Instruction/ maintenance manual of the product ASC-2E Alto-Shaam
Go to page of 30
W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA PHONE: 262.251.3800 • 800.558.8744 USA / CANADA FAX: 262.251.7067 • 800.
i Delivery .................................................................... 1 Unpacking ................................................................ 1 Safety Procedures and Precautions .......................... 2 Installation Site Installation .
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 1 DELIVERY This Alto-Shaam appliance has been thoroughly tested and inspected to ensure only the highest quality unit is provided. Upon receipt, check for any possible shipping damage and report it at once to the delivering carrier.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 2 CAUTION Used to indicate the presence of a hazard that can or will cause minor personal injury, property damage, or a potential unsafe practice if the warning included with this symbol is ignored.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 3 INSTALLATION SITE INSTALLATION The Alto-Shaam convection oven must be installed in a location that will permit the oven to function for its intended purpose and to allow adequate clearance for ventilation, proper cleaning, and maintenance.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 4 INSTALLATION 30-5/8" (778mm) 8" (203mm) CA VITY VENT ELECTRICAL INLET 3-5/32" (80,1mm) 9-15/16" (252mm) ELE.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 5 INSTALLATION The oven must be mounted on the factory equipped oven legs or on an optional oven stand. Installation on a solid or concrete base that in any way restricts air flow may void the warranty.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 6 INSTALLATION The oven must be installed by a qualified electrician. This appliance must be branch circuit protected with proper ampacities, in accordance with the wiring diagram located in this manual or in the electrical compartment of the oven.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 7 INSTALLATION (2-ASC-2E/STK SHOWN ) CAUTION TO PREVENT PERSONAL INJURY, USE CAUTION WHEN MOVING OR LEVELING THIS APPLIANCE.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 8 INSTALLATION (2-ASC-4E/STK 208/240V SHOWN ) After legs or casters have been installed on the bottom oven, place the upper oven on top of lower unit.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 9 INSTALLATION 8 1 1 7 3 4 2 9 1 2 34-5/16" (876mm) 5 6 2 38" (956mm) DESCRIPTION PART NO.
OPERATING INSTRUCTIONS ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 10 CAUTION METAL PARTS OF THIS EQUIPMENT BECOME EXTREMELY HOT WHEN IN OPERATION. TO AVOID BURNS, ALWAYS USE HAND PROTECTION WHEN OPERATING THIS APPLIANCE.
OPERATING INSTRUCTIONS ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 11 The oven includes 6 chrome plated wire shelves with two removable side racks and 12 shelf positions spaced at 1- 3/ 4" (43mm).
OPERATING INSTRUCTIONS ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 12 1 B LED DISPLAY C UP/DOWN ARROWS D COOK.
OPERATING INSTRUCTIONS ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 13 Q “ON.” • Thedisplay 2 will alternate between last Cook Set Temperature and actual Cavity Temperature.
OPERATING INSTRUCTIONS ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 14 This Alto-Shaam electronic convection oven allows the operator to program up to seven cooking procedures.
OPERATING INSTRUCTIONS ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 15 Stop an Operation: Press Start/stop L Key. The oven will remain in a power-on state, and the operation will be cancelled. Press Cook 8 to set procedure again.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 16 The Alto-Shaam convection oven will provide the best results and longest possible service with the utilization of the following suggestions and guidelines.
CARE AND CLEANING ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 17 PROTECTING STAINLESS STEEL SURFACES It is important to guard against corrosion in the care of stainless steel surfaces. Harsh, corrosive, or inappropriate chemicals can completely destroy the protective surface layer of stainless steel.
CARE AND CLEANING ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 18 1. After the oven has cooled, remove all detachable items such as wire shelves, side racks, and drip pan.
SERVICE ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 19 Error Code Description Possible Cause E-10 Cavity air sensor shorted Cavity air sensor reading < 5°F.
SERVICE ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 20 Part numbers and drawings are subject to change without notice. 2 3 6 7 9 8 11 13 14 16 15 10 1 5 4 12 17 DESCRIPTION PART NO.
SERVICE ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 21 Part numbers and drawings are subject to change without notice. 2 3 6 7 9 8 20 18 11 13 14 16 15 17 10 21 1 5 19 4 12 *Not Shown DESCRIPTION PART NO.
SERVICE ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 22 Part numbers and drawings are subject to change without notice. .
SERVICE ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 23 PARTS LIST Exterior Pane.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 24.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 25.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 26.
ASC-2E & ASC-4E Electric Convection Ovens - Electronic Control • 27.
TRANSPORTATION DAMAGE and CLAIMS All Alto-Shaam equipment is sold F.O.B. shipping point, and when accepted by the carrier, such shipments become the property of the consignee. Should damage occur in shipment, it is a matter between the carrier and the consignee.
An important point after buying a device Alto-Shaam ASC-2E (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Alto-Shaam ASC-2E yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Alto-Shaam ASC-2E - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Alto-Shaam ASC-2E you will learn all the available features of the product, as well as information on its operation. The information that you get Alto-Shaam ASC-2E will certainly help you make a decision on the purchase.
If you already are a holder of Alto-Shaam ASC-2E, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Alto-Shaam ASC-2E.
However, one of the most important roles played by the user manual is to help in solving problems with Alto-Shaam ASC-2E. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Alto-Shaam ASC-2E along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
