Instruction/ maintenance manual of the product XPA6100 Dual
Go to page of 12
INSTALLATION/OWNER ’ S MANUAL Mobile Power Amplifiers XPA SERIES XPA2100 XPA4100 XPA6100.
2 XPA SERIES INSTALLATION Preparation Please read entire manual before installation. Due to the technical nature of amplifiers, it is highly recommended that your DUAL amplifier is installed by a professional installer or an authorized dealer. Before You Start • Disconnect negative battery terminal.
NOTE Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used a general guideline only. Power Wire (+12V) • Disconnect negative battery terminal before proceeding.
4 XPA SERIES INSTALLATION Power and Speaker Connections Speaker Connection(s) Ground Connection Remote Connection 1 2 3 +12VDC Battery Connection Fuse(s) 4 5 1 23 4 5 43 2 5 1 4 3 2 5 1.
5 XPA SERIES INSTALLATION Audio Inputs and Controls LED Indicator Bass Boost Crossover Mode Switch Crossover Frequency 1 2 3 4 Input Level Control High Level Inputs Low Level Inputs Inp.
6 XPA SERIES INSTALLATION Fuse Rating When replacing fuses, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the amplifier. XPA2100 25 amp ATO x 1 XPA4100 25 amp ATO x 2 XPA6100 20 amp ATO x 2 Power/Ground Wire Size For optimum performance, use only the wire size listed below or larger.
7 XPA SERIES INSTALLATION Amplifier Connections Speaker Connections Connect speaker wires observing polarity. The minimum impedance load for the XPA2100 and XPA4100 is 2 ohms stereo and 4 ohms bridged. The minimum impedance load for the XPA6100 is 2 ohms.
8 XPA SERIES OPERATION Configuration/Setup The input level control (gain) is used to obtain the best possible match between the head unit audio output and the amplifier input. Begin by turning the input level control fully counterclockwise. Next, turn up the head unit volume control around 3/4 of the way up.
9 XPA SERIES WARRANTY Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
10 XPA SERIES OPERATION Specifications CEA-2006 Power Standard Specifications (reference: 14.4VDC, 20Hz~20kHz) Power Output: 50 Watts RMS x 2 channels at 4 ohms and.
11 XPA SERIES OPERATION Specifications CEA-2006 Power Standard Specifications (reference: 14.4VDC, 20Hz~200Hz) Power Output: 200 Watts RMS x 1 channel at 4 ohms and.
Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2008 Dual Electronics Corp. NSA0208-V02 XPA SERIES OPERATION Troubleshooting Problem Cause Action Unit will not turn on.
An important point after buying a device Dual XPA6100 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dual XPA6100 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dual XPA6100 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dual XPA6100 you will learn all the available features of the product, as well as information on its operation. The information that you get Dual XPA6100 will certainly help you make a decision on the purchase.
If you already are a holder of Dual XPA6100, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dual XPA6100.
However, one of the most important roles played by the user manual is to help in solving problems with Dual XPA6100. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dual XPA6100 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
