Instruction/ maintenance manual of the product ETAM36.365 DeLonghi
Go to page of 22
ET AM36_AU/ 02.13.
DE GB ET AM36.365 BEAN T O CUP ESPRESSO AND C APPUCCINO MA CHINE Instruction for use.
2 2 B2 B3 B5 B6 B4 C1 D1 D2 D3 D6 D7 D8 B1 B7 B12 B11 B10 B9 B8 C2 C3 C4 C5 C6 D5 D4.
3 A7 A8 A9 A1 A5 A4 A3 A2 A10 B A12 A14 A11 A6 A7 A24 A23 A15 A16 A18 A17 A21 A20 A22 A19 A13 3.
4 4 13 4 56 6 78 91 0 11 12 13 14 15 16 2.
5 5 18 17 26 22A 19 20 21 23 22B 27A 27B 24 25 29 30 30 33 32 28.
6 CONTENTS TECHNICAL DA T A ................................................................ 6 DISPOSAL .......................................................................... 6 INTRODUCTION .........................................................
7 INTRODUC TION Thank you for choosing the ET AM36.365 automa tic bean t o cup espresso and cappuccino machine. W e hope you enjoy using your new applianc e. T ake a few minutes to read these instr uc tions. This will av oid all risks and damage to the appliance.
8 Please note: Keep these instructions. If the appliance is passed to other per- sons, they must also be pro vided with these instructions. DESCRIPTION Description of appliance (page 3 - A ) A1. T op lid A2. Beans container A3. Pre-ground coee funnel lid with pressur e closure A4.
9 Connecting the appliance Important! Check that the mains power supply voltage corresponds to the value indicated on the rating plate on the bottom of the ap - pliance. Connect the appliance to an eciently ear thed and correctly installed socket with a minimum curren t rating of 10A only .
10 MENU SETTINGS T o access the settings menu , press the butt on corresponding t o MENU . Scroll throu gh the menu by pres sing the sc roll ing arr ow (< or >) (g. 9). Rinsing Use this function t o deliv er hot water from the spout to heat the internal circuit and make the c oee delivered hotter .
11 3. Pr ess the button; 4. Press the scrolling arrow (< or >) (g. 9) until the number of minutes/hours of operation is displayed (15 or 30 min- utes, or 1, 2 or 3 hours); 5. Press the button t o conrm; 6. Press the MENU/ESC butt on to exit the menu.
12 T o display , proceed as follows: 1. Pr ess the MENU/ESC button to enter the menu; 2. Press the scrolling arrow (< or >) (g. 9) until “Sta tistics” is displayed; 3. Press the butt on; 4. By pressing the scrolling arrow (< or >) (g.
13 - 1 cup , if you want 1 coee (g . 15); - 2 cups if you want 2 c oees (g. 17). 3. Low er the spout as near as possible to the cups (g. 16). This mak es a creamier coee . 4. Press the button corresponding to the number of coees requir ed (1 cup or 2 cups ).
14 No froth FLA T WHITE/ MILK (hot milk) Min. froth L AT T E Max. froth CAPPUCCINO/ MILK frothed milk Making milk based drinks automatically The FLA T WHITE, CAPPUCCINO , LA TTE and MILK buttons on the control panel enable these drinks to be pr epared aut omatically .
15 avoid splashes). 3. Press the button (g. 3). “Prepara tion underway” is displayed (if required). Then hot water is delivered and “HOT W A TER” is displayed, together with a progress bar which lls gradually as prepara tion proceeds. 4.
16 • Check the condensate tr ay and empty if necessar y (g. 29). Important! When removing the drip tray , the grounds container must be emptied, even if it c ontains few grounds. If this is not done , when you mak e the next coees, the grounds c ontainer may ll up more than expected and clog the machine.
17 Please note! Iftheinfuser isdiculttoinser t,beforeinser tion,squeezethe two levers shown in the gur e to make it smaller . 8. Once inserted, make sure the two red buttons hav e snapped out. PUSH 9. Close the infuser door .
18 soft water ● slightly hard w ater ●● hard wa ter ●●● very hard water ●●●● Setting water hardness 1. Press the MENU/ESC butt on to enter the menu. 2. Press the scrolling arrow (< or >) until “W ater Hardness” is displayed .
19 5. Place the lter in the water tank and sub - merge it completely for ten seconds, tilting it to enable the air bubbles to escape (g. 39). 6. Insert the lter into the lter housing and press as far as it will go (g. 40A). 7. Close the tank with the lid (g.
20 DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION FILL TANK Insucientwaterinthetank. F ill the tank with water and/or inser t it correctly, pushing it as far as it will go until it clicks into place . EMPTY GROUNDS C ONT AINER The grounds con tainer (A18) is full.
21 TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolv ed as described, contact customer services. PROBLEM POSSIBLE CAUSE SOLUTION The coee is not hot . The cups were not pr eheated. • Enablethecupwarmer ,leavethecupsatleast20 minutes to warm up .
An important point after buying a device DeLonghi ETAM36.365 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought DeLonghi ETAM36.365 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data DeLonghi ETAM36.365 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, DeLonghi ETAM36.365 you will learn all the available features of the product, as well as information on its operation. The information that you get DeLonghi ETAM36.365 will certainly help you make a decision on the purchase.
If you already are a holder of DeLonghi ETAM36.365, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime DeLonghi ETAM36.365.
However, one of the most important roles played by the user manual is to help in solving problems with DeLonghi ETAM36.365. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device DeLonghi ETAM36.365 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
