Instruction/ maintenance manual of the product 7191 061 Foster
Go to page of 20
Foster spa via M.S. Ottone, 18/20 42041 Brescello (RE) - Italy tel. +39.0522.687425 - tel. Servizio Assistenza +39.0522.684450 fax +39.0522.686019 - fax Servizio Ricambi +39.0522.962166 e-mail: service@fosterspa.com www .fosterspa.com USER'S MANUAL FOR BUILT-IN OVEN KS 60 gas, c od.
A A A A 1.
EN The s ymbol on the pr oduct or on its packag ing in dic ates th at this pro duct m ay not b e treat ed as hous eh old w aste. Instead it sh all be han ded over t o the ap plic abl e collect ion p oint f or th e recycli ng of electric al and el ectron ic equipmen t.
.
6* $ .
INSTALLATION ATTENTION: This appliance can be installed and operated only in rooms that are continuously ventilated according to UNI 7129/UNI 7131. IMPORTANT: The installation must be carried out by professionally qualified personnel following the manufacturer' s instructions.
Installation room For proper operation of the gas appliance, it is essential that the room has a natural air flow from openings on the external walls providing sufficient air for combustion of the gas. These openings must have a free air - flow cross - section of at least 100 cm² (it is possible to make one or more openings).
.
CONNECTION TO THE GAS SUPPLY The supply system must be compliant with the current local standards in the country of use. The type of gas for which the oven has been regulated is indicated on the serial number plate located on one of the side edges of the cavity (visible with the door open) and on the packaging.
Adaptation to the gas in use Other types of gas can be used by changing the burner s etting as follows: 1) Make sure that the oven is not connected to the electrical mains. 2) Open the oven door completely. 3) Extract the bottom of the oven after having removed the retaining screws 4) Take off the burner by unscrewing the screw.
Setting of the minimum The oven thermostat is equipped with a by-pass for the minimum; when changing the type of gas it is also necessary to adjust the setting in the following manner: Remove the thermostat knob; If the front panel is in glass, remove it by unscrewing the two locking ring nuts located under the ot her two knobs (fig.
BEFORE USING THE OVEN - PRECAUTIONS AND GENERAL S UGGESTIONS Unplug the appliances before performing any maintenance and/or cleaning. Any repairs or other work on the appliances must be carried out by qualified technicians only.
TURNING ON THE OVE N The oven is equipped with electric ignition. To turn on the oven, open the door completely. Press the thermostat knob slightly and turn it counter-clockwise to the maximum. Press the knob completely to trigger the electric ignition and keep the knob pre ssed for a few seconds.
Pilot light Th e light turns on when the selector knob is in any position different from 0. Selector knob It allows to choose between th e di ff ere nt cooking functions. Use of the selector and symbols : Oven light How to use the oven It allows to choose the preferred temperature of cooking.
.
INSTRUCTIONS FOR INSTALLING KNOB GUARD OPEN OVEN DOOR INSTALL KNOB GUARD IN SLOTS OF FRONT FASTEN KNOB GUARD ONTO FRONT BY MOVING IT TO THE RIGHT MAKE SURE THE KNOB GUARD IS ATTACHED BY PULLING IT OUTWARDS CLOSE OVEN DOOR ATTENTION: During operation the knob guard gets very hot.
Panettone or focaccia 175 2 55 - 65 Real focaccia 175 3 60 - 70 ‘Sublime’ cake 175 3 60 - 70 Pie crust 200 3 8-10 Pie crust with soft cheese 200 3 25 - 35 Pie crust with fruit 200 3 25 - 35 Pie cr.
CLEANING AND MAINTENANCE OF THE OVEN Important: Before performing any maintenance, you must either unplug the oven or disconnect the power supply via the omni - polar switch of the electrical system. Cleaning the oven: Let the oven cool after each use and clean it to keep bur nt on residues from being repeatedly heated.
How to remove the oven door To make it easier to clean the oven, it is possible to remove the door from the hinges as follows: The hinges A are equipped with 2 mobile U - bolts B. When the U - bolts B are lifted, the hinges are disconnected from their housing.
Cleaning the side racks The side r a cks has to be hooked onto the wall of the oven. Slide the racks and tray provided into the side r a il s . To remove the side racks press on part A as shown .
An important point after buying a device Foster 7191 061 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Foster 7191 061 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Foster 7191 061 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Foster 7191 061 you will learn all the available features of the product, as well as information on its operation. The information that you get Foster 7191 061 will certainly help you make a decision on the purchase.
If you already are a holder of Foster 7191 061, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Foster 7191 061.
However, one of the most important roles played by the user manual is to help in solving problems with Foster 7191 061. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Foster 7191 061 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
