Instruction/ maintenance manual of the product MW513 QuickSmart Fisher & Paykel
Go to page of 44
NZ A U P AC SG QuickSmar t™ and W ashSmar t™ Clothes washer Installation instructions and User guide.
Intelligence w ork ing for y ou Y our washer is born from 75 y ears of Fisher & P aykel laundr y innovation. Unlike conv entional machines, F isher & Pa ykel clothes washers, through SmartDrive™ technology adapt the wash action and water levels to sav e on water and electricity use; mak ing it kinder on your wallet and the environment .
1 Con tents Impor tant! SA VE THESE INSTRUCTIONS The models shown in this User Guide may not be available in all mark ets and are subject to change at any time. F or current details about model and specification av ailability in your country, please visit our website listed on the back cover or c ontact your local F isher & Paykel dealer .
2 Installation instructions Unpacking T o ensure the best performance from your new washer please follow the instructions below . Removing the packaging 1 Remove the outer packaging. 2 Tilt the machine backwards and walk it off the bottom packer one foot at a time .
3 Installation instructions Fig .3 Inlet hose ends Machine end T ap end Inlet hoses Note: new hose sets provided with the machine ar e to be used to connect the washer to the water mains . Old hose sets should not be re-used. 1 Connect the straight ends of the inlet hoses to the taps (thereare washers fitted in both ends).
4 W ater supply Y our cold wat er should not exceed 35°C and your hot water should not ex ceed 65°C. T emperatures above these may cause the machine t o fault or cause damage to the machine. If you have an uncon trolled water heating sourc e (eg a wet back or solar heating system) y ou should fit a Safe Valve (sold separa tely).
5 Getting star ted Thank you f or buying a Fisher & P aykel washing machine. W e are very proud of this washer and trust it will serve you well for man y years. At F isher & Pa ykel we aim to provide inno vative products that are simple t o use, ergonomic and energy efficient.
6 Using y our W ashSmar t™ washer B. F abric softener If you wish to use fabric softener , place it in the dispenser on the top of the agitator (r efer to page 21). Impor tant! F abric softener must not be used if you have selected the ECO or QUICK W ASH option (refer to page 14).
7 Using y our W ashSmar t™ washer If you wish to stop y our W ashSmar t™ washer Press ST ART/P A USE. If it is during spray rinse or spin there is a slight delay while the bowl slo ws to a stop and the lid is unlocked. Impor tant! For best f abric and colour care remov e your clothes as soon as the cycle has finished.
8 Using y our QuickSmar t™ washer Place the load evenly ar ound the agitator (ref er to ‘S orting’ and ‘Loading’ , page 19). Remove fabric softener dispenser . A. Detergent F ollow the instructions on the detergent package.
9 Using y our QuickSmar t™ washer C. POWER Press POWER t o turn the machine on. D . W ash cycles Select the c ycle you want b y pressing the W ASH CYCLES button loca ted below the REGULAR cycle indicator . Scroll through the cycles until the light for the one you w ant is lit.
10 Lid lock Y our washer has a lid lock, which locks when your machine is spinning. This ensures the lid cannot be opened during hazardous parts of the c ycle, pro viding added safety for you and y our family . The LID L OCKED light (above the ST ART/P AUSE button) comes on when the lid is locked to tell y ou when you cannot open the lid.
11 W ash c ycles and options Default settings W ashSmar t™ model REGULAR HEA VY DUTY HAND W ASH ALLERGY EASY IRON W ash time 12 min 15 min 6 min 12 min 9 min W ash action REGULAR HEA VY DUT Y HAND W.
12 T o selec t the wash options W ashSmar t™ model 1 Select the wash c ycle, temper ature, wat er level and spin speed (ref er to page 7). 2 Press the OPTIONS butt on if you want to choose ECO , SOAK or QUICK W ASH (refer to pages 14 and 15). 3 Press ST ART/P A USE.
13 W ater lev els Fig .21 W ater level guide on agitator Manual water lev el selection The agitator has fiv e levels marked on its stem that can be used to help you select the correct water level for y our load. Select the correct water level by using the lowest visible mark on the agitat or .
14 W ash options – saving wa ter and time Eco W ashSmar t™ and QuickSmar t™ models Use the ECO option t o save water . The ECO option uses an Eco Spray rinse which has been specially designed t o use at least 25% less water than a traditional rinse .
15 W ash options Soak W ashSmar t™ model only Use the SOAK option to soak clothes a t the end of the wash phase or when you wish to re-use the wash water . When you select SOAK your w asher will soak for a period of 2hours before completing RINSE and SPIN.
16 W ash options W ashing bulk y items F orcing large items into the machine ma y result in them being damaged during washing. Make sure there is enough room in the machine f or items to move when being washed . Some items float up during the wash (eg duvets/ doonas and pillows).
17 F av ourite c ycle F A VOURITE c ycle W ashSmar t™ model only The F A VOURITE cycle lets you programme your ideal w ash c ycle. It can be any wash cycle with any of its wash options and it can start from any point in the cycle. F or instance, it may be a cycle to wash your gym gear or it may be a rinse and spin to finish washing the nappies .
18 Cust omising the wash cycles T o customise a c ycle W ashSmar t™ model only Y ou can progr am your washer to remember the wash options y ou prefer f or each wash cycle. F or instance, y ou may want to set the REGULAR cycle to a C OLD wash or set HEA VY DUT Y to include a SOAK.
19 Before y ou wash Sor ting T o get the best wash results it pay s to sort your clothes befor e washing. Care labels The care label will tell y ou about the fabric of the garment and how it should be washed. Soil Sor t clothes according t o the type and amount of soil.
20 Detergen t Choosing the right detergen t W e recommend using domestic detergen t. Y ou can use powder or liquid . Soap flakes should not be used in your washer . When washing wool items , remember to use a detergen t specifically recommended for w oollens.
21 F abric softener How the fabric softener is dispensed The fabric softener is placed into the dispenser on the top of the agita tor . During the rinse the machine spins to release the fabric softener , delivering it down the agitator st em as the machine fills for the final deep rinse.
22 Changing pre-set options Option adjustment mode After using your washer a number of times you ma y want to fine tune some of the options to suit your wash needs. There are a number of pr e -set options, which can be alter ed. In the WashSmart™ model the following pr e -set options can be changed: The wash temperatur es.
23 Changing pre-set options 1 Enter the option adjustment mode (ref er to page 22). 2 The diagram below sho ws how the lights relat e to the options you can change. It also shows what lights will be on when you first ent er the option adjustment mode.
24 Changing pre-set options W ash temperatures On the QuickSmar t™ model the W ARM temperature can be adjusted if y ou think it is too hot or too cold. On the W ashSmar t™ model all wash temperatur es can be individually adjusted. Note: the hot and cold temperatur es will be the same as the respective water supply temper atures.
25 Changing pre-set options Contr olled cold W ashSmar t™ model only If your cold water temper ature is very low you will not get a very effective wash. The CONTROLLED C OLD option solves this problem by adding a small amount of hot water to r aise the temperature of the w ash to approximat ely 20°C.
26 Changing pre-set options Out of balance reco very routine When your washer is spinning it can sense if the wash load is out of balanc e. If an out of balance load is detected, the machine will stop and re-tr y spinning up to three times . If it still senses an unbalanced load there are two options the machine can take .
27 Machine information Caring for y our washer When you ha ve finished T urn off the taps to prevent the chance of flooding should a hose burst.
28 Machine information Additional inf ormation Products that might damage y our washer Concentra ted bleaches, nappy sanitisers and h ydrocarbon solvents (eg petr ol and paint thinners) can cause damage to the paintwork and components of your w asher .
29 Saving wat er W ater saving tips F ull loads are more efficient than part loads. Use the ECO option (r efer to page 14). Adjust the RINSE option on REGULAR and HEA VY DUT Y cycles ( W ashSmar t™ model), and REGULAR, HEA VY DUT Y and WOOL cycles ( QuickSmart™ model) to one deep rinse (refer to page24).
30 Saving wat er Manual suds save with syphon back If you have a large tub near y our washing machine and a separate drain outlet, y ou can set up another method of reusing the water . The tub should hold a minimum of 100 litres or hav e an overflow .
31 If your washer beeps f or help Y our washer is capable of diagnosing its own pr oblems. If your washer giv es a musical series of beeps every 5 seconds it is telling you that it has a problem which you can solve using the checklist below . Musical series of beeps* every 5 seconds and.
32 If your washer beeps f or help LID L OCKED light is flashing. Make sure the lid is closed. Press ST ART/P A USE (refer to page 10). If the symptom persists call your F isher & Paykel Dealer or A uthorised Repairer . First RINSE or SPIN pr ogress light is flashing as well as the SPIN SPEED ligh t.
33 Operating pr oblems Pressing POWER does not turn the machine on. Is the power switched on at the w all? Switch the pow er off at the wall and wait 60 seconds befor e turning the power on again. Could your household po wer supply be at fault? Try plugging in another electrical appliance.
34 W ash problems Listed below are possible causes and solutions t o some common wash problems. Creasing . Overloading the washer . Choose an EASY IRON or HAND W ASH c ycle ( W ashSmar t™ model), or a DELICA TE c ycle ( QuickSmar t™ model) as these c ycles hav e been designed to minimise creasing .
35 W ash problems Dye transfer . W ash and dr y non-colour fast clothes separately . Non-colour fast clothes left sitting in a washer or laundr y basket can transfer dye to other clothes . T angling. W ashing with too much water (ie underloading) can cause the clothes to tangle around one another .
36 Manufac turer’ s W arranty Y ou automatically r eceive a 2 year Manufacturer’ s W arranty with the purchase of this Productcovering parts and labour for servicing within the countr y of purchase.
37 Manufac turer’ s W arranty E Normal recommended maintenance as set out in the product’ s user guide. F R epairs when the appliance has been dismantled, r epaired or serviced by other than a Fisher&Paykel authorised repair er or the selling dealer .
38 Cust omer Car e Before y ou call for service or assistance… Check the things you can do yourself . Refer to your U ser Guide and check: 1 Y our appliance is correctly installed. 2 Y ou are familiar with its normal operation. 3 Y ou have r ead the problem solving section at the back of the book.
39 Cust omer Car e Product details Fisher & P aykel Appliances Model Serial no. Date of Pur chase Purchaser Dealer Suburb T own Country.
.
.
NZ A U P AC SG 08.2013 F&P PN - 424675 A www.sherpaykel .com Copyright © F isher & Paykel 2013. A ll rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at an y time.
An important point after buying a device Fisher & Paykel MW513 QuickSmart (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Fisher & Paykel MW513 QuickSmart yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Fisher & Paykel MW513 QuickSmart - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Fisher & Paykel MW513 QuickSmart you will learn all the available features of the product, as well as information on its operation. The information that you get Fisher & Paykel MW513 QuickSmart will certainly help you make a decision on the purchase.
If you already are a holder of Fisher & Paykel MW513 QuickSmart, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Fisher & Paykel MW513 QuickSmart.
However, one of the most important roles played by the user manual is to help in solving problems with Fisher & Paykel MW513 QuickSmart. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Fisher & Paykel MW513 QuickSmart along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
