Instruction/ maintenance manual of the product EXT-DVI-1CAT5-ELR Gefen
Go to page of 28
Audio Embedder 3GSDI EXT-DVI-1CAT5-ELR User Manual DVI ELR Extender over one CAT5 *Pr eferred Release A1.
ii 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this product near water . 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer ’s instructions.
iii Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notied within two (2) years from the da.
iv T echnical S upport (818) 772-9100 (800) 545-6900 8:00 AM to 5:00 PM Monday - Friday , Pacic T ime Fa x (818) 772-9120 Email support@gefen.com We b http://www .gefen.com Mailing Addr ess Gefen, LLC c/o Customer Service 20600 Nordhoff St. Chatsworth, CA 9131 1 Pr oduct R egistr ation Register your product here: http://www .
v v Operating Notes • Shielded T wisted-Pair (STP) CA T -5e or CA T -6 cabling is recommended. However , Un-shielded T wisted-Pair (UTP) CA T -5e or CA T -6 cabling is acceptable. Shielded cable is preferred as it provides immunity to Electromagnetic Interference (EMI), cell phones, and A/C motors.
vi Features and Packing List Features • Extends DVI up to 495 feet (150 meters) over one CA T -5e cable • Supports resolutions up to 1080p Full HD and 1920 x 1200 (WUXGA) • EDID management for r.
.
viii Table of Contents 1 Get ting St arted Introduction............................................................................................................ 2 Sender Unit .........................................................................
.
.
DVI ELR Extender over one CAT5 1 Ge t ting St ar t ed Introduction............................................................................................................ 2 Sender Unit ..............................................................
page | 2 Introduction Sender Unit 5V DC Link DVI In Power DVI ELR Extender over one CAT5 S Link EXT -DVI-1CAT5-ELRS Gefen 5V DC Link DVI In Power DVI ELR Extender over one CAT5 S Link EXT -DVI-1CAT5-E.
page | 3 Introduction ID Name Description 1 Link Connect a CA T -5 cable from this jack to the Link jack on the Receiver unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Link (LED) This green LED indicates the current state of the product.
page | 4 Introduction Getting S tart ed Getting S tart ed Receiver Unit 5V DC Link DVI Out Power DVI ELR Extender over one CAT5 R Link EXT -DVI-1CAT5-ELRR Gefen 5V DC Link DVI Out Power DVI ELR Extend.
page | 5 Introduction Getting S tart ed ID Name Description 1 Link Connect a CA T -5 cable from this jack to the Link jack on the Sender unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Link (LED) This green LED indicates the current state of the product.
page | 6 Installation Getting S tart ed Connection Instructions 1. Use the included DVI cable to connect the DVI source to the DVI In port on the Sender unit.
.
.
page | 9 DVI ELR Extender over one CAT5 2 Basic Oper ation LED Status .......................................................................................................... 10 DIP Switch Conguration .............................................
page | 10 Adv anced Oper ation LED Status Basic Oper ation The Power and Link LED indicators on the Sender and Receiver unit provide basic information on the current status of the DVI ELR Extender over one CA T5. The information, in the table below , applies to both the Sender and Receiver unit.
page | 1 1 DIP Switch Conguration Adv anced Oper ation There is a bank of four DIP switches on the bottom of the Sender and Receiver unit. Remove the piece of colored tape to reveal the DIP switch bank. These DIP switches provide control over EDID management, HPD pass-through, power modes, and range selection.
page | 12 Adv anced Oper ation DIP Switch Conguration Each of the following sections describe the DIP switch settings that control each feature. DIP switches that are not related to a specic feature have been grayed-out. Note that DIP switch settings can be used independently or in conjunction with other features, as desired.
page | 13 DIP Switch Conguration Basic Oper ation Power Mode Description Sender unit Receiver unit Power-Save (Green) mode. The Receiver unit is powered only when a video signal is present on the DVI (or HDMI) cable. Sleep Mode consumes less than 1 W att of power .
.
DVI ELR Extender over one CAT5 3 Appendix Specications .............................................................................................
page | 16 Appendix Specications Supported Formats Resolutions (max.) • 1920 x 1200 (WUXGA) • 1080p Full HD Connectors, Indicators, and Controls DVI In (Sender) • 1 x DVI-I, 29-pin, female (di.
.
20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefen.com support@gefen.com Stretch it. Switch it. Split it. Gefen’s got it. ® 20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.
An important point after buying a device Gefen EXT-DVI-1CAT5-ELR (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Gefen EXT-DVI-1CAT5-ELR yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Gefen EXT-DVI-1CAT5-ELR - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Gefen EXT-DVI-1CAT5-ELR you will learn all the available features of the product, as well as information on its operation. The information that you get Gefen EXT-DVI-1CAT5-ELR will certainly help you make a decision on the purchase.
If you already are a holder of Gefen EXT-DVI-1CAT5-ELR, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Gefen EXT-DVI-1CAT5-ELR.
However, one of the most important roles played by the user manual is to help in solving problems with Gefen EXT-DVI-1CAT5-ELR. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Gefen EXT-DVI-1CAT5-ELR along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
