Instruction/ maintenance manual of the product AMW B-Series Grindmaster
Go to page of 24
AMW B-SERIES OPERA TOR MANUAL INST ALLA TION ST ART UP PROCEDURE W A TER CONNECTION The National Sanitation Foundation requires the following for an NSF approved water hook-up: • A quick disconnect water connection or enough coiled tubing so that the machine can be moved for cleaning underneath.
F ACT OR Y SETTINGS (for each dispense head) • T ank temperature is set at 200 degrees F . • Brew time is pre-set at 2:20. (V olume/time to be set on-site) • Pulse Brew is set for 1 pulse, 20 sec on, 20 sec off. • W armer Energy Savings mode is set for 60-minutes.
B-SERIES Page 3 ADJUSTMENTS (cont.): Refer to B-Series Programming Chart on page 5. Pour-Over Mode Left display controls this. • The display will read “P-O” (pour-over). • Press “BREW” button to proceed to the next setting. • Press up or down arrow to change to “YES” or “NO”.
Page 4 B-SERIES LOW TEMP / NO BREW MODE: When set to “ON”, a brew cycle cannot be initiated until tank is hot and “READY” light is ON. When set to “OFF”, a brew cycle may be initiated at any time. POUR-OVER MODE: Note: Not available on B-6, B-DAP , and B-DGP (twin) models.
User Lockout User Lockout is achieved via the position of the LOCK jumper on the board header . Locate the header on the board (shown below) and place the jumper in the desired position. In the Locked position all menus in this document are locked out, and the unit will only allow brewing or grinding functions.
Page 6 B-SERIES Programming for B-Series.
B-SERIES Page 7 Models B-3, B-3WR, B-3WL, B-SAP & B-ID Parts List serial numbers A166225 and lower (without a -P suffix) A12124 Spray Head Deflector Kit A531-072 Heater Relay , 12VDC coil A554-109.
Models B-3, B-3WR, B-3WL, B-SAP & B-ID Parts List serial numbers A166226P and higher (with a -P suffix) Model B-3 Dual V oltage Unit Shown A12124 Spray Head Deflector Kit A71450 Heater Relay , 24V.
Models B-3, B-3WR, B-3WL, B-SAP & B-ID Part s List Dual V oltage Unit Shown A71562 Element, 240V/3500W A62305 Thermost at, Hi-Limit A71567 Thermistor A544-008 Grommet, Probe (3) A71684 24V Dump V .
Models B-6, B-DGP & B-DAP Part s List serial numbers A166225 and lower (without a -P suffix) A71822 Decal, T- p a d B-6 A71823 Decal, T -p ad, B-DAP , B-DGP A548-128 Deflector Spray Head (2) A61481 T ransformer (2) 40V A, 24VCT A71934 Controller Kit (2) A71619 Brew Basket Assy .
Models B-6, B-DGP & B-DAP Part s List serial numbers A166226P and higher (with a -P suffix) A71822 Decal, T- p a d B-6 A71823 Decal, T -p ad, B-DAP , B-DGP A548-128 Deflector Spray Head (2) A61481 T ransformer 40V A, 24VCT A530-059 Controller A71619 Brew Basket Assy .
Models B-6, B-DGP & B-DAP Part s List A62305 Thermost at Hi-Limit A71936 Element, 240V/6000W A71562 Element, 240V/3500W A71508 Heat Sensor Probe A61 108 Level Probe A71567 Thermistor (see NOTE 1 b.
TROUBLESHOOTING GUIDE Weak coffee Strong coffee Bitter coffee Grounds in coffee Brew basket overflowed Unpleasant taste Quantity of coffee dispensed each throw is not the same Circuit breaker trips co.
Wiring Diagram Models B-3, B-3WR, B-3WL, B-SAP & B-ID serial numbers A166225 and lower (without a -P suffix) Page 14 B-SERIES.
Wiring Diagram Models B-3, B-3WR, B-3WL, B-SAP & B-ID serial numbers A166225 and lower (without a -P suffix) B-SERIES Page 15.
Wiring Diagram Models B-6, B-DAP , B-DGP serial numbers A166225 and lower (without a -P suffix) Page 16 B-SERIES.
Wiring Diagram - E Models Models B-6, B-DAP , B-DGP serial numbers A166225 and lower (without a -P suffix) B-SERIES Page 17.
Wiring Diagram Models B-3, B-3WR, B-3WL, B-SAP & B-ID serial numbers A166226P and higher (with a -P suffix) Page 18 B-SERIES.
Wiring Diagram Models B-3, B-3WR, B-3WL, B-SAP & B-ID serial numbers A166226P and higher (with a -P suffix) B-SERIES Page 19.
Wiring Diagram Models B-6, B-DAP , & B-DGP serial numbers A166226P and higher (with a -P suffix) Page 20 B-SERIES.
Wiring Diagram - E Models Models B-6, B-DAP , & B-DGP serial numbers A166226P and higher (with a -P suffix) B-SERIES Page 21.
.
.
Grindmaster® Coffee Grinders and Br ewers • PrecisionBrew™ Br ewing Systems • Espressimo® Espresso Machines Crathco® Hot Beverage Dispensers • Crathco® Cold and Frozen Beverage Dispensers • AMW Cof fee and T ea Systems T el (502) 425-4776 • Fax (502) 425-4664 • 1-800-695-4500 (USA & Canada only) P .
An important point after buying a device Grindmaster AMW B-Series (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Grindmaster AMW B-Series yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Grindmaster AMW B-Series - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Grindmaster AMW B-Series you will learn all the available features of the product, as well as information on its operation. The information that you get Grindmaster AMW B-Series will certainly help you make a decision on the purchase.
If you already are a holder of Grindmaster AMW B-Series, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Grindmaster AMW B-Series.
However, one of the most important roles played by the user manual is to help in solving problems with Grindmaster AMW B-Series. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Grindmaster AMW B-Series along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
