Instruction/ maintenance manual of the product 08B21-SJC-102 Honda
Go to page of 17
© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 1 of 17 INST ALLA TION INSTRUCTIONS Accessory Application Publications No.
2 of 17 AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 2 EPT sealers 4 Cushion tapes 2 Socket bolts, 4 x 10 mm 3 W asher screws, 4 x 12 mm 2 W asher screws, 4 x 6 mm Re.
© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 3 of 17 3. Remove the fuel fill door release handle. Remove the left front door sill trim (three clip s and three retaining tabs). 4. Remove the left rear door sill trim (three clip s and four retaining t abs).
4 of 17 AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 9. Remove the rear seat belt anchor bolt and eight seat anchor bolts. • Seat belt anchor bolt torque: 30 to 35 N·m (22 to 25 lbs) 8. Remove the rear seat bracket covers; • Remove the left and right rear seat bracket covers (two clips for each cover).
© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 5 of 17 11. Remove the rear trim panel cover (eight clip s and two retaining t abs). 14 . Remove the left rear lower anchor bolt cover , and remove the left rear seat belt lower anchor bolt.
6 of 17 AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 17. Remove the rear bumper: • Remove the license plate (two bolts). • Remove two bolts, six self-t apping screws and six clips from the rear bumper . • Pull the rear bumper toward you.
© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 7 of 17 22 . Remove the left front anchor (two TORX bolts). 21. Remove the left C-pillar outer trim (slide rearward, and unplug the vehicle connector). Remove the clips from the body , and reinstall the clips to the lef t C-pillar outer trim.
8 of 17 AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 24 . Remove the left bed rail trim: • Remove the screw cover (four retaining t abs). • Remove the self-tapping screw . • Pull the left bed rail trim back to release the six clips, and remove the lef t bed rail trim.
© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 9 of 17 28 . Remove the tailgate trim: • Remove the four screws and release the one end clip on each side. • Sharply push the tailgate to the right to release the 16 clips from the trim.
10 of 17 AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 33 . Install one blind nut into each 8 mm hole. 34 . Remove the four screws from the rear camera. Route the rear camera harness through the rear camera subbracket, and install the rear camera subbracket to the rear camera with the four screws.
© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 11 of 17 36. Route the rear camera harness through the 10 mm hole in the tailgate, and seat the grommet into the 10 mm hole. 38 . Align the two locating tabs on the rear camera subbracket with the slots in the rear camera bracket, and install two 4 x 6 mm washer-screws.
12 of 17 AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 40. Route the rear camera harness along the tailgate as shown. 41 . Remove the TORX bolt from the tailgate hinge, and attach the harness clamp bracket B to the tailgate using the TORX bolt you just removed.
© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 13 of 17 42. Secure the rear camera harness to the harness clamp bracket B with three small wire ties.
14 of 17 AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 51. Route the rear camera harness out through the bed panel hole, and secure the rear camera harness to the vehicle harness with one wire tie just inside the panel hole.
© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 15 of 17 53. Remove the vehicle grommet from the left C-pillar . 54. Insert the rear camera harness through the grommet, and route the rear camera harness through the vehicle grommet opening.
16 of 17 AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved. 63 . Slide the driver’s seat back and forth to check that the rear camera subharness is not pulled too tight or is too loose. 62. Plug the rear camera subharness 6-pin connector into the Navi control unit.
© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 17 of 17 64 . Reconnect the negative cable to the battery . T urn the key to the ON (II) position, and enter the Navi code. 65 . Move the shift knob to the “R” position.
An important point after buying a device Honda 08B21-SJC-102 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Honda 08B21-SJC-102 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Honda 08B21-SJC-102 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Honda 08B21-SJC-102 you will learn all the available features of the product, as well as information on its operation. The information that you get Honda 08B21-SJC-102 will certainly help you make a decision on the purchase.
If you already are a holder of Honda 08B21-SJC-102, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Honda 08B21-SJC-102.
However, one of the most important roles played by the user manual is to help in solving problems with Honda 08B21-SJC-102. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Honda 08B21-SJC-102 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center