Instruction/ maintenance manual of the product 8820 Electrolux
Go to page of 21
H I 8820 CHDI 8820 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation.
61 Printed on recycled paper AEG - putting words into action Content s Safety warnings 62 For the User 62 For the Installer 62 Description of the Appliance 64 Extraction 64 Recirculation 64 Control Pa.
62 Safety warnings For the User The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames.
63 The national Standard on fuel-burning systems specifies a maximum depression of 0.04 mbar in such rooms. The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed.
64 Description of the Appliance The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter . Y ou will need an original AEG charcoal filter for this function (A vailable from your local AEG Service Force Centre).
65 Control Panel Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. T urn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen.
66 Control device for grease and charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter).
67 Maintenance and care The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products.
68 g g h d i h g g Charcoal filter The charcoal filter should only be used if you want to use the hood in the recirculation function. T o do this you will need an original AEG charcoal filter (available from your local Service Force Centre).
69 W arning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. Y ou are therefore strongly recommended to follow these instructions.
70 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply . Check that a fan speed has been selected The cooker hood is not working Check that: effectively .
71 T echnical assist ance service (not for UK) Y ou are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. For service in Australia call 1300 650 020.
72 T echnical Specifications Dimensions: Height x Width x Depth (in cm) 81,5-1 10 x 120 x 70 Maximum absorbed power: 255 W Motor absorption: 1 x 175 W Lighting: 4 x20 W Length of the cable: 150 cm Ele.
73 Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply , check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access.
74 Installation - Fig. 7-8-9-10 Assembling the deflector (3 parts only for filter version): The three parts should be fixed with 2 screws, the deflector extension is adjustable and should correspond to the width of the chimney flue support, to which it is then fixed.
75 Fig. 8 2a 3 4 4 4 4 4 4 6 6 7 7 7 7 8 8 2a 5 7 9 10 10 10 10 11 11 14,5 273 273 244 214 190 6 12 2b 2b.
76 For extractor versions (13A), connect the other end of the exhaust pipe to the flue. For filter versions (13F), fit deflector F to the support and secure it to the bracket supplied using 4 screws, then connect the exhaust pipe to the connection ring located on the deflector .
77 Fig. 9 15b 15b 15b 15b 15b 16 16 15b 15b 13F F 13A 15b 14 15a 15b.
78 Fig. 10 18 18 18 18 18 18 18 18 18 18 M 19 19 X X 20 20 17.
79.
LI2AZA Ed. 01/04 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www .aeg.hausgeraete.de http://www .aeg.co.uk © Copyright by AE G From the Electrolux Group. The world´s No.1 choice. The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor use.
An important point after buying a device Electrolux 8820 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux 8820 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux 8820 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux 8820 you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux 8820 will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux 8820, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux 8820.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux 8820. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux 8820 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
