Instruction/ maintenance manual of the product ASC-4G Alto-Shaam
Go to page of 30
W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA PHONE: 262.251.3800 • 800.558.8744 USA / CANADA FAX: 262.251.7067 • 800.
i Delivery .................................. 1 Unpacking ................................ 1 Safety Procedures and Precautions ............. 2 Installation Site Installation .......................... 3 Clearance Requirements .................. 3 Installation Requirements .
ASC-4G Gas Convection Oven - Electronic Control • 1 DELIVERY This Alto-Shaam appliance has been thoroughly tested and inspected to ensure only the highest quality unit is provided. Upon receipt, check for any possible shipping damage and report it at once to the delivering carrier.
ASC-4G Gas Convection Oven - Electronic Control • 2 CAUTION Used to indicate the presence of a hazard that can or will cause minor personal injury, property damage, or a potential unsafe practice if the warning included with this symbol is ignored.
ASC-4G Gas Convection Oven - Electronic Control • 3 INSTALLATION DANGER IMPROPER INSTALLATION, ALTERATION, ADJUSTMENT, SERVICE, OR MAINTENANCE COULD RESULT IN SEVERE INJURY, DEATH, OR CAUSE PROPERTY DAMAGE. READ THE INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING OR SERVICING THIS EQUIPMENT.
ASC-4G Gas Convection Oven - Electronic Control • 4 INSTALLATION INSTALLATION MINIMUM 6 INCH CLEARANCES FROM COMBUSTIBLES AND NON-COMBUSTIBLES Ne pas installer à une distance inférirure à celle indiquée ci-dessous d'une paroi en matiére combustible: Côtés 6 pouches, Arriére 6 pouches FOR USE ONL Y ON NON-COMBUSTIBLE FLOORS.
ASC-4G Gas Convection Oven - Electronic Control • 5 GAS SUPPLY & INSTALLATION GAS SUPPLY & INSTALLATION GAS PRESSURE CHART The gas valve and burner have been fitted according to the gas type specified on the identification name plate.
ASC-4G Gas Convection Oven - Electronic Control • 6 GAS SUPPLY & INSTALLATION GAS REQUIREMENTS The gas inlet is located at the back of the oven. Code requires the installation of a manual gas shutoff valve to be installed in the gas line ahead of the oven.
ASC-4G Gas Convection Oven - Electronic Control • 7 GAS SUPPLY & INSTALLATION GAS CONNECTION � FOR OVENS ON CASTERS The oven must be supplied with a flexible connector that complies with The Standard for Connectors for Movable Gas Appliances, ANSI Z21.
ASC-4G Gas Convection Oven - Electronic Control • 8 INSTALLATION This appliance is equipped with a three-prong grounding plug. For your protection against shock hazard this appliance should be plugged directly into a properly grounded three-prong receptacle.
ASC-4G Gas Convection Oven - Electronic Control • 9 INSTALLATION VENTILATION VENTILATION HOODS Proper venting along with a sufficient quantity of make-up air is essential for proper oven operation.
ASC-4G Gas Convection Oven - Electronic Control • 10 INSTALLATION CAUTION TO PREVENT PERSONAL INJURY, USE CAUTION WHEN MOVING OR LEVELING THIS APPLIANCE. STACKING KIT (5005783) STACKING INSTRUCTIONS A) Remove side panels. B) Knock out the mounting holes on top of the intended bottom oven.
ASC-4G Gas Convection Oven - Electronic Control • 11 INSTALLATION STACKING, GAS PLUMBING & FLUE INTERCONNECT (5003788) 7 8 1 2 3 4 5 6 Rev 04/09 ASSEMBLY INSTRUCTIONS FIRST: Assemble plumbing items 2 thru 6 as shown NEXT: Assemble items 7, 8, & 1 as shown ITEM DESCRIPTION PART NO.
ASC-4G Gas Convection Oven - Electronic Control • 12 INSTALLATION 8 1 1 7 3 4 2 9 1 2 34-5/16" (876mm) 5 6 2 38" (956mm) OVEN STAND ASSEMBLY ITEM DESCRIPTION PART NO.
OPERATING INSTRUCTIONS ASC-4G Gas Convection Oven - Electronic Control • 13 USER SAFETY INFORMATION The Platinum Series gas convection oven is intended for use in commercial establishments by qualified operating personnel where all operators are familiar with the purpose, limitations, and associated hazards of this appliance.
OPERATING INSTRUCTIONS ASC-4G Gas Convection Oven - Electronic Control • 14 START-UP OPERATION BEFORE INITIAL USE: Interior oven surfaces must be heated to remove surface oils and the accompanying odors produced during the first use of the oven. 1. Wipe all wire shelves, side racks and the full oven interior with a clean, damp cloth.
OPERATING INSTRUCTIONS ASC-4G Gas Convection Oven - Electronic Control • 15 1 3 5 6 9 M J O Q 4 7 8 P K R N L 1 PREHEAT INDICATOR B READY INDICATOR C LED DISPLAY D UP/DOWN ARROWS E CO.
OPERATING INSTRUCTIONS ASC-4G Gas Convection Oven - Electronic Control • 16 A. PRESS MAIN POWER R “ON.” • Thedisplay 3 will alternate between last Cook Set Temperature and actual Cavity Temperature.
OPERATING INSTRUCTIONS ASC-4G Gas Convection Oven - Electronic Control • 17 PROGRAMMING This Alto-Shaam electronic convection oven allows the operator to program up to seven cooking procedures. Each cooking program entered can be preset in any program function to cook by time (or probe, if a probe is included on the oven).
OPERATING INSTRUCTIONS ASC-4G Gas Convection Oven - Electronic Control • 18 Stop an Operation: Press Start/stop M Key. The oven will remain in a power-on state, and the operation will be cancelled.
ASC-4G Gas Convection Oven - Electronic Control • 19 CHEF OPERATING TIPS The Alto-Shaam convection oven will provide the best results and longest possible service with the utilization of the following suggestions and guidelines.
CARE AND CLEANING ASC-4G Gas Convection Oven - Electronic Control • 20 PROTECTING STAINLESS STEEL SURFACES It is important to guard against corrosion in the care of stainless steel surfaces. Harsh, corrosive, or inappropriate chemicals can completely destroy the protective surface layer of stainless steel.
CARE AND CLEANING ASC-4G Gas Convection Oven - Electronic Control • 21 CLEAN THE OVEN ON A DAILY BASIS 1. After the oven has cooled, remove all detachable items such as wire shelves, side racks, and drip pan. Clean these items separately. 2. Remove any food scraps from shelves, shelf supports, and blower fan wheel.
SERVICE ASC-4G Gas Convection Oven - Electronic Control • 22 Part numbers and drawings are subject to change without notice. Error Code Description Possible Cause E-10 Cavity air sensor shorted Cavity air sensor reading < 5°F. Verify sensor integrity.
SERVICE ASC-4G Gas Convection Oven - Electronic Control • 23 Part numbers and drawings are subject to change without notice. SERVICE 2 3 4 5 7 6 12 11 14 9 10 8 18 19 13 1 15 16 17 ITEM DESCRIPTION PART NO.
SERVICE ASC-4G Gas Convection Oven - Electronic Control • 24 Part numbers and drawings are subject to change without notice. INTERIOR OVEN COMPARTMENT ITEM DESCRIPTION PART NO.
SERVICE ASC-4G Gas Convection Oven - Electronic Control • 25 Part numbers and drawings are subject to change without notice. LEG ASSEMBLY (5003784) 1 2 3 4 6 5 7 ITEM DESCRIPTION PART NO.
SERVICE ASC-4G Gas Convection Oven - Electronic Control • 26 Part numbers and drawings are subject to change without notice. PARTS LIST P/N DESCRIPTION QTY EXTERIOR 1006623 PANEL, OUTER, SIDE/TOP ....................................... 1 1006671 PANEL, OUTER, RH .
ASC-4G Gas Convection Oven - Electronic Control • 27.
TRANSPORTATION DAMAGE and CLAIMS All Alto-Shaam equipment is sold F.O.B. shipping point, and when accepted by the carrier, such shipments become the property of the consignee. Should damage occur in shipment, it is a matter between the carrier and the consignee.
An important point after buying a device Alto-Shaam ASC-4G (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Alto-Shaam ASC-4G yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Alto-Shaam ASC-4G - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Alto-Shaam ASC-4G you will learn all the available features of the product, as well as information on its operation. The information that you get Alto-Shaam ASC-4G will certainly help you make a decision on the purchase.
If you already are a holder of Alto-Shaam ASC-4G, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Alto-Shaam ASC-4G.
However, one of the most important roles played by the user manual is to help in solving problems with Alto-Shaam ASC-4G. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Alto-Shaam ASC-4G along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center