Instruction/ maintenance manual of the product hoover dishwasher Hoover
Go to page of 32
User instructions DDY 095TX DISHWASHER EN ®.
.
3 CONTENTS Safety advice Setting up, installation W ater softener unit Loading the salt Adjusting the upper basket Loading the dishes Loading the detergent T ypes of detergent Loading the rinse aid Cl.
4 SAFETY INSTRUCTIONS There are certain basic safety rules which are valid for any domestic appliance. Installation ■ Make sure that the plug fitted to the machine is compatible with the power supply socket.
5 INST ALLA TION (T echnical notes) ■ After unpacking, adjust the height of the dishwasher . For the dishwasher to work correctly it must be level. Adjust the feet so that the machine does not tilt by more than 2 degrees. ■ If it you need to move the machine after removing the packaging, do not try to lift it by the bottom of the door .
W ater connection IMPORT ANT The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused. ■ Th e inlet and drain hoses can be directed to left or right. IMPORT ANT The dishwasher can be connected to either cold or hot water , as long as it is no hotter than 60 °C.
7 Connecting the outlet hose ■ The outlet hose should disharge into a standpipe, making sure that there are no kinks (fig. 4) . ■ The standpipe must be at least 40 cm above floor level and it must have an internal diameter of at least 4 cm. ■ It is advisable to fit an anti-odour air trap (fig.
8 7 598 556/573 5 INST ALLA TION IN FITTED KITCHENS Fitting between existing cabinets ■ The height of the dishwasher , 85 cm, has been designed in order to allow the machine to be fitted between existing cabinets of the same height in modern fitted kitchens (fig.
9 * The softener unit is set in the factory at level 4 (d4) as this satisfies the requirements of the majority of users. Regulate the setting of your water softener unit according to the degree of hardness of your water as follows: IMPORT ANT The dishwasher must be AL W A YS off before start this procedure.
LOADING THE SAL T ■ On the bottom of the machine there is a container for the salt for regenerating the softener . ■ It is important to use only a salt that is specifically designed for dishwasher .
11 1 3 a b a b 2 ADJUSTMENT OF THE UPPER BASKET If 27 cm to 31 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below: 1. Pull out the upper basket; 2. Then grasp the basket from both sides and lift it upwards (fig.
12 A standard daily load is represented in figs. 1 and 2 . Upper basket (fig. 1) Upper basket (fig. 2) Using the lower basket ■ Saucepans, oven dishes, tureens, salad bowls, lids, serving dishes, dinner plates and soup plates can be loaded into the lower basket.
13 ■ The lower basket is fitted with a special adjustable central rack (fig. 3 and 4) . This permits stable and optimum loading, even when the size and/or shape of the dishes is non-standard. - POSITION “A” : for a standard load, or one that excludes pans, salad bowls and the like.
14 Using the third basket ■ The third basket has been designed to load items such as utensils of small dimensions or flat and long shaped items. By freeing the lower baskets from these objects, loading big-size items becomes more comfortable and easier , making it possible for instance to load plates and pots in the lower basket.
LOADING THE DETERGENT The detergent IMPORT ANT It is essential to use a detergent that is specifically designed for dishwashers either in powder , liquid or tablet form. Unsuitable detergents (like those for washing up by hand) do not contain the proper ingredients for use in a dishwasher , and stop the dishwasher from working correctly .
16 TYPES OF DETERGENT Detergent tablets Detergent tablets of different manufacturers dissolve at different speeds, for this reason, during short programmes, some detergent tablets may be not fully effective, because they are not completely dissolved.
LOADING THE RINSE AID The rinse aid The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. Filling the rinse aid container The rinse aid container can be found to the left of the detergent container (fig.
18 1 2 3 CLEANING THE FIL TERS The filter system (fig.A “4”) consists of: a central container that traps the larger particles; a flat gauze that continuously filters the wash water; a micro filter , located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse.
19 PRA TICAL HINTS How to get really good wash results ■ Before placing the dishes in the dishwasher , remove any remaining food (bones, shells, pieces of meat or vegetables, coffee grounds, skin of fruit, cigarette ash, tooth picks etc. to avoid blocking the filters, water outlet and washing arm nozzles.
20 WHEN CYCLE IS FINISHED After every wash it is essential to turn off water supply and to switch off the machine by pressing the On/Off button to the of f position. If the machine is not going to be used for some time, it is advisable to follow these rules: 1.
21 DESCRIPTION OF THE CONTROL P ANEL EN 50242 place load Capacity with pans and dishes W ater supply pressure Fuse Power input Supply voltage 15 9 persons Min.
22 PROGRAMME SELECTION AND SPECIAL FUNCTIONS (Use in conjunction with programme guide) IMPORT ANT The dishwasher has a ver y practical function: - the memory function which saves the last programme used, so that if you regularly use the same washing cycle, you do not have to re-set the programme every time, thereby saving time and effort.
23 Programme interruption Opening the door when a programme is running is not recommended especially during the main wash and final hot rinse phases. However , if the door is opened while a programme is running (for example, to add dishes) the machine stops automatically and the display will flash the remaining time before the end of the cycle.
24 "DELA Y ST ART" button Dishwasher start time can be set with this button, delaying start from 1 to 23 hours. Proceed as follows to set a delayed start: ■ Press the "DELA Y ST ART" button ( "00" will appear on the display).
25 AUTOMA TIC F AUL T SIGNALS T urn off the dishwasher , open the inlet hose and reset the cycle. Check if the drain tube is bent or if the siphon or filters are clogged. If the problem persists, contact Customer Service. Check if the drain tube is bent or if the siphon or filters are clogged.
26 PROGRAMME GUIDE W ash with prewash For wash programmes with prewash, it is advisable to add a second dose of detergent (max. 5.75 g) directly in the machine. Cycle with alternating action of water jets and steam. Effective in softening and removing dried up soil from heavily soiled loads.
27 140 • •• • 75°C • • •• • • • •• • • 130 85 75°C 65°C • •• • • •• • • •• • • •• • • •• • • •• • • •• • • .
THE W A TERBLOCK SYSTEM Fig. 1 A The waterblock system has been designed to improve the safety of your appliance, particularly when the machine is left unattended. The waterblock system actually prevents flooding which might be caused by a machine malfunction or as a result of a fracture on the pipes.
IDENTIFYING MINOR F AUL TS Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks: 29 F AUL T CAUSE REMEDY 1 - Machine completely dead 2 - Machine does .
30 N.B.: Should any of the situations occur and should the machine give a bad wash performance, it is necessary to remove the deposits from the dishes by hand since the final drying cycle hardens the deposits which a second wash in the machine would not be able to remove.
The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics.
1 1.10 - 4103461 1.A EN This appliance is marked according to the European directive 2002/96/EC on W aste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly .
An important point after buying a device Hoover hoover dishwasher (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hoover hoover dishwasher yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hoover hoover dishwasher - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hoover hoover dishwasher you will learn all the available features of the product, as well as information on its operation. The information that you get Hoover hoover dishwasher will certainly help you make a decision on the purchase.
If you already are a holder of Hoover hoover dishwasher, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hoover hoover dishwasher.
However, one of the most important roles played by the user manual is to help in solving problems with Hoover hoover dishwasher. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hoover hoover dishwasher along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
