Instruction/ maintenance manual of the product EZ-10 CrimeStopper
Go to page of 12
EZ-30 / EZ-10 REMOTE ENGINE STARTING SYSTEM OPERATING INSTRUCTIONS INTRODUCTION **IMPORTANT NOTES:- FOR EZ-10 MODEL ONLY** The EZ-10 Model is for remote starting purposes only. It has NO keyless entry functions. Any information in this manual pertaining to remote keyless entry functions, door lock & door unlock applies only to the EZ-30 model.
TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….…………………………2 Remote Control Diagrams………...…………………………………………………………………………….
REMOTE CONTROL DIAGRAMS #1 #2 #3 LOCK ENGINE UNLOCK VEHICLE #2 FLA SHLIGHT ST A RT/ST OP EZ-30 Engine St a r t / St o p Flashlight Ve h i c l e #2 EZ-10 System EZ-30 SYSTEM The transmitter supplied with the EZ-30 system has 5 butt ons total. The button configuration of the EZ-30 is Factory-set and unchangeable.
REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press the remote start button for at least 1 second. 2) Parking lights flash once; return solid, and the Ignition/Acc circuits turn on. 3) After a few seconds the Starter Motor engages, Parking lights and Acc circuits will turn off while cranking.
REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock system (EZ-30) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park.
REMOTE ENGINE CONTROL INFINITY RUN MODE This mode can only be activated when "Idle Down" procedure. The Infinity Run mode allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses .
TURBO TIMER MODE (OPTIONAL) The optional Turbo Timer mode allows the EZEE Start syst em to keep a Turbo or Turbo Diesel vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors remotely. This is handy for turbo cool-down without the need for expensive turbo ti mers.
CONVENIENCE AND SAFETY FEATURES EZ-30 ONLY: KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) via remote control for safety and convenience. Note: This feature may require extra labor and/or parts to install.
CONVENIENCE AND SAFETY FEATURES BRAKE PEDAL RESET Prevents starting or shuts off a remote started vehicle w hen this circuit is active or activated. Prevents unauthorized tampering. This circuit s huts the system down immediately when brake pedal is pressed if the key is not in ignition and turned to the ON position.
TRANSMITTER PROGRAMMING TRANSMITTER PROGRAM DIAGRAM: IGN OFF WAIT F O R 4 FLA SHE S PRESS 4 X's FLA SH 2, 3, or 4 X's (GRA Y WIRE GR OUNDED) EZ-30 IGN OFF PRESS PRESS LOCK BUTT ON EZ-10 COMP.
2-VEHICLE OPERATION The EZ-30/10 systems can be used for 2 vehicle operation. A single remote can control a second vehicle with an identical system installed. There are some exceptions. See “Multi-Vehicle Notes” section below. VEHICLE #2 Press low er side button first, then you hav e 4 seconds to control v ehicle #2.
TROUBLESHOOTING: “BEFORE YOU CALL” SECTION UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START: The unit senses a fault at the Brake (Purple wire is active) or the Hood is OPEN (Gray wire grounded). This is a safety feature of the unit. Check installation for faults and make sure hood is closed and latched and brake wire is not active.
An important point after buying a device CrimeStopper EZ-10 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought CrimeStopper EZ-10 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data CrimeStopper EZ-10 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, CrimeStopper EZ-10 you will learn all the available features of the product, as well as information on its operation. The information that you get CrimeStopper EZ-10 will certainly help you make a decision on the purchase.
If you already are a holder of CrimeStopper EZ-10, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime CrimeStopper EZ-10.
However, one of the most important roles played by the user manual is to help in solving problems with CrimeStopper EZ-10. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device CrimeStopper EZ-10 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
