Instruction/ maintenance manual of the product 55TRPAH England's Stove Works
Go to page of 46
PELLET AUXILIARY HEATER INSTALLATION & OPERATION MANUAL 25 ‐ PAH/55 ‐ SHPAH/55 ‐ TRPAH REV.
Page | 2 WARNING : Use of outside combustion air is mandatory with this unit. Do not operate with the hopper open; lid must be shut and tightly latched during operation.
Page | 3 TABLE OF CONTENTS Introduction Introduction ................................. 4 Specifications Heating Specifications .................. 5 Dimensions ........................
Page | 4 INTRODUCTION Thank you for purchasing this fine product from England’s Stove Works! England’s Stove Works was start.
Page | 5 SPECIFICATIONS Heating Specifications Heat Output Range** ............................................ 11,000 BTU/hr – 25,000 BTU/hr Approximate Pellet Burn Rate** .
Page | 6 INSTALLATION Installation Over view When choosing a loca tion for your new stove, there are a multitude of factors that should be taken into account before beginning the installation.
Page | 7 INSTALLATION Clearances to Combustibles Unit to Side Wall Unit to Rear Wall Unit to Corner Unit Top to Ceiling Min.
Page | 8 INSTALLATION Venting Introduction This pellet stove operates on a negative draft system, which pulls combustion air through.
Page | 9 INSTALLATION Additional Venting Information Do not mix and match components from different pipe manufacturers when assembling your venting system (i.
Page | 10 INSTALLATION Approved Venting Method 1 : Through the Wall Generally the simplest installation method, venting through .
Page | 11 INSTALLATION Approved Venting Method 2 : Through the Ceiling Venting through the ceiling/roof may be the only feasible venting option in some cases and is a factory recommended installation.
Page | 12 INSTALLATION Approved Venting Method 3 : Exis ting Chimn ey System Using an existing masonry or factory built chimney for venting is the only other acceptable method for venting this pellet unit.
Page | 13 INSTALLATION Mobile Home Installation The England’s Stove Works, Inc. outside air kit MUST be used for installation of this unit in a mobile home.
Page | 14 OUTSIDE AIR HOOK ‐ UP The use of outside combustion air is mandatory on this pellet stove.
Page | 15 FLOOR PROTECTION This pellet stove requires a non ‐ combustible floor protector if the stove is to be installed on a combustible floor.
Page | 16 DAILY OPERATION Getting Started Check to see that the hopper is clean and free from foreign materials.
Page | 17 Shortly after pressing the “On” button, the letters “ S U ” will appear in the heat range and blower speed windows of the control board.
Page | 18 CONTROL BOARD SETTINGS The control board on this stove allows the user to adjust the heat output and convection bl.
Page | 19 ERROR CODES Error codes, or “E ‐ Codes,” are alphanumeric codes that will appear in the Heat Range and Blower Speed windows of the Control Board if the unit experiences an abnormal condition.
Page | 20 POWER FAILURE If the power to the unit is interrupted for approximately three minutes or less, the unit will r.
Page | 21 THERMOSTAT OPERATION Thermostat Installation 1. Unplug the unit and remove the back panel of the stove.
Page | 22 THERMOSTAT OPERATION Thermostat Operation Details The 25 ‐ PAH|55 ‐ SHPAH|55 ‐ TRPAH was designed to operate equally well in both manual and thermostat mode.
Page | 23 DAILY MAINTENANCE Important Notes As with any maintenance concerning this unit, be sure the unit is “OFF” and has completed the Shut ‐ Down cycle BEFORE beginning.
Page | 24 Use a long handled screwdriver or putty knife to remove any deposits left in the burnpot, being careful to remove them from the burnpot and not allow them to filter down into the cradle area.
Page | 25 MONTHLY MAINTENANCE Important Notes As with any maintenance concerning this unit, be sure the unit is “OFF,” has completed the Shut ‐ Down cycle, and is completely cool BEFORE beginning.
Page | 26 Using a utility type vacuum cleaner, , vacuum the fly ash out of the exhaust chamber.
Page | 27 YEARLY MAINTENANCE Important Notes As with any maintenance concerning this unit, be sure the unit is “OFF,” has completed the Shut ‐ Down cycle, and is completely cool BEFORE beginning.
Page | 28 YEARLY MAINTENANCE Exhaust Blower Cleaning Although the exhaust blower and blower housing were designed to minimize ash build ‐ up, some fly ‐ ash will still accumulate there throughout the burning season.
Page | 29 YEARLY MAINTENANCE Convection Blower Cleaning As always, be certain the stove is cool and unplugged before servicing any components within the unit.
Page | 30 Trouble ‐ Shooting Guide WARNING: To avoid ELECTRICAL SHOCK always disconnect the unit from the power source BEFORE attempting any repair.
Page | 31 Unit Shuts Down in 15 ‐ 20 minutes with an "E ‐ 2" code on contr ol board . 1. Loose thermal sensor. 1. Check both sides of thermal sensor connection (exhaust blower and control board).
Page | 32 REPLACING COMPONENTS Auger Motor 1. Before beginning any component replacement, be certain the unit is unplugged and thoroughly cooled down.
Page | 33 REPLACING COMPONENTS Convection Blower 1. Before beginning any component replacement, be cert ain the unit is unplugged and thoroughly cooled down.
Page | 34 REPLACING COMPONENTS Vacuum Sensor 1. Before beginning any component replacement, be cert ain the unit is unplugged and thoroughly cooled down. 2. Remove the exhaust outlet cover plate and rear panel of unit.
Page | 35 REPLACING COMPONENTS Gaskets 1. Door o This unit comes with a 5 / 8 ” rope gasket around the door that should be replac ed at least every two years.
Page | 36 REPLACING COMPONENTS Glass This unit has a one ceramic glass panel (Part No. AC ‐ G17) in the viewing door; self .
Page | 37 REPLACING COMPONENTS Control Board The Control Board (Part # PAH ‐ CB09) is a digital read ‐ out board. This board offers a wide variety of settings to operate the unit.
Page | 38 WIRING DIAGRAM Caution – Shock Hazard Press the “Off” button and let the appliance completely cool BEFORE unplugging the appliance and beginning any maintenance or component replacement.
Page | 39 ILLUSTRATED PARTS DIAGRAM Auger Motor Assembly .
Page | 40 REPLACEMENT PARTS LIST Part Number Part Description Diagram # Gaskets PU ‐ HLG Hopper Lid Gasket 1 AC ‐ DGKNC 5/8”.
Page | 41 You may write your unit’s Manufacture Date and Serial Number in the blank spaces on this sample tag, for futu re reference. This sample tag also shows the safety info.
Page | 42 LIMITED FIVE (5) YEAR WARRANTY From the date of purchase to the original owner The manufacturer extends the following warrantie s: Five Year Period: 1.
Page | 43 Procedure Purchaser must give notice of claim of defect within the warranty period and pay transportation to and from a service center designated by the manufacturer.
Page | 44.
Page | 45 WARRANTY REGISTRATION for England’s Stove Works® Purchaser Information I. Purchased By (Name) _________________________________________ II. Address ____________________________________________________ III.
Page | 46 Important Notice This registration informatio n MUST be on file for this warranty to be valid. Please mail this information within thirty (30) days from the original date of purchase.
An important point after buying a device England's Stove Works 55TRPAH (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought England's Stove Works 55TRPAH yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data England's Stove Works 55TRPAH - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, England's Stove Works 55TRPAH you will learn all the available features of the product, as well as information on its operation. The information that you get England's Stove Works 55TRPAH will certainly help you make a decision on the purchase.
If you already are a holder of England's Stove Works 55TRPAH, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime England's Stove Works 55TRPAH.
However, one of the most important roles played by the user manual is to help in solving problems with England's Stove Works 55TRPAH. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device England's Stove Works 55TRPAH along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
