Instruction/ maintenance manual of the product 506030 Electrolux
Go to page of 20
3 ENGLISH .0 A SAFETY INSTRUCTIONS ............. ................................ ............... .................... Pag. 4 B GENERAL RECOMMENDATIONS ........ ................................................. ......... Pag. 5 B1 HANDLING ...........
4 To reduce the risk of fi re, electrical shock, or injury whe n using your potwasher, please follow these basic pre- cautions including the following: • Read all instructions before using yo ur potwasher. • This Manual does not cover every possib le condition an d situation that may occur.
ENGLISH 5 WARNING CAREFULLY READ THE INSTALLATION OPERA - TING AND MAINTENANCE INSTRUCTIONS BEFORE INSTALLING THIS APPLIANCE. INCORRECT INSTALLATION, ADAPTATIONS OR ALTERNATIONS COULD CAUSE DAMAGE TO PROPERTY OR PER- SONAL INJURY.
6 B3 DISPOSAL OF PACKING MATERIAL All the packaging materials are environ mentally safe and friendly. They maybe kept withou t fear or danger. They may be recycled or burned in a special waste incinera- tion plant.
ENGLISH 7 B4 TECHNICAL DATA Table 2 Standard cycle time m ay vary should the inlet water temperature be different from tha t indicated above. MODEL WT830M/PW1M WT830H/PW1MH WT850M/PW2M Supply voltage: 208 V, 3 ph, 60 Hz 45 amp 208 V, 3 ph, 60 Hz 45 amp 208 V, 3 ph, 60 Hz 56 amp Total Watts 14.
8 Figure 4 Installation diagram PW1M Legend Figure 4 A - Water inlet p ipe with 3/4”dia /19mm fittin gs C - Outlet pipe 1 5/8” ID /40 mm (^) –11 /16” ID /18 mm (*).
ENGLISH 9 Figure 5 Installa tion diagram PW1MH Legend Figure 5 A - Water inlet pi pe with 3/4”dia/19mm fittings C - Outlet pipe 1 5/8” ID /40 mm (^) –11/16” ID /18 mm (* ).
10 Figure 6 Installation diagram PW2M Legend Figure 6 A - Water inlet p ipe with 3/4”dia /19mm fittin gs C - Outlet pipe 1 5/8” ID /40 mm (^) –11 /16” ID /18 mm (*).
ENGLISH 11 A fused disconne ct switch or a main circuit breaker (customer f urnished) MUST be installed in the electric su pply line f or th e appliance.
12 The ground wire must have a cross section of AWG 6/13,3 mm 2 . Do not use the wiring cond uit or other piping for ground connections. If necessar y, have the electrician supply the ground wire.
ENGLISH 13 If necessary, repeat this operat ion several times. C5 SETTING THE DISPENSERS All operations should be car ried out with the applia nce switched on, the door open an d no cycle selected.
14 Setting the activation time: Exit from pr ogramming mode: Notes for ext ernal dispensers: -i f dEt=181 the detergen t dispenser only oper- ates during wash pump operation ; terminals 7 and 9 of the main termin al box are powered at the same time.
ENGLISH 15 Our appliances have be en stu died and optimized to g ive th e h ighest pe rformanc e. This ap plia nce must be used exclusi- vely for the purpose for wh ich it has be en desig ned, i.e. for washing pans with water and spe cific detergents.
16 If the door is opened d uring this stage the message "CLOSE" will scroll on the display : The filling and heating stag e has finished when the display show s the tank t emperatur e: To display the b oiler temperature duri ng heating of the tank, open the door and pr ess “J” button (Figure 12).
ENGLISH 17 CAUTION: Do not allow handles to protrud e through bottom of rack, they may block wash and r inse arms rotation (Figure 15). Figure 15 Increase / decrease th e wash force To wash lightweigh.
18 D4 END OF WORK AND DA ILY CLEANING The appliance is designe d to carry out an automatic cleaning cycle to help flush out any residues and to guarantee greater health and hygiene : • Open the door and take out the r ack containing the clean pans.
ENGLISH 19 Cleaning the pump filter • Remove the pump filter “M” and clean any food trap- ped in filter. Figure 21 Clean the tank • Open the do or for acce ss to the ta nk (Fig ur e 22 ): - lift the lever “S” and pull the door outwards; - g en tly low er the do o r.
20 Close the door and select the drain cycle by pressing the “B” butto n (Figure 12 ). The message “CLE” ("CLEAN") will be displayed throu- ghout the drain cycle.
ENGLISH 21 This message advises calling a qualified authorized ser- vice technician for a general check- up on of the state of the appliance. NOTICE : CONTACT YOUR AUTHORIZED SERVICE COMPANY TO PERFORM MAINTENACE AND REPAIRS.
22 E TROUBLESHOOTING POTWASHER DOES NOT WASH WELL 1. Check if the suction filter is di rty, if so clean it thoroughly. 2. Check if the wash jets are clogged by solid food particles. 3. Check that the initial amount of de tergent or subsequen t additions are correct.
An important point after buying a device Electrolux 506030 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Electrolux 506030 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Electrolux 506030 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Electrolux 506030 you will learn all the available features of the product, as well as information on its operation. The information that you get Electrolux 506030 will certainly help you make a decision on the purchase.
If you already are a holder of Electrolux 506030, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Electrolux 506030.
However, one of the most important roles played by the user manual is to help in solving problems with Electrolux 506030. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Electrolux 506030 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
