Instruction/ maintenance manual of the product FSTMO75 3M
Go to page of 12
Installer: Please leave this manual with owner/operator . End User: Please retain for operation and future maintenance instructions. FlashGARD HP ™ Reverse Osmosis F iltration S ystem Model Number F.
T o reduce the risk associated with property damage due to water leakage: • Read and follow Use Instructions before installation and use of this system. • Before starting installation, shut off main water supply and drain pipes. • Installation and Use MUST comply with all state and local plumbing codes.
Table of Contents Safety Instructions ............................................................................................................. ................................................... Page 2 Caution and Warning Statements ........ ....
Mounting 1) Remove the mounting bracket template (see page 10) from this manual. Tape it to the wall where the mounting bracket is to be installed. 2) Install mounting screws (not included) into each of the keyhole locations on the template.
T o reduce the risk associated with property damage due to water leakage: • Before starting installation, shut off main water supply and drain pipes. • Installation and Use MUST comply with all state and local plumbing codes. • Do not install on hot water supply lines.
6 System Start-Up 1) Remove the prefilter cartridge from its packaging. Remove the red cap from the cartridge and moisten the o-rings with water Insert the cartridge interconnect into the filter head. Be sure that the ears on the cartridge line up with the spaces in the head.
7 Tools Required: • Piece of 1/4” tubing or Bucket • Bicycle or tire pressure gauge • Bicycle tire pump 1 ) Empty the storage tank. a. Shut off the inlet water valve and Water Booster System if applicable. b. Make sure tank shut-off valve located at the top of the water tank is open.
8 Problem Cause Solution Notes Unit Runs Low or Out of Water Low Feed Water Pressure Repair Beverage Booster Pump/System Contact Dealer Add Booster Pump Assembly Only if Beverage Booster System is not.
9.
10.
11.
12 - © 2008 3M Company . All rights reserved. 3M and CUNO are trademarks of 3M Company used under license. INSTR4226 DRAFT CUNO Incorpor ate d 400 Resea rch Pa rk wa y Meriden, C T 06 450, USA T oll Fr ee: 1.888.21 8.CUNO Wo rldwide : 203.237 .5 54 1 Fa x : 203.
An important point after buying a device 3M FSTMO75 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought 3M FSTMO75 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data 3M FSTMO75 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, 3M FSTMO75 you will learn all the available features of the product, as well as information on its operation. The information that you get 3M FSTMO75 will certainly help you make a decision on the purchase.
If you already are a holder of 3M FSTMO75, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime 3M FSTMO75.
However, one of the most important roles played by the user manual is to help in solving problems with 3M FSTMO75. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device 3M FSTMO75 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
