EN
Alcatel-Lucent logo
Official user manual

Alcatel-Lucent Corded Phone (22)

8 pages·1 MB·Telephone·PDF·ENDEFRITNLJA
Alcatel-Lucent Corded Phone (22)
Table of Contents 31 sections Downloaded from - http://www.guardianalarms.net · 1. SETUP · B A · 2. WALL MOUNTING · … ShowHide
Page 1 of the Alcatel-Lucent Corded Phone (22) user manual — Downloaded from - http://www.guardianalarms.net
Page 1 · click to enlarge
Page 1
Alcatel-Lucent Corded Phone (22) — Downloaded from - http://www.guardianalarms.net diagram (page 1)
Fig. 1 · Downloaded from - http://www.guardianalarms.net
Alcatel-Lucent Corded Phone (22) — Downloaded from - http://www.guardianalarms.net diagram (page 1)
Fig. 2 · Downloaded from - http://www.guardianalarms.net

Downloaded from - http://www.guardianalarms.net

Page 2 of the Alcatel-Lucent Corded Phone (22) user manual — 2. WALL MOUNTING
Page 2 · click to enlarge
Page 2

1. SETUP

Plug one end of the spiral cord into the handset plug (A), and the other end into the

socket located on the left-hand side of the phone (B).

B A

Plug the telephone cord into the socket (C) situated on the back of the set and plug

the other end (D) into the telephone wall socket.

E

D

Stick the emergency number label in the appropriate place.

2. WALL MOUNTING

To mount your telephone set on the wall, remove the wall mounting peg and put it back in reverse position as described below.Bore two 6mm-large holes, spaced 70 mm apart. Put two plugs in place, then, place in two screws (3.5 mm Ø and 25 mm long) without tightening them.

Place the cord in the slot situated underneath the set.

Wall mounted position Horizontal position

Page 3 of the Alcatel-Lucent Corded Phone (22) user manual — 1. SETUP
Page 3 · click to enlarge
Page 3
Alcatel-Lucent Corded Phone (22) — 1. SETUP diagram (page 3)
Fig. 3

* on TEMPORIS 22 only

Page 4 of the Alcatel-Lucent Corded Phone (22) user manual — 3.7 ADDITIONAL SERVICES KEYS
Page 4 · click to enlarge
Page 4

3. GENERAL USE

3.1 LINE LAMP / MESSAGE WAITING LAMP

This light flashes in rhythm with the ringing when you receive a call. It lights up as soon as you take the line.

If you are connected to a private ALCATEL telephone system equipped with mail, the message waiting lamp informs you of a message in your “mail box”.

Dialling can be done in two different ways:

By lifting the handset then dialling.

By dialling in on hook mode.

3.2 DIALLING IN ON HOOK MODE*

Press the loudspeaker key then dial your correspondent’s number. Go off hook to establish the conversation.

3.3 LOUDSPEAKER KEY*

During a call, press the Loudspeaker key so that the people around you can hear the conversation.

Adjust the sound level with the and keys.

Deactivate the loudspeaker by pressing the Loudspeaker key again.

3.4 HANDSET SOUND VOLUME*

When the loudspeaker is deactivated, you can increase the handset sound volume.

Press the key.

To return to the initial volume, press the key.

3.5 MUTE

Press the Mute key. Your correspondent can no longer hear you during this waiting

time.

1 beep is generated on the line every 10 seconds.

To resume the conversation, press the Mute key again.

3.6 LAST NUMBER REDIAL

Go off hook.

Press the Last Number Redial key.

To erase the last number redial

Go off hook.

Press the Programming key twice.

Press the Last Number Redial key.

3.7 ADDITIONAL SERVICES KEYS

Function keys allowing access to additional services. (Ask at your local Telecom company or your fitter for information).

* On TEMPORIS 22 only

Page 5 of the Alcatel-Lucent Corded Phone (22) user manual — 5.2 WHEN IN PROGRAMMING MODE
Page 5 · click to enlarge
Page 5

4. USING THE MEMORIES

Your telephone set can store 10 numbers of up to 24 digits.

4.1 PROGRAMMING THE MEMORIES

Go off hook.

Press the Programming key.

Enter the number.

Press one of the ten memory keys.

Go off hook.

Enter the number.

Press the Programming key whether you are in conversation or not.

Press one of the ten memory keys.

4.2 DIALLING FROM A MEMORY

Go off hook.

Press one of the ten memories keys.The loaded number is dialled automatically.

4.3 ERASING A MEMORY

Go off hook.

Press the Programming key twice.

Press the key corresponding to the memory to be erased.

5. CHOOSING AND ADJUSTING THE RINGER

You can choose and adjust one of the four melodies available when your telephone is ringing, or at any time after entering the programming mode.

5.1 WHEN YOUR TELEPHONE IS RINGING

Modification of the ringer can be carried out during a ringing phase.

Press one of the keys 1, 2, 3 or 4 to change the melody.

To reduce or increase ringing volume, press or on TEMPORIS 22 or press or on TEMPORIS 12.

Your modifications are memorized, you can answer the call.

5.2 WHEN IN PROGRAMMING MODE

To access the programming mode:

Press and hold keys 1 and 3 simultaneously.

Pick up the handset.

Release the keys.

Access to programming mode is confirmed by 1 beep.

Programming without calling · Programming whilst calling

Page 6 of the Alcatel-Lucent Corded Phone (22) user manual — 6.3 MODIFYING THE PASSWORD
Page 6 · click to enlarge
Page 6

To adjust the ringing:

Press the Programming key then key 1 (current melody is heard).

To reduce or increase ringing volume, press or on TEMPORIS 22 or press or on TEMPORIS 12.

Pressing a key between 1 and 4 changes the melody.

To put ringer ON/OFF:

Press the Programming key then key 0.

Press to put the ringer OFF. When ringer is OFF, 4 BEEP are heard when picking up the handset.

Press to put the ringer ON.

Put the handset on hook.

6. LOCKING THE TELEPHONE SET

Thanks to a 4-digit password, your can:

Forbid access to the ringing tone programming.

Forbid access to the configuration for professional use.

Limit calls to phone numbers of up to 6 digits maximum. The initial password is 0000.

6.1 ACCESSING THE PROGRAMMING MODE

Your are offered 3 operations. For each of them, access the programming mode again.

Press and hold keys 4 and 6 simultaneously.

Pick up the handset.

Release the keys.

6.2 LOCKING / UNLOCKING

Press the Programming key followed by 1.

Press the key.

Go on hook.

Press the # key.

Enter the password.

Go on hook.

6.3 MODIFYING THE PASSWORD

Access the programming mode again and then:

Press the Programming key followed by 2.

Enter the current password. 2 beeps are generated.

Enter the new 4-digit password. 2 beeps are generated.

Enter it a second time. 2 beeps are generated.

Put the handset on hook.

Locking · Unlocking

Page 7 of the Alcatel-Lucent Corded Phone (22) user manual — 7.3 FLASH DURATION (R)
Page 7 · click to enlarge
Page 7

6.4 IF YOU FORGOT THE PASSWORD

Access the programming mode again and then:

Press the Programming key followed by 0.

Press the * key.

2 beeps are generated.

Go on hook.

This last operation erases the WHOLE programming including

memories. The password is 0000 again.

7. CONFIGURATION FOR PROFESSIONAL USE

If your TEMPORIS is connected directly to the public network, do not pay attention to this chapter.

7.1 ACCESSING THE PROGRAMMING MODE

Your are offered 3 operations. For each of them, access the programming mode again.

Press keys 1 and 3 simultaneously.

Go off hook.

Release the keys.

7.2 TYPE OF DIALLING

Press the programming key followed by 2.

Press the key (or key)

Go on hook.

Press the key (or key).

Go on hook.

7.3 FLASH DURATION (R)

Access the programming mode again and then:

Press the Programming key followed by 3.

Press1 for a 80 ms flash,

2 for a 100 ms flash, 3 for a 180 ms flash, 4 for a 250 ms flash, 5 for a 300 ms flash, 6 for a 600 ms flash.

Go on hook.

For pulse dialling · For tone dialling

Page 8 of the Alcatel-Lucent Corded Phone (22) user manual — 9. CUSTOMERS SERVICE
Page 8 · click to enlarge
Page 8

8. GUARANTEE

This product is guaranteed according to the clauses offered by your distributor.

To get this guarantee you must use your telephone according to the instructions of the

user guide and you have to keep the invoice or ticket mentioning purchasing date and distributor name.

The guarantee doesn’t apply in case of:

- problem due to abnormal use, - telephone damaged by shocks or fall, - telephone damaged by overvoltage, lighting, fire or water, - maintenance by unauthorized person.

9. CUSTOMERS SERVICE

The store from which you bought the set is in a position to give you information and/or provide after-sales service.

This product is designed to be connected to an analog telephone line classified TNV3.

DECLARATION OF CONFORMITY According the disposition of the directive 1999/5/EC of the European parliament and of the council of 9 March 1999 on radio equipment and Telecommunications terminal equipment and the mutual recognition of their conformity. The certificate of conformity is available from the following Internet site: “www.atlinks.com”

The manufacturer reserves the right to modify

make technical improvements or comply with

new regulations. Nanterre companies registry

the specifications of its products in order to

An ALCATEL/THOMSON multimedia Joint Venture Company

Ref3BQ 13197 AAAE 05/01

Sales and Marketing Departments:

41 boulevard de la République - Bât. B6 - 78400 Chatou - France

number: 390 546 059.

Head office46, quai Alphonse Le Gallo

92100 Boulogne Billancourt - France

Printed by :

Engineered by

Ask about the Alcatel-Lucent Corded Phone (22)

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Alcatel-Lucent Corded Phone (22)

Be the first to ask — other owners or our team will answer.

Original document

Alcatel-Lucent Corded Phone (22) manual PDF

8 pages·1 MB·Telephone·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…