Instruction/ maintenance manual of the product 94847 Harbor Freight Tools
Go to page of 9
PNEUMA TIC PLANISHING HAMMER ASSEMBL Y AND OPERA TING INSTRUCTIONS 3491 Mission Oaks Blvd., Camarillo, CA 9301 1 Visit our W eb site at http://www .harborfreight.
Page 2 SKU 94847 For technical questions, please call 1-800-444-3353 REV 07j Specications Speed 875 - 1350 BPM Operating Air Pressure 50 to 100 (maximum) PSI; 4 SCFM Air Inlet 1/4”, 18 NPT , fema.
Page 3 SKU 94847 For technical questions, please call 1-800-444-3353 Do not overreach . Keep proper footing and balance at all times. Do not reach over or across running machines. Maintain tools with care . Keep tools sharp and clean for better and safer performance.
Page 4 SKU 94847 For technical questions, please call 1-800-444-3353 Unpacking When unpacking, check to make sure the following parts are included. Refer to the Parts List and Assembly Drawing located at the end of this manual.
Page 5 SKU 94847 For technical questions, please call 1-800-444-3353 Caution: Do not turn on the Air Compressor at this time. Oiler and Filter Connection Dirt, water , and the lack of pneumatic tool oil are major causes for tool wear . Install an optional oiler-lter (not supplied), as illustrated below for better performance.
Page 6 SKU 94847 For technical questions, please call 1-800-444-3353 Operation 1. T o change the height of the Anvil (5) to within 1-1/2 inches of the desired height, pull out Stopper Pin (9), and move the Adjustable Pole (7) up or down to one of two Stopper Pin holes.
Page 7 SKU 94847 For technical questions, please call 1-800-444-3353 Maintenance 1. After each use, wipe all components of the Planishing Hammer with a clean cloth to remove any dirt and grease buildup.
Page 8 SKU 94847 For technical questions, please call 1-800-444-3353 Assembly Drawing.
Page 9 SKU 94847 For technical questions, please call 1-800-444-3353 LIMITED 90 DA Y W ARRANTY Harbo r Freight T ools Co. makes ever y ef fort to assure that its produ cts meet high qualit y and durab.
An important point after buying a device Harbor Freight Tools 94847 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Harbor Freight Tools 94847 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Harbor Freight Tools 94847 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Harbor Freight Tools 94847 you will learn all the available features of the product, as well as information on its operation. The information that you get Harbor Freight Tools 94847 will certainly help you make a decision on the purchase.
If you already are a holder of Harbor Freight Tools 94847, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Harbor Freight Tools 94847.
However, one of the most important roles played by the user manual is to help in solving problems with Harbor Freight Tools 94847. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Harbor Freight Tools 94847 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
