Instruction/ maintenance manual of the product EGG 690 Electrolux
Go to page of 16
Gas hob Mod. EGG 690 INSTR INSTR INSTR INSTR INSTR UCTION BOOKLET UCTION BOOKLET UCTION BOOKLET UCTION BOOKLET UCTION BOOKLET Please read this instruction booklet before using the appliance 35685-4801.
2 This appliance complies with the following E.E.C. Directives: * 73/23 - 90/683 (Low V olt ageDirective); * 93/68 (General Directives); * 89/336 (Electromagnetical Compatibility Directive) ; * 90/396.
3 Content s For the User For the Inst aller Import ant Safety Information 2 Description of the Hob 3 Operation 4 Maintenance and Cleaning 4 Something Not W orking? 5 Service and S pare Part s 5 Guaran.
4 Operation Hob burners To light a burner: z push in the relevant control and turn it to maximum position; z then adjust the flame as required. z If the burner does not ignite, turn the control knob to zero, and try again.
5 Something Not W orking? If the hob is not working correctly , please carry out the following checks before contacting your local Service Force Centre. IMPORT ANT : If you call out an engineer to a fault listed below , or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
6 Guarantee Conditions Customer Care Dep artment For general enquiries concerning your Electrolux appliance or for further information on Electrolux product s, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.
7 Overall dimensions Width: 615,5 mm (front edge) 580 mm (rear edge) Depth: 510 mm Cut out dimensions Width: 550 mm Depth: 470 mm Supply connections Gas: R 1/2 inch (1/2 inch male) Rear right hand corner Electric: 230-240V 50Hz supply , 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse.
8 A) End of shaft with nut B) Washer C) Elbow FO 0814 FO 0264 FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE FITTING THE GAS HOB WITH A COOKER HOOD ABOVE Import ant safety requirement s This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition).
9 Building In Cut Out Size The dimensions of the cut-out are given in the diagram. FO 2098 ON/OFF SWITCH FLEX OUTLET ON/OFF SWITCH FLEX OUTLET FO 0763 FO 0764 1 2 Dimensions are given in mm.
10 ) Electrical connections Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed.
11 A. IGNITOR SWITCH B. IGNITOR UNIT 1 2 L N 0 220 240 1 2 3 4 W iring Diagram Fault Finding Preliminary Electrical Systems Check A. EARTH CONTINUITY CHECK - Appliance must be electrically disconnected - meter set on Ω (Ohms) x 1 scale and adjust zero if necessary .
12 Ignition System / Gas Ignition YES Check plug top fuse and replace if necessary Check polarity and earth continuity of supply point Check earth continuity of appliance Ignitor does not spark Check .
13 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. T o do this, follow the procedure below . - T urn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times.
14 Conversion from Natural Gas to LPG It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted.
15.
Grafiche MDM - Forlì 10/03 CUSTOMER CARE Electrolux 55-77 High S treet Slough Berkshire, SL1 1DZ T el: 08705-950950 © Electrolux plc 2003 The Electrolux Group. The world’ s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use.
An important point after buying a device Electrolux EGG 690 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux EGG 690 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux EGG 690 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux EGG 690 you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux EGG 690 will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux EGG 690, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux EGG 690.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux EGG 690. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux EGG 690 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
