Instruction/ maintenance manual of the product EFI 625 Electrolux
Go to page of 20
INSTRUCTION BOOK FOR ELECTROLUX COOKER HOOD EFI 625 and EFI 630 cod. 4329618 04 - 010911 UK.
2 Thank you for buying an Electrolux product. T o enable you to use your appliance effectively and safely , please read this instruction book carefully before using the appliance and retain for future reference.
3 IMPORT ANT SAFETY INFORMA TION These warnings are provided in the interests of your safety . Ensure that you understand them all before installing or using this appliance. Y our safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department.
4 YOUR APPLIANCE OPERA TING INSTRUCTIONS This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. T o obtain the best performance it is advisable to switch on the hood a few minutes before you start cooking and leave it running for approximately 15 minutes after finishing.
5 T o Operate Open the visor and select the required functions. The appliance can be installed to recirculate or extract contaminated air. The cooker hood is more ef fective when used in the extraction mode. Recirculation The hood is supplied specified for use in the recirculation mode with the charcoal filter/s fitted.
6 MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply . The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent.
7 3. Clean the metal inlet grille/s and motor support/ s before replacing the charcoal filter/s. 4. Place the new charcoal filter/s (B) over the motor support/s (A), and while holding the filter securely insert the disk (C) and turn clockwise. This appliance can be a fire hazard if the grease and charcoal filters are not replaced as recommended.
8 SOMETHING NOT WORKING SERVICE AND SP ARE P ARTS If, having followed these instructions carefully , your cooker hood fails to work properly please carry out the following checks.
9 GUARANTEE CONDITIONS ST ANDARD GUARANTEE CONDITIONS We, Electrolux, undertake that if within twelve months of the date of the purchase this Electrolux built-in appliance or any part there of is prov.
10 INST ALLA TION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way . T echnical Information DIMENSIONS HEIGHT : 350mm WID TH: 598mm DEPTH: 270-360m.
11 INST ALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air.
12 A: Built-in Electric Hob: 650mm minimum clearance B: Built-in Gas hob: 700mm minimum clearance C: Slot-in Electric Cooker: 685mm minimum clearance D: Slot-in Gas Cooker: 787mm minimum clearance Hob.
13 V enting The hood is more ef fective when used in the extraction setting (ducted to the outside). V enting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of (EFI 625) 100mm (4 ins) or (EFI 630) 125mm (5 ins) minimum.
14 Fitting the Cooker Hood to the W all 1. Fit the brackets with the round ends facing downwards using the plastic rawl plugs and screws provided. 2. Once the brackets are secured, lift the hood squarely to the wall slightly higher than the brackets and lower the cooker hood until it is located onto the two brackets.
15 T o Refit the Hood with Decor Panel Attached 1. Insert the upper visor guides into the upper track in the front of the casing. 2. Pull down the bottom edge of the visor and insert the lower guides into the track in the bottom of the casing. 3. Push the visor in until an audible click is heard.
16.
17.
18.
19.
55 - 77 High Street - Slough BERKSHIRE SL1 1DZ © Electrolux Household Appliances Limited 2001.
An important point after buying a device Electrolux EFI 625 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux EFI 625 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux EFI 625 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux EFI 625 you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux EFI 625 will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux EFI 625, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux EFI 625.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux EFI 625. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux EFI 625 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
