Instruction/ maintenance manual of the product DSB-F183L Daewoo
Go to page of 18
MODEL #: DSB-F183L O WNER'S MANU AL S1 S/N : 3113909900.
1 This air conditioner meets strict safety and operating standards. The installer of this unit must install or service this unit so it operates safe- ly and efficiently.
2 Indoor Cover Electric Dust Collector (Air clean Plasma) Removes small dust and generates (-) ions. Deodorizing Filter Removes bad smells from the air. Emergency/Remote Switch Indicators Indicate the AC setting. Remote Sensor Power Plug Sensor Wire LCD Remote Controller Air Cleaning Filters Removes dust and prohibits germs.
3 INDOOR UNIT DISPLA Y ■ Remote Control Signal Receiver This place is the part to receive the signal if it receives the signal, you can hear the signal “ beep. beep ” . ■ There is a switch panel at inside of Front Panel. At the time of operating, open the Front Panel.
4 MODE SLEEP ON/OFF TIMER ENTER/ CANCEL FAN SPEED TURBO/MILD Display Displays information pertaining to unit. TURBO/MILD Press to select super power operation (Turbo) mode TIMER ENTER/CANCEL Button Press to enter a timer setting or to cancel timer setting TIMER ON/OFF Button Press to set the unit off or on time.
5 OPERA TION 1. Insert the attached AC plug into a 2-pronged Only 220V or 220V~240V AC outlet. Plug into 220V AC Outlet AC Outlet and Plug NOTES: • Never connect the AC line cord plug to other than the speci- fied voltage ( Only 220V or 220V~240V ).
6 CELSIUS T O F AHRENHEIT CONVERSION CHART CELSIUS FAHRENHEIT 18 64.4 19 66.2 20 68 21 69.8 22 71.6 23 73.4 24 75.2 25 77 CELSIUS FAHRENHEIT 26 78.8 27 80.6 28 82.4 29 84.2 30 86 31 87.8 32 89.6 NOTES: • When operating the remote controller, make sure there are no obstructions between the remote controller and the remote sensor.
7 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and “ ON ” will light in the remote display. 2. Press the MODE button until the Quick ( “” ) indi- cator blinks. 3. The unit will then start cooling or heating the room at the highest power.
8 T O OPERA TE ONL Y F AN To operate only the fan so the unit will circulate the air, proceed as follows: 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and “ ON ” will light in the remote display.
9 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and “ ON ” will light in the remote display.
10 2. While the unit is off, press the TIMER ON button; the display will light waiting input for the timer, but the actual unit will not turn on. 3. Repeatedly press the TIMER ON button until the desired hour that you want the unit to turn on appears on the display.
11 2. Press the TIMER OFF button once to enter the Timer screen. 3. Repeatedly press the TIMER OFF button until the desired hour that you want the unit to shut off appears on the display. For example, if it is 8:00 P.M. and you want the unit to turn off at 10:00 P.
12 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and “ ON ” will light in the remote display. 2. Press the MODE button to select the desired mode. Then, set the desired temperature using the T EMP.
13 CHANGING/CLEANING THE AIR FIL TERS 1. Open the indoor unit ’ s cover and remove both black air filters by bending them slightly backward and the lifting out. 2 . Remove the two small filters (Deodorizing and Electrostatic) from the indoor unit. 3.
14 CLEANING THE INDOOR CO VER 1 . Remove the left and right side to open the indoor cover upward by two hand NOTE: Please remove and insert the indoor by two hand 2. Open the door until 80 degree 80 ° 3 . Pull right side to remove indoor cover hinge from frame grille hinge hole 4.
C ARE AND MAINTEN ANCE 15 Clean the casing and front of the indoor unit with a vacuum brush or wipe with a clean damp cloth. • NEVER USE Solvents, harsh chemicals or hot water to clean the unit. • Some metal edges on the unit are sharp. Be careful when cleaning or handling.
TROUBLESHOO TING GUIDE 16 Before requesting service, please refer to the chart below for possible solutions: SYSPT OMS POSSIBLE CA USE POSSIBLE SOLUTIONS No power. Power failure. Restore the power Line voltage too low. Contact electrician to install new outlet.
Below is an overview for the connection of the Indoor unit to the Outdoor unit. O VER VIEW This appliance must be installed according to national power supply acquirement.
An important point after buying a device Daewoo DSB-F183L (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Daewoo DSB-F183L yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Daewoo DSB-F183L - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Daewoo DSB-F183L you will learn all the available features of the product, as well as information on its operation. The information that you get Daewoo DSB-F183L will certainly help you make a decision on the purchase.
If you already are a holder of Daewoo DSB-F183L, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Daewoo DSB-F183L.
However, one of the most important roles played by the user manual is to help in solving problems with Daewoo DSB-F183L. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Daewoo DSB-F183L along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
