Instruction/ maintenance manual of the product RCTS-MLT Hearth and Home Technologies
Go to page of 10
1 Printed in U.S.A. Copyright 2007 Hearth & Home T echnologies Inc. 20802 Kensington Boulevard, Lakeville, MN 55044 100-920B 8/07 RCTS-ML T Remote Control Kits -For use with SIT Millivolt V alves .
2 RECEIVER WIRING INSTRUCTIONS Incorrect wiring connections WILL cause damage to the gas valve or electronic module operating the gas appliance and may also damage the remote receiver .
3 Figure 4. Plunger insertion NOTE: All steps required for installation of the fl ame controller MUST be done by a quali fi ed gas service technician.
4 Figure 8. REMOTE RECEIVER JAM NUT REGULA TOR TOWER PLUNGER RED ORANGE BLUE Finalizing Remote Installation 1. Turn the main gas knob ON, relight pilot fl ame, and turn fi replace ON. 2. Inspect gas connections around solenoid and regulator tower with a comercially available, non-corrosive leak check solution.
5 REMOTE RECEIVER The remote receiver has a 3-position slide switch: OFF/ REMOTE/ON (see Figure 7). Figure 7. Remote Receiver TRANSMITTER Important: Before operating remote control, transmitter and receiver must have matching security codes. See section ‘Matching Security Codes’.
6 MA TCHING SECURITY CODES It may be necessary to program the remote receiver to the security code of the transmitter upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer . T o program the remote receiver: 1.
7 SETTING BUTTON Figure 9. Setting Button/Child Proof Lockout Setting ºF/ºC Scale The factory setting for temperature is degrees Fahrenheit (ºF) . T o change this setting to degrees Centigrade (ºC): 1.
8 Adjusting the Flame Height - Operates in ON or THERMO mode This remote control system allows the user to control the height of the FLAME when the gas valve is factory equipped with a FLAME CONTROLLER. 1. Press and release FLAME button to change fl ame height to HI (see Figure 8, Location #5), (a second fl ame icon appears).
9 7. Set the SET temperature to at least 2º F (1º C) below the room temperature and the system fl ame will extin- guish. Thereafter, it should continue to cycle on and off thermostatically approxim.
10 THERMOST A T WIRE ASSEMBL Y PIEZO WHITE RED VA LV E PILOT THERMOCOUPLE THERMOPILE Figure 10. Standing Pilot Ignition Wiring Diagram Figure 1 1. Standing Pilot Ignition Wiring Diagram with Piggyback Wire Figure 12.
An important point after buying a device Hearth and Home Technologies RCTS-MLT (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hearth and Home Technologies RCTS-MLT yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hearth and Home Technologies RCTS-MLT - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hearth and Home Technologies RCTS-MLT you will learn all the available features of the product, as well as information on its operation. The information that you get Hearth and Home Technologies RCTS-MLT will certainly help you make a decision on the purchase.
If you already are a holder of Hearth and Home Technologies RCTS-MLT, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hearth and Home Technologies RCTS-MLT.
However, one of the most important roles played by the user manual is to help in solving problems with Hearth and Home Technologies RCTS-MLT. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hearth and Home Technologies RCTS-MLT along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
