Instruction/ maintenance manual of the product AH 530-720 Gaggenau
Go to page of 18
1 AH 530-790 AH 530-720 Preface Safety notes Page 3 1. Important notes Page 4-5 1.1 F or your safety Page 4 1.2 Operating for the first time Page 5 1.3 About use Page 5 2. F eatures Page 6 3. Operation Page 7-9 4. Cleaning and care Page 10-1 1 5. Maintenance Page 12 6.
2 Preface With your new extractor hood, working in the kitchen will be even more fun. The appliance offers you a number of advantages: – A good extraction capacity with low noise values, – a large number of control functions, – optimum illumination of the cooking surface by a dimmable halogen light.
W ARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJUR Y TO PERSONS, OBSER VE THE FOLLOWING: a.) Use this unit only in the manner intended by the manufacturer .
1.1 F or your safety – Damaged appliances must not be operated. – The appliance must only be connected by an authorised specialist , paying attention to the relevant regulations of the power supply companies and the regional construction regulations.
1.2 Operating for the first time Before operating the appliance for the first time, please pay attention to the following notes: – The appliance must be installed and connected by a specialist before it is operated for the first time. – The rating plate for this appliance is included with the instructions on a separate sheet.
6 2. F eatures 1 Outgoing air duct 2 Control panel 3 Grease filter 4 Lighting Installation accessories: Stainless steel-design ventilation duct: LK 530-010 for ceiling heights of 7 ´´ 3 ´ ´ - 8 ´´ 6 ´ ´ / 2.20 - 2.66 m LK 530-020 for ceiling heights of 8 ´´ 6 ´ ´ - 10 ´´ 1 ´ ´ / 2.
7 3. Operation The AH 530-790 is 35 3 / 8 ´ ´ / 90 cm wide, and the AH 530-720 is 47 3 / 16 ´ ´ / 120 cm wide. Operation of both extractor hoods is identical. After they have been pressed, all functions selection keys except 0 (“Motor off”) are backlit in green.
8 The Int key for the intensive level should be pressed when browning and frying in an open pan (see Fig. 6). If you have switched on the hood by selecting the intensive level, it will be switched off again automatically after 5 minutes.
9 Special functions: Intensive time: Y ou can set the intensive level running time to 3, 5 or 10 minutes by simultaneously pressing the Int key and the 1, 2 or 3 key and you can store this setting (see Fig. 9). When delivered, the appliance is set to five minutes, i.
10 Cleaning the grease filters The grease filter saturation display F flashes after an operating time of 30 hours to indicate that you should clean the grease filter (see Fig. 3). The grease filter can of course be cleaned at any time, even if the grease filter saturation display should not start to flash.
11 Cleaning the extractor hood Clean the extractor hood and the aluminium- design ventilation ducts (LK 530-01 1/021) with a soft cloth and mild detergent solution only . Clean the stainless-steel design ventilation ducts (LK 530-010/020) with mild detergent solution and apply stainless steel care agent to the metal surface using a soft cloth.
The appliance must be disconnected from the power supply during all repair work. If the appliance does not function correctly , check the fuses first. If the power supply is functioning correctly , bu.
13 6.1 T echnical data AH 530-790: W eight: 23.5 kg Dimensions: 35 3 / 8 ´ ´ x 20 10 / 16 ´´ 898 x 550 mm AH 530-720: W eight: 27.5 kg Dimensions: 47 3 / 16 ´ ´ x 20 10 / 16 ´´ 1 198 x 550 mm Electrical connection Pay attention to the rating plate data.
6.2 Installation W ARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJUR Y TO PERSONS, OBSER VE THE FOLLOWING: a.) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
15 Flexible aluminium pipes, corrosion-protected sheet metal pipes and exhaust air pipes whose material conforms to fire B1 in accordance with DIN 4102 can be used.
16 Proceed as follows: – From the bottom edge of the hood, mark a center line on the wall. – With the aid of the drilling template, mark the positions of the screws on the wall (Fig. 19). – Pay attention to the minimum clearance of 24 ´ ´ / 600 mm for electric cookers and 27 1 / 2 ´ ´ / 700 mm for gas cookers.
– Secure the hood on the wall with the four screws b (Fig. 21). – Establish the pipe connection. – Establish the electrical connection. – Stainless steel chimney only (LK 530-010/020): Pull the protective film off the chimney’s trims. Note: A void damaging the sensitive metal surfaces.
Operating and assembly instructions AH 530-790 AH 530-720 Extractor hood.
An important point after buying a device Gaggenau AH 530-720 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Gaggenau AH 530-720 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Gaggenau AH 530-720 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Gaggenau AH 530-720 you will learn all the available features of the product, as well as information on its operation. The information that you get Gaggenau AH 530-720 will certainly help you make a decision on the purchase.
If you already are a holder of Gaggenau AH 530-720, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Gaggenau AH 530-720.
However, one of the most important roles played by the user manual is to help in solving problems with Gaggenau AH 530-720. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Gaggenau AH 530-720 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
