Instruction/ maintenance manual of the product DGS-1224T D-Link
Go to page of 8
Before Your Begin This Quick Installation Guide gives step - by - step instructions for setting up the D - Link DGS1224T Gigabit Smart Switch . The model you have purchased may a p pear slightly different from those shown in the illustrations.
2 Setup The DGS - 1224T Gigabit Smart Switch The setup of the Switch can be performed using the following steps: A. Install the DGS - 1224T in a fairly cool and dry place. See Technical Specification for the accepta ble operation temperature and humidity ranges.
3 Mount the Switch in the rack Connecting Network Cable The DGS - 1224T supports 10 / 100 /1000 Mbps Gigabit Ethernet. It runs full/half duplex transfer mode for 10/100Mbps and full duplex transfer mode for 1000Mbps. Each port on the DGS - 1224T supports Auto - MDI/MDI - X.
4 n 1000BASE - T Twisted Pair Ports ( Por t 1 ~ 24) The DGS - 1224T is equipped with two Gigabit twisted pair ports that are auto negotiable 10/100/1000Mbps and also support auto MDI/MDIX crossover detection. These two ports can operate in half - and full - duplex modes.
5 n Ports 1 & 16 Status LEDs L ink /A ct On When the Link/A ct LED lights on, the respectiv e port is successfully connected to an Ethernet network. Blinking When the Link/A ct LED is blinking, the port is transmitting or receiving data on the Ethernet network.
6 I nstalling the Web Management Utility Through the Web Browser you can configure the Switch such as VLAN, Trunking, QoS … etc . The following instruction guid es you to install the Web Management utility. 1. Insert t he Utility CD in the CD - Rom Drive.
7 PC must be set on the same IP network . For example, when the default network address of the default IP address of the Web Smart Switch is 192.168.0.1 , then the manager PC should be set at 192.168. 0 .x (where x is a number between 2 and 254), and the default subnet mask is 255.
8 Setup Menu When t he m ain page appe ars , f ind the Setup menu in the left side of the screen (Figure 5) . Click on the setup item that you want to configure .
An important point after buying a device D-Link DGS-1224T (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought D-Link DGS-1224T yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data D-Link DGS-1224T - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, D-Link DGS-1224T you will learn all the available features of the product, as well as information on its operation. The information that you get D-Link DGS-1224T will certainly help you make a decision on the purchase.
If you already are a holder of D-Link DGS-1224T, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime D-Link DGS-1224T.
However, one of the most important roles played by the user manual is to help in solving problems with D-Link DGS-1224T. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device D-Link DGS-1224T along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
