireless remote control is universal, and it could be used for many units, some buttons of this control which are not available to this unit will not be described below.
Note: This wireless remote control is universal, and it could be used for many units, some buttons of this control which are not available to this unit will not be described below.
Guide for operation- general operation or timer off. When AUTO RUN mode is selected, the setting temperature will not be displayed on the LCD, the unit will be in accordance with the room temp. automatically to select the suitable running method and to make ambient comfortable.
1. Press swing up and down button continuously more than 2s,the main unit will swing back and forth from up to down, and then loosen the button, the unit will stop swinging and present position of guide louver will be kept immediately.
If wireless remote controller is lost, open the surface panel and operate manually. Note: ＣＬＯＳＥ ＶＥＮＴ ＯＰＥＮ ＣＬＯＳＥ ＶＥＮＴ ＯＰＥＮ -"OPEN" position,the ventilation door opens to allow air,smoke or odors to be expelled from the room.
Operation T ips Operation for comfort and economy Do not overcool the room temperature . This is not good for health and wastes electricity. Keep blind or curtains closed . Do not let sunshine enter the room directly when the air con- dition is in operation.
1 5 Caution Do not use the air conditioner for other purposes except for cooling the room. Do not use the air conditioner for other purposes such as drying clothes, preserving foods, or cultivating vegetables. Do not block the air intake and outlet vents .
1 6 Care and maintenance Always turn o f f the air conditioner and main power supply before cleaning to ensure safet y . Cleaning unit 1. Cut power o f f before cleaning. 3. Don ’ t use gas, benzene, solvent,wash, chemical solvent, etc. for cleaning.
T rouble shooting guide Fault phenomenon Trouble-shooting Air conditioner dose not operate at all. * Is there a power failure? * Is the plug out? * I s power fuse or switch off ? * Whether the voltage.
*Operation starts or stops abnormally; *Power fuse or switch often breaks; *Carelessly splash water or something into air conditioner; *Electrical lines are much hot or lines cover breaks; *Other strange situations. Immediately stop all operations and plug out, please contact your dealer in the following situations.
NATIONAL SERVICE NUMBER – 1300 303 929 Hotpoint (Aust) Pty Ltd ABN 68 082 599 086 WARRANTY RECORD Please complete all details below should warranty service be required on your new Hotpoint air co nditioner. This form must be completed by the customer and the installer.
NATIONAL SERVICE NUMBER – 1300 303 929 Hotpoint (Aust) Pty Ltd ABN 68 082 599 086 PROBLEMS THAT MAY NOT BE COVERED UNDER WARRANTY Hotpoint (Aust) P ty Ltd reserves the righ t to ref use warranty if reported problem s arise from situations outside their cont rol.
Hotpoint (Aust) Pty Ltd W eb Site: www.hotpoint.com.au 66129905991.
An important point after buying a device Hotpoint HP21WR (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hotpoint HP21WR yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hotpoint HP21WR - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hotpoint HP21WR you will learn all the available features of the product, as well as information on its operation. The information that you get Hotpoint HP21WR will certainly help you make a decision on the purchase.
If you already are a holder of Hotpoint HP21WR, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hotpoint HP21WR.
However, one of the most important roles played by the user manual is to help in solving problems with Hotpoint HP21WR. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hotpoint HP21WR along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
