Instruction/ maintenance manual of the product CMD-4000 Dakota Digital
Go to page of 6
CMD-4000 SERIES REV. A 4+ FUNCTION REMOTE CONTROL DOOR LATCH OPENER SYSTEM INTRODUCTION Thank you for purchasing the CMD-4000 series Remote Control Door Latch Opener System from Dakota Digital, Inc. This, along with many other products that Dakota Digital, Inc.
2 WIRING HARNESS COLOR CODE. 10 pin connector RED constant 12 volt battery source BLACK chassis ground YELLOW ignition key switched 12 volts VIOLET CHANNEL 7 relay (optional) WHITE/BLACK CHANNEL 6 rel.
The only wires that need to be passed to the doors are the two wires running to each door motor. This should be done using a flexible rubber t ube or rubber grommet to protect the wires, or by using the optional DAKOTA DIGITAL, INC.
GREEN CHANNEL 2 RED: +12 BATTERY OUTSIDE EMERGENCY RELEASE SWITCH DRIVER'S DOOR MOTOR (PDR-1 shown) +12 BATTERY RED FUSE BROWN CHANNEL 1 GROUND GROUND GREEN BLUE SPLICE SPLICE BLACK These channe ls must be connec ted to relays if they are used.
DIP SWITCH SETTINGS For optimal performance, all switches should be in the “O FF” position. If any switches are in the “ON” position damage or incorrect operation may occur to the attached components. TRANSMITTER PROGRAMMING All of the transmitters to be programmed into the syst em should be available.
TROUBLE SHOOTING GUIDE Symptom Possible Problem Solution ---------------------------------------------------------------------------------------------------------------------------------------------------- System will not operate doors Receiver is not getting Check 12 volt connection.
An important point after buying a device Dakota Digital CMD-4000 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dakota Digital CMD-4000 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dakota Digital CMD-4000 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dakota Digital CMD-4000 you will learn all the available features of the product, as well as information on its operation. The information that you get Dakota Digital CMD-4000 will certainly help you make a decision on the purchase.
If you already are a holder of Dakota Digital CMD-4000, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dakota Digital CMD-4000.
However, one of the most important roles played by the user manual is to help in solving problems with Dakota Digital CMD-4000. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dakota Digital CMD-4000 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
