Instruction/ maintenance manual of the product Water Dispenser Emerson Process Management
Go to page of 8
Division of Emerson Electric Co. Racine, Wisconsin 53406, U .S .A. In-Sink-Erator Instant Hot W ater Dispenser Installation, Care & Use Guide Congratulations on the purchase of your new In-Sink-Erator instant hot water dispenser . This product is designed and manufactured to the highest standards.
wall s witch 115 V A C line Disposer outlet only is controlled by wall switch. Use this diagram if you are using the same wall outlet f or the dispenser and your disposer .
INST ALLA TION INSTRUCTIONS 1 IF YOU WISH T O USE THE HOLE IN WHICH THE SPRA Y HOSE IS LOCA TED, FOLLOW THESE EASY STEPS: 1. T urn off water supply 2. Remove nut that connects spray hose at bottom of faucet. 3. Remove nut that connects spray hose at bottom of washer flange in spray hole using ordinary wrench or basin wrench.
A B C Release Button Product Damage • Do not connect electric power until tank is filled with water ( step 10 ). • Failure to do so may damage heating element or trip the thermal over load protector .
Product Damage Overtightening the plastic nut can break the inlet fitting. Product Damage - DO NO PLUG IN YET Do not plug unit in until tank is filled with water and water flows from spout. Product Damage • Make sure bends in all tubes are smooth and unkinked before you proceed.
The thermostat is factory pre-set at approximately 190˚F (88˚C). If the temperature needs to be adjusted follow the steps outlined below . 1. Unplug or disconnect the unit from the electrical supply . 2. Remove the screw securing the access cover to the unit (see Figure 1).
TROUBLESHOOTING GUIDE INST ALLA TION QUESTIONS? Call the Answerline at 1-800-558-5700 Problem Wa t e r is not hot Wa t e r too hot or not hot enough W ater dripping from the spout or vent: • When heating • Constantly W ater comes out the vent instead of the spout.
Property Damage • Do not plug unit in until tank is filled with water and water flows from spout. • T o avoid water damage due to leakage, replace any cut, loose or split plastic tubing. Important: Do not install this appliance in public areas or institutions where there is unsupervised access to this appliance.
An important point after buying a device Emerson Process Management Water Dispenser (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Emerson Process Management Water Dispenser yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Emerson Process Management Water Dispenser - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Emerson Process Management Water Dispenser you will learn all the available features of the product, as well as information on its operation. The information that you get Emerson Process Management Water Dispenser will certainly help you make a decision on the purchase.
If you already are a holder of Emerson Process Management Water Dispenser, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Emerson Process Management Water Dispenser.
However, one of the most important roles played by the user manual is to help in solving problems with Emerson Process Management Water Dispenser. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Emerson Process Management Water Dispenser along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
