Instruction/ maintenance manual of the product HK 3390 Harman-Kardon
Go to page of 28
HK 3390 STEREO RECEIVER O W N ER’S M ANUAL HK1695 3390OM 6/13/08 12:11 PM Page 1.
2 SAFETY INFORMA TION Important Safety Instructions 1. Read these instructions . 2. Keep these instructions . 3. Heed all warnings . 4. Follow all instructions . 5. Do not use this apparatus near water . 6. The A / V receiver’s cabinet may be cleaned by gently wiping with a soft cotton or microfiber cloth.
3 Important Safety Information Verify Line Voltage Before Use Y our HK 3390 has been designed for use with 120-volt AC current. Connection to a line voltage other than that for which it is intended can create a safety and fire hazard and may damage the unit.
4 NOTES HK1695 3390OM 6/13/08 12:11 PM Page 4.
5 2 SAFETY INFORMA TION 6 INTRODUCTION 7 FRONT -P ANEL CONTROLS 9 REAR-P ANEL CONNECTIONS 11 REMOTE CONTROL FUNCTIONS 13 CONNECTIONS 13 Speaker Connections 13 Subwoofer 13 Connecting Source Devices to.
6 Thank you for choosing this Harman Kardon ® receiver! In the years since Harman Kardon ® engineers invented the high-fidelity receiver , we have taken to heart the philosophy of bringing the joy of home entertainment to as many people as possible , all the while improving performance and adding features .
7 FRONT -P ANEL CONTROLS Power Indicator: This LED has two modes . When power is turned off , the LED is amber to indicate that the receiver is plugged in and ready to be turned on.
8 T uning Pre s et S tation s 1 S peaker s 2 Pre s et S can FM Mode T uner Band Ba ss C ontrol Video 3 Audio/Video Input s Power Indicator Headphone Jack Power S witch Volume C ontrol C D S ource S el.
9 9 REAR-P ANEL CONNECTIONS AM and FM Antenna T erminals: Connect the included AM and FM antennas to their respective terminals for radio reception. Video 1, Video 2 and Video 3 Audio/Video Inputs: These jacks may be used to connect your video-capable source components (e .
10 Preamp Outputs Subwoofer T rigger Outputs Subwoofer Outputs Subwoofer Link Switches Main-Amp Inputs Speaker 1 Outputs Speaker 2 Outputs Switched AC Accessory Outlets Main Power Switch Phono CD Inpu.
11 11 REMOTE CONTROL FUNCTIONS The HK 3390 remote is capable of controlling six devices , including the HK 3390 itself . The remote is preprogrammed at the factor y to operate most Harman Kardon DVD , CD and CDR players . Each time you wish to use the codes for any component, first press its Selector Button.
12 IR T ran s mitter Len s Power On Power Off S peaker 1 S peaker 2 S ource S elector s Mute Memory Numeric Key s C lear Menu FM Mode Auto Pre s et Play Record Volume C ontrol s S leep T uning Dimmer .
13 CONNECTIONS There are different types of audio and video connections used to connect the receiver to the speakers and video display , and to connect the source devices to the receiver . T o make it easier to keep them all straight, the Consumer Electronics Association (CEA ® ) has established a color -coding standard.
14 CONNECTIONS satellite television box, or MP3 player . Although the tuner is built into the HK 3390, it also counts as a source , even though no external connections are needed, other than the FM and AM antennas . Separate connections are required for the audio and video portions of the signal.
15 15 SPEAKER PLACEMENT Before you begin to connect cables , it is important to set up your speakers in their correct locations in the room. See Figure 8. Optimally , the front left and right speakers are placed the same distance from each other as from the listening position, or about 60 degrees apart, and angled toward the listener .
16 Y ou are now ready to connect your various components to your receiver . Before beginning , make sure that all components , including the HK 3390, are turned completely off and their power cords are unplugged. Don’t plug in any of the power cords until you ha ve finished making all of your connections.
17 17 INST ALLA TION For each audio-only source , such as a CD player , connect the left and right analog audio outputs of the source device to the corresponding inputs on the HK 3390.
18 18 INST ALLA TION Connect the left and right analog audio outputs of the DVD player to the Video 2 Audio Inputs on the HK 3390. Then connect the composite video output of the DVD player , usually colored yellow , to the Video 2 Video Input. See Figure 16.
19 19 INST ALLA TION transmitted through the HK 3390 to the source device . This enables you to control your sources even when the HK 3390 itself is controlled via an external IR receiver .
20 20 Now that you have installed your system components , you are ready to begin enjoying your new audio system. T urning On the HK 3390 After you plug the power cord into an AC outlet and turn on the Main Power Switch on the rear panel, the Power Indicator should light up in amber .
21 OPERA TION and right speakers , unless the artist has mixed the recording in a way that pans sounds to one side or the other . If your speakers are not placed the same distance from the listening position, or if your room has other unusual characteristics , gently press the Balance Control knob until it unlatches and pops out.
22 OPERA TION Figure 34 – T uner Input Selection Radio stations may be selected in one of five ways (see Figure 35): 1. If you know the frequency number , enter it directly by first pressing the Direct Button on the remote , and then using the Numeric Keys .
23 OPERA TION VFD OFF: Display goes completely dark except for Power Indicator to remind you that the receiver is turned on NOTE: When the remote is in the device mode for either the Video 1 or Video 2 source , the Dimmer Button on the remote will only affect the source device (if compatible), and will not affect the HK 3390.
24 TROUBLESHOOTING GUIDE SYMPTOM CAUSE SOLUTION Unit does not function when Main • No AC power • Make certain AC power cord is plugged into Power Switch is pushed a live outlet • Check to see wh.
25 HK 3390 TECHNICAL SPECIFICA TIONS Audio Section Stereo Mode: Continuous Average Power (FTC): 80 Watts per channel, 20Hz – 20kHz, @ <0.07% THD , both channels driven into 8 ohms 100 Watts per channel, 20Hz – 20kHz @ <0.
26 APPENDIX T able A1 – Remote Control Device T ypes T able A2 – Subwoofer T rigger Output Operation Source Input Remote Control Device T ype Phono Operates HK 3390 only Video 1 Harman Kardon DMC .
Button Phono VID 1 VID 2 VID 3 / VID Front T a pe MON / CDR CD AM FM Controls DMC 1000 DVD Player DVD Player CD Recorder CD Player/Changer Controls Controls HK 3390 only Control Codes Control Codes Co.
250 Crossways Park Drive , Woodbury , New Y ork 11797 www .harmankardon.com © 2008 Harman International Industries , Incorporated. All rights reserved.
An important point after buying a device Harman-Kardon HK 3390 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Harman-Kardon HK 3390 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Harman-Kardon HK 3390 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Harman-Kardon HK 3390 you will learn all the available features of the product, as well as information on its operation. The information that you get Harman-Kardon HK 3390 will certainly help you make a decision on the purchase.
If you already are a holder of Harman-Kardon HK 3390, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Harman-Kardon HK 3390.
However, one of the most important roles played by the user manual is to help in solving problems with Harman-Kardon HK 3390. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Harman-Kardon HK 3390 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
