Instruction/ maintenance manual of the product iDive 300 H2O Audio
Go to page of 14
.
Deep Dive W aterproof Case & Speakers Depth Rating 300ft/90m iDV1-75 20080819 F or updated manuals please visit our web site www.h2oaudio .com www .
Depth Rating 300ft / 90m Cam Knob Lock Cam Knob Mask Clip Speak er LED lights Lanyard Hole iP od ® Control Buttons Connector Cable Battery Cover Insert Holes & Height Adjuster Holes O-ring 1 2.
Quickstart: Instructions: I. Read “Getting F amiliar with the iDive 300” II. Unlock and open case III. Install batteries (3 AA) IV . Install iP od specifi c inserts and height adjusters (see page 10 for fi t chart) V. Install iP od VI. T urn on iP od VII.
Prior to use verify: 1. The O-ring is lightly lubricated and seated within the tr ack in the lid. 2. The O-ring and contact surface are free of scr atches and other imperfections . Do NO T use if: 1. The O-ring is dry , crack ed, twisted, and/or out of alignment.
T o Close Case 1. Close lid 2. Rotate the cam knob clockwise 180° 3. Close the cam knob lock IV . Install batteries 1. Open case . 2. Disconnect and remove iP od from case if installed. 3. T urn the battery cover screw counter -clockwise until the screw loses contact with the insert plate.
Included insert and height adjusters Inserts and height adjusters are labeled to aid identifi cation. As new iP ods become available please check our web site for updates on Inserts and height adjusters .
VI. Insert iP od 1. Ensure the correct inserts and height adjusters are installed for your iP od (PLEASE NO TE: If the correct insert and height adjusters are not used you may damage or destroy your iP od and the iDive300) 2. Place iP od in the inserts with the iP od dock connector facing toward the cam knob .
In case of a Steady Red LED 1. Ensure you are using a supported iP od model. 2. Ensure the iP od is fully charged. 3. Ensure the iP od is turned on. 4. Disconnect & reconnect the connector cable . In case of a Flashing Red LED 1. Batteries of the iDive300 case are running low – change or recharge them soon.
CA UTION: Do not store case in the following environments: * Solvents or other chemical fumes * High humidity * High Ozone * Extreme temperature fl uctuations Storing the case in these conditions may lead to a damaged case , causing it to leak. Rinse the EXTERIOR of the system in fresh water after EA CH use: 1.
Improper use of this system may cause the user to mak e mistak es or decisions that may lead to serious injury or death. Important warning and disclosure: Any individual intending to utilize this product during S .C .U .B.A diving activities must be properly tr ained and certifi ed by an accredited agency .
T o Obtain Service: Please go to support section of our website or contact customer support at Customer Support Hours and Contact Information: Monday through F riday 9AM to 5PM PT T el: 858.
Q: Why is the Red LED fl ashing? A: The iDive300 is designed to measure battery-life of the 3-AA batteries that are used to power the “Made for iP od” connection electronics and the power amplifi er . T he Red LED will start to fl ash when the batteries have approximately 25% charge remaining.
www .H2OAudio.com Copyright Notice: This owner’ s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied, photocopied, reproduced, translated, or formed into any electronic format without prior consent in writing. H2O Audio is a registered trademark of H2O Audio, Inc.
An important point after buying a device H2O Audio iDive 300 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought H2O Audio iDive 300 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data H2O Audio iDive 300 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, H2O Audio iDive 300 you will learn all the available features of the product, as well as information on its operation. The information that you get H2O Audio iDive 300 will certainly help you make a decision on the purchase.
If you already are a holder of H2O Audio iDive 300, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime H2O Audio iDive 300.
However, one of the most important roles played by the user manual is to help in solving problems with H2O Audio iDive 300. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device H2O Audio iDive 300 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
