Instruction/ maintenance manual of the product Drop-In and Free-Standing Ice Cooled Dispensers Cornelius
Go to page of 9
1 E IMI Cornelius Inc; 1994–2003 10/4/94 166239001 Revised 10/8/03 Rev . Level1 www .cornelius.com T elephone (800) 238-3600 INST ALLA TION INSTRUCTION THIS INST ALLA TION INSTRUCTION APPLIES TO ALL MODELS OF DROP-IN AND FREE-ST ANDING ICE COOLED DISPENSERS.
10/4/94 166239001 2 Revised 10/8/03 E IMI Cornelius Inc; 1994 – 2003 Rev . Level 1 5. Remove any excess sealant. Note: For non-electrical valves, skip the next step. 6. Mount the T ransformer power supply under the counter , in a position to allow access to the electrical outlet and to allow the 24V power cord to reach the dispenser .
10/4/94 166239001 3 Revised 10/8/03 E IMI Cornelius Inc; 1994 – 2003 Rev . Level 1 C. Continue to activate the dispensing valve in cycles ( “ ON ” for 15-seconds, “ OFF ” , then “ ON ” for 15-seconds). Repeat “ ON ” and “ OFF ” cycles for 15-cycles.
10/4/94 166239001 4 Revised 10/8/03 E IMI Cornelius Inc; 1994 – 2003 Rev . Level 1 4. Remove sanitizing solution source from the syrup system. 5. Allow sanitizing solution to remain in the syrup systems for not less than 10 or no more than 15-minutes (max.
10/4/94 166239001 5 Revised 10/8/03 E IMI Cornelius Inc; 1994 – 2003 Rev . Level 1 CLEANING THE ICE BIN 1. Prepare a mild detergent soap solution in 100 ) F potable water . 2. Using a nylon (not wire) bristle brush, clean the cold plate and the interior of the ice bin with the soap solu- tion.
10/4/94 166239001 6 Revised 10/8/03 E IMI Cornelius Inc; 1994 – 2003 Rev . Level 1 5. Fill the bin with 32 ) F ice. DO NOT use ice taken directly from a freezer . 6. Adjust the brix (water-to-syrup ratio) for post-mix valves. 7. Set the flow rate for pre-mix valves.
10/4/94 166239001 7 Revised 10/8/03 E IMI Cornelius Inc; 1994 – 2003 Rev . Level 1 TROUBLESHOOTING TROUBLESHOOTING T rouble Probable Cause Remedy ADJUSTMENT OF DISPENSING V AL VE SYRUP FLOW REGULA T OR DOES NOT INCREASE TO DESIRED W A TER-TO-SYRUP ‘‘ RA TIO ’’ A.
10/4/94 166239001 8 Revised 10/8/03 E IMI Cornelius Inc; 1994 – 2003 Rev . Level 1 T rouble Remedy Probable Cause DISPENSED PRODUCT COMES OUT OF DISPENSING V AL VE CLEAR BUT FOAMS IN CUP OR GLASS A. Oil film or soap scum in cup or glass. A. Use clean cup or glass.
10/4/94 166239001 9 Revised 10/8/03 E IMI Cornelius Inc; 1994 – 2003 Rev . Level 1 T rouble Probable Cause Remedy ONL Y CARBONA TED WA TER DISPENSED, Continued G. Dispensing valve syrup flow regulator , syrup tank quick disconnect, or syrup lines restricted.
An important point after buying a device Cornelius Drop-In and Free-Standing Ice Cooled Dispensers (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Cornelius Drop-In and Free-Standing Ice Cooled Dispensers yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Cornelius Drop-In and Free-Standing Ice Cooled Dispensers - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Cornelius Drop-In and Free-Standing Ice Cooled Dispensers you will learn all the available features of the product, as well as information on its operation. The information that you get Cornelius Drop-In and Free-Standing Ice Cooled Dispensers will certainly help you make a decision on the purchase.
If you already are a holder of Cornelius Drop-In and Free-Standing Ice Cooled Dispensers, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Cornelius Drop-In and Free-Standing Ice Cooled Dispensers.
However, one of the most important roles played by the user manual is to help in solving problems with Cornelius Drop-In and Free-Standing Ice Cooled Dispensers. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Cornelius Drop-In and Free-Standing Ice Cooled Dispensers along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
