Instruction/ maintenance manual of the product CH18ABD1 Fedders
Go to page of 8
Installation, Oper ation and Maint enanc e 1.5 Thr oug h 5 T on H eat P ump INTRODUCTION ..............................................................................1 NOTES TO INST ALLER ..............................................................
NOTES TO INST ALLER The words “SHALL” and “MUST” indicate a requirement which is essential to satisfactory and safe product performance. The words “SHOULD” and “MA Y” indicate a recommendation or advice which is not essential and not required but which may be useful or helpful.
2 Six feet clearance above the unit Three feet clearance Rain Gutters Concrete slab Three feet clearance INST ALLA TION Condensing Unit Location The condensing unit should be located outdoors as close as possible to the evaporator .
Opening the Service V alve (Step V alve) NOTE: This is not a back-seating valve. 1. Remove the valve cap using an adjustable wrench. 2. Open the valve by inserting a hex wrench (3/16" for the liquid line, 5/16" for the vapor line) into the stem and back out counter-clockwise until the valve stem just touches the retaining ring.
4 CONNECT REFRIGERANT PIPING The following should be followed when installing refrigerant piping. Comply with all local, state, and federal codes and/or r egulations pertaining to this type of equipment and its installation. 1. Run the tubing by the most direct route and support every few feet.
Mo d e l 5 FINAL CHECKS FOR INST ALLER 1. Ensure that all wiring is routed away from tubing and she et metal edges to prevent rub-through or wire pinching. 2 . Ensure that all wiring and tubing is secure in unit before adding panels and covers. 3. Tighten service valve stem caps to 1/12 turn past finger tight.
6 24 AB 1 VF D CH 18 = 18000 BTU/H [5.28 kW] 24 = 24000 BTU/H [7.03 kW] 30 = 30000 BTU/H [8.79 kW] 36 = 36000 BTU/H [10.55 kW] 42 = 42000 BTU/H [12.31 kW] 48 = 48000 BTU/H [14.
M odel C10 & This W arranty Does Not Cover Damage Caused By: • Improper installation • Misuse of equipment • Negligent servicing • Improper applications • Preventative maintenance • Un.
An important point after buying a device Fedders CH18ABD1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Fedders CH18ABD1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Fedders CH18ABD1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Fedders CH18ABD1 you will learn all the available features of the product, as well as information on its operation. The information that you get Fedders CH18ABD1 will certainly help you make a decision on the purchase.
If you already are a holder of Fedders CH18ABD1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Fedders CH18ABD1.
However, one of the most important roles played by the user manual is to help in solving problems with Fedders CH18ABD1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Fedders CH18ABD1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
