Instruction/ maintenance manual of the product XIA5600 Dual
Go to page of 12
INSTALLATION/OWNER ’ S MANUAL 2/1-Channel Mobile Power Amplifier XIA5600.
2 XIA5600 INSTALLATION Preparation Please read entire manual before installation. Due to the technical nature of amplifiers, it is highly recommended that your DUAL amplifier is installed by a professional installer or an authorized dealer. Before You Start • Disconnect negative battery terminal.
NOTE: Be sure to follow specific instructions included with your amplifier installation kit (not included with this amplifier). The information below should be used a general guideline only.
4 XIA5600 INSTALLATION Connections and Controls Low Level Inputs High Level Inputs Input Level Control Crossover Frequency Crossover Mode Switch Bass Boost LED Indicator 1 2 3 Ground Connect.
5 XIA5600 INSTALLATION Typical Wire Routing Fuse Rating When replacing fuses, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the amplifier.
6 XIA5600 INSTALLATION Output Connections The lighting elements of DUAL illuminite speakers provide you with a unique custom touch to your vehicle.
7 XIA5600 INSTALLATION Amplifier Connections Speaker Connections Connect speaker wires observing polarity. The minimum impedance load is 2 ohms stereo and 4 ohms bridged. Use of loads lower than these is not recommended and may cause amplifier damage.
8 XIA5600 OPERATION Configuration/Setup The input level control (gain) is used to obtain the best possible match between the head unit audio output and the amplifier input. Begin by turning the input level control fully counterclockwise. Next, turn up the head unit volume control around 3/4 of the way up.
9 XIA5600 WARRANTY Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
10 XIA5600 OPERATION Specifications CEA-2006 Power Standard Specifications (reference: 14.4VDC +/-0.2V, 20Hz~20kHz) Power Output: 200 Watts RMS x 2 channels at 4 ohms.
11 XIA5600 OPERATION Troubleshooting Problem Cause Action Unit will not turn on (no power LED indicator) +12V wire not connected or incorrect voltage REM wire not connected or inco.
Dual Electronics Corp. Toll Free: 1-866-382-5476 www.dualav.com ©2006 Dual Electronics Corp. NSA0806-V01.
An important point after buying a device Dual XIA5600 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dual XIA5600 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dual XIA5600 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dual XIA5600 you will learn all the available features of the product, as well as information on its operation. The information that you get Dual XIA5600 will certainly help you make a decision on the purchase.
If you already are a holder of Dual XIA5600, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dual XIA5600.
However, one of the most important roles played by the user manual is to help in solving problems with Dual XIA5600. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dual XIA5600 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
