Instruction/ maintenance manual of the product CF725GES00 Emerson
Go to page of 16
Part No. F40BP73690000 Form No. BP7369 U.L. Model No.: CF725 READ AND SA VE THESE INSTRUCTIONS Net W eight: 23.4 Lbs. VIENNE ™ 52” Ceiling Fan Owner's Manual CF725GBZ00 CF725GES00 Model No.
2 W ARNING: T o avoid fire, shock, and serious personal injury , follow these instructions. Safety Instructions 1. Read your owner ’s manual carefully and keep it for future reference.
3 This Manual is Designed to Make it as Easy as Possible for Y ou to Assemble, Install, Operate and Maintain Y our Ceiling Fan Do not install or use fan if any part is damaged or missing.
1. T wo 1-1/4” threaded studs 2. T wo knurled knobs 3. T wo lockwashers 4. Three wire connectors 5. One clevis pin 6. One hairpin clip 7. Eleven M5 x 18mm oval head screws 8.
5 General Y our Emerson ceiling fan comes supplied with a SW102 Fan/Light W all Control and a Remote Control Receiver . This system allows you to regulate your ceiling fan speed and light intensity . NOTE: An optional Emerson Electric SR100 Remote Control may also be used to control your ceiling fan.
6 4. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 3). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 10.
7 REINST ALL THREE M4 x 15mm P AN HEAD SCREWS AND RUBBER WASHERS UPPER HOUSING RING MOTOR AND UPPER HOUSING ASSEMBL Y Figure 5 9. Make sure the grommet is properly installed in the coupler cover , then slide the coupler cover on the downrod until it rests on the motor and upper housing assembly (Figure 6).
8 T o reduce the risk of fire, electric shock, or personal injury , mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced.
9 1. Position the supply wires to the left side of the outlet box (Figure 10); position the fan wires to the right side. Partially insert the remote control receiver (flat side up) until one end rests on the hanger ball as shown in Figure 10. NOTE: Make all wiring connections using wire connectors (supplied).
T o avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling canopy and the ceiling.
10. Screw in two 60-watt (maximum) candelabra bulbs (supplied) in the light fitter sockets (Figure 14). 11 . Remove the finial nut, hex nut and washer from housing downlight assembly . 12. Position the glass over the threaded nipple. Slide the washer onto the threaded nipple and gently tighten the hex nut to secure the glass and washer .
Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock. ! W ARNING The use of any other control not specifically approved for this fan could result in fire, shock and personal injury .
T rouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. W ARNING: Make sure main power is turned off. 2. Loose power line 2. Check line power connections connections to the fan.
Repair Parts 9 3 2 1 5 4 12 19 16 8 10 20 11 13 6 7 17 14 16 22 15 18 21 23 FAN OFF LOW MED HI LIGHT Before discarding packaging material, be certain all parts have been removed.
Part Numbers Key Model No. Model No. N o . Description CF725GBZ00 CF725GES00 * Hanger Pack, Consisting of: 761655-75 761655-76 1 Hanger Bracket — — 2 Hanger Ball — — 3 Downrod — — * Parts .
LIMITED WARRANTY What The War ranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. Y ou must be the original pur chaser or user of the product to be covered.
An important point after buying a device Emerson CF725GES00 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Emerson CF725GES00 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Emerson CF725GES00 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Emerson CF725GES00 you will learn all the available features of the product, as well as information on its operation. The information that you get Emerson CF725GES00 will certainly help you make a decision on the purchase.
If you already are a holder of Emerson CF725GES00, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Emerson CF725GES00.
However, one of the most important roles played by the user manual is to help in solving problems with Emerson CF725GES00. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Emerson CF725GES00 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
