Instruction/ maintenance manual of the product BHD-301-G Heat Controller
Go to page of 17
Heat Controller , Inc. • 1900 Wellworth A ve. • Jackson, MI 49203 • (517)787-2100 • www .heatcontroller .com SER VICE MANU AL Portable Dehumidifer Series with R-410A: BHD-301-G BHD-501-G BHD-6.
BHD-G Service Manual Portable Dehumidier with R-410A Heat Controller , Inc. 1 T ABLE OF CONTENTS 1. PREF ACE ............................................................................................ 2 1.1 SAFETY PRECAUTIONS .....................
Heat Controller , Inc. Portable Dehumidier with R-410A BHD-G Service Manual 2 1. PREF ACE This SERVICE MANUAL provides various servicing information for the unit, including the mechanical and electrical parts, etc. This dehumidier was manufactured and assembled under a strict quality control system.
BHD-G Service Manual Portable Dehumidier with R-410A Heat Controller , Inc. 3 3. Humidity Set Control The humidity level can be set within a range of 35%RH (Relative Humidity) to 85%RH (Relative Humidity) in 5% increments. For drier air , press the button and set to a lower percent value(%).
Heat Controller , Inc. Portable Dehumidier with R-410A BHD-G Service Manual 4 2. Product Installation Instructions Install the portable dehumidier in a at and spacious location where the air outlets will not be obstructed. Do not install underneath desks or inside cupboards as this will restrict the air ow .
BHD-G Service Manual Portable Dehumidier with R-410A Heat Controller , Inc. 5 3.4 OPERA TION WITH CONTINUOUS DRAINAGE On the rear of the unit, remove the rubber plug carefully . Remove the water tank rst, then push the hose onto the connector located inside of the hole.
Heat Controller , Inc. Portable Dehumidier with R-410A BHD-G Service Manual 6 4.Electronic function 4.1 POWERING ON THE UNIT When the unit is just powered on or the dropped power is just restored, the unit will immediately perform the self- diagnosis.
BHD-G Service Manual Portable Dehumidier with R-410A Heat Controller , Inc. 7 5.Basic T est Procedures 5.1 DEFECTIVE COMPRESSOR Compressors are single phase, 1 15 volt. All compressor motors are permanent split capacitor type using only a running capacitor across the start and run terminal.
Heat Controller , Inc. Portable Dehumidier with R-410A BHD-G Service Manual 8 5.2 SEALED REFRIGERA TION SYSTEM REP AIRS EQUIPMENT REQUIRED 1. V oltmeter 2. Ammeter 3. Ohmmeter 4. E.P .A. Approved Refrigerant Recovery System. 5. V acuum Pump (capable of 200 microns or less vacuum.
BHD-G Service Manual Portable Dehumidier with R-410A Heat Controller , Inc. 9 1 1. Break vacuum by charging system from the high side with the correct amount of refrigerant specied.
Heat Controller , Inc. Portable Dehumidier with R-410A BHD-G Service Manual 10 CAP ACITOR - TEST 1. Remove capacitor from unit. 2. Check for visual damage such as bulges, cracks, or leaks. 3. For dual rated, apply an ohmmeter lead to common (C) terminal and the other probe to the compressor (HERM) terminal.
BHD-G Service Manual Portable Dehumidier with R-410A Heat Controller , Inc. 1 1 6. TROUBLESHOOTING GUIDE 6.1 TROUBLESHOOTING GUIDE In general, possible trouble is classied in three kinds.
Heat Controller , Inc. Portable Dehumidier with R-410A BHD-G Service Manual 12 6.3.3 Humidity sensor check 6.3.4 Fail to start or fail to start motor.
BHD-G Service Manual Portable Dehumidier with R-410A Heat Controller , Inc. 13 6.3.5 Abnormal noise 6.3.6 Complaint and remedy Complaint Cause Remedy No display or any button failure. T ransformer (Discharge transformer before testing) Check resistance between the two input/output lines on transformer .
Heat Controller , Inc. Portable Dehumidier with R-410A BHD-G Service Manual 14 Complaint Cause Remedy Fan motor noise Fan Replace the fan if cracked, out of balance, or partially missing. Blower Replace the blower if cracked, out of balance, or partially missing.
BHD-G Service Manual Portable Dehumidier with R-410A Heat Controller , Inc. 15 7. Wiring Diagram.
04/2009 05/2010.
An important point after buying a device Heat Controller BHD-301-G (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Heat Controller BHD-301-G yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Heat Controller BHD-301-G - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Heat Controller BHD-301-G you will learn all the available features of the product, as well as information on its operation. The information that you get Heat Controller BHD-301-G will certainly help you make a decision on the purchase.
If you already are a holder of Heat Controller BHD-301-G, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Heat Controller BHD-301-G.
However, one of the most important roles played by the user manual is to help in solving problems with Heat Controller BHD-301-G. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Heat Controller BHD-301-G along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
