Instruction/ maintenance manual of the product CO48PM Honeywell
Go to page of 22
Portable Evaporative Air Cooler for Outdoor, Indoor & Commercial Use OWNER’S MANUAL Read and save these instructions before use Model: CO48PM Power rating: 140 Watts Voltage rating: 120 Volt AC, 60Hz For product inquiries or support, visit www.honeywellaircoolers.
QUICK START GUIDE Fill with water and plug into a standard power outlet. Place near an open door or window. Note : Evaporative air cooler requires cross ventilation. Turn ON and enjoy the cooling breeze. Note: Start with LOW speed and gradually increase to higher speed for optimum cooling performance.
SECTION PAGE 1. THANK YOU ......................................................................................................... 2. USER TIPS ..........................................................................................................
2 THANK YOU Congratulations on your purchase of this versatile Honeywell Evaporative Air Cooler. For optimum cooling from your cooler, fill the water tank to maximum level and load ice inside the ice compartment before you turn on your air cooler. Cooler Location (Important - Please Read!) Place the cooler in front of an open door or window.
3 USER TIPS Energy Efficient, No Compressor Honeywell Evaporative Air Coolers are built to maximize energy efficiency and keep costs low. Warm air is drawn into the cooler and enters the Honeycomb Cooling Media. Water pumped from the tank pours over the honeycomb media.
4 USER TIPS Indoor Use The recommended maximum relative humidity level is 60% or less, which allows a noticeable temperature decrease. The temperature decrease will be greater in drier climates because higher evaporation occurs when the humidity is low.
5 SAFETY Read And Save These Instructions: When using electrical appliances, basic safety precautions should always be followed: OFF C OOL ON OFF ON 0 3 2 1 SPEED S WING MAX MIN 120V - 60 Hz Shock Hazard Water Level Indicator Your cooler runs on 120 Volt AC, 60 Hz current.
6 SAFETY DO NOT attempt to repair or adjust any electrical or mechanical functions of the cooler, as this may void the warranty. DO NOT cover the air inlet or outlet on the appliance as this may cause motor damage.
7 SAFETY Don't use indoor extension cords outside. Look for extension cords specifically marked for outdoor use. Look for extension cords that have a GFCI (Ground Fault Circuit Interrupter) built in. Make sure the amperage rating for the extension cord is higher than the amperage rating for the appliance.
8 PARTS DESCRIPTION OFF COOL ON OF F ON 0 3 2 1 SPEED SWING MAX MIN 10 1 Water Inlet and Ice Loading Compartment 2 Handle 3 Left Honeycomb Panel 4 Lever for Horizontal Louvers 5 Water Tank 6 Casters 7.
9 USE & OPERATION Control Panel COOL SPEED SWING OFF ON OFF ON 0 3 2 1 NOTE: Speed control may be marked as High / Med / Low in certain units..
Speed / On - Off Connect to the power supply and turn the Speed knob. The fan will start. Change the speed from 1 for Low to 2 for Medium to 3 High. To switch OFF the unit turn the Speed know to "0". Cool To begin cooling the desired area turn the "COOL" switch ON.
To refill the water tank, pull out the Water Fill Door located on the top of the unit (#16 on Page 8) and fill water to the Max, as indicated on the Water Level Indicator (#8 on Page 8).
• • • • • Securely connect the continuous water supply connector (located on the lower left side panel #11 on Page 8) to the water supply. Turn on the water. The water tank will refill automatically. The water float valve will detect the water level and will automatically start or stop the water flow.
• • • • The cooler is supplied with Honeycomb Cooling Media. The cleaning frequency for the Honeycomb media depends on local air and water conditions. In areas where the mineral content of water is high, mineral deposits may build up on the Honeycomb Cooling Media and restrict air flow.
• • • • • • • Turn the power “off” and disconnect the air cooler from the power supply. Move the unit to a location where it can be drained. Remove the drain plug and allow the tank to empty(#12 on Page 8). Refill the water tank up to the maximum level with clean water and drain it completely.
15 TROUBLESHOOTING GUIDE Customer Support: 1-800-474-2147 No discharge of air Cord is not plugged in. Power is not on. Not Cooling / Unit is making noise Pump is not turned ON. Refill water tank. Odors When the Cooler is new. If the Cooler has been used.
16 TECHNICAL SPECIFICATIONS MODEL NO. CO48PM 120 V 60 Hz 140 Watts 12.6 Gallon Honeycomb 24.40(L) X 14.76(W) X 34.17(H) 29.3 lbs Voltage Frequency Wattage Water Tank Capacity 1.
17 ELECTRICAL WIRING DIAGRAM.
1-YEAR LIMITED WARRANTY Read all the instructions before attempting to use this product. This 1 year limited warranty applies to repair or replacement product found to be defective in material or workmanship This warranty does not apply to any damage resulting from commercial, abusive, unreasonable use or supplemental damage.
19 SERVICE AND WARRANTY Please read the Instruction Manual carefully before setting up or using this product. If you believe this product to be suffering from a manufacturing fault, or if you have inquiries about this product, please contact our Customer Support: CUSTOMER SUPPORT JMA North America LLC Ramsey, New Jersey, 07446.
© 2012 AirTek International Corporation Limited The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representation or warranties with respect to this product. Manufactured by AirTek International Corporation Limited.
An important point after buying a device Honeywell CO48PM (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Honeywell CO48PM yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Honeywell CO48PM - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Honeywell CO48PM you will learn all the available features of the product, as well as information on its operation. The information that you get Honeywell CO48PM will certainly help you make a decision on the purchase.
If you already are a holder of Honeywell CO48PM, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Honeywell CO48PM.
However, one of the most important roles played by the user manual is to help in solving problems with Honeywell CO48PM. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Honeywell CO48PM along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
