Instruction/ maintenance manual of the product CF-941 Henny Penny
Go to page of 6
Model CF-941 SECTION 3. OPERATION 3-1. INTRODUCTION This section provides operating procedures for the multipurpose holding cabinets. Read the Introduction, Installation and Operation Sections and all instructions should be foll owed before operating the cabinet.
Model CF-941 Figure 3-1 3-3. START-UP Before using the cabinet, it should be thoroughly cleaned as described in the cleaning procedures section of this manual. To put the cabinet into operation, move each POWER switch to the ON position and adjust each control to the appropriate temperature.
Model CF-941 3-5. CLEANING 1. Move the POWER switch to the OFF position. 2. Disconnect the electrical supply to the unit. To avoid burns, allow the unit to cool before cleaning by opening all the drawers fully for approximately 20 minutes. 3. Remove drawers by pulling straight out and tilting up.
Model CF-941 3-6. OPERATION AND Unit Operation PROGRAMMING Before operating the holding cabinet, read and understand this complete operation manual (supplied with each unit). The following steps are meant to be guidelines, not complete operating instructions.
Model CF-941 3-6. OPERATION AND Timer Settings PROGRAMMING (Continued) To change a timer setpoint, press and hold the desired timer button, then use the UP and DOWN buttons to change the time. Releasing the timer button enters the time into the controls.
Model CF-941 3-6. OPERATION AND 6. Press and release the SET button 4 times and “In-” PROGRAMMING shows in the display. In- means initialization. Press (Continued) and hold the UP or DOWN button at this time and allow the display to count down from 3.
An important point after buying a device Henny Penny CF-941 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Henny Penny CF-941 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Henny Penny CF-941 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Henny Penny CF-941 you will learn all the available features of the product, as well as information on its operation. The information that you get Henny Penny CF-941 will certainly help you make a decision on the purchase.
If you already are a holder of Henny Penny CF-941, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Henny Penny CF-941.
However, one of the most important roles played by the user manual is to help in solving problems with Henny Penny CF-941. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Henny Penny CF-941 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
