Instruction/ maintenance manual of the product 517212-001 Compaq
Go to page of 26
Printed in Upgrading and Ser vicing Guide.
.
Removing and Replacing the Hard Disk Drive Features may var y by model..
.
517212-001 — Removing and Replacing the Hard Disk Drive 3 Removing and Replacing the Hard Disk Drive 20 to 40 minutes Before Y ou Begin After you replace the hard disk drive, you have to perfor m a system recover y . Refer to the documentation that came with your computer for deta iled system recover y steps.
4 517212-001 — Removing and Replacing the Hard Disk Drive Removing the Hard Disk Drive 1 Remove all removable media such as CDs or DVDs from the computer . 2 T urn off the computer using the shutdown procedure for your operating system. 3 Disconnect the power from the wall and from the back of the computer .
517212-001 — Removing and Replacing the Hard Disk Drive 5 9 Release the two latching tabs on the left side of the front bezel by pulling them slightly outward. When the left side of the front bezel is released, pull it away from the computer . 10 Spread a towel or soft cloth on your working surface.
6 517212-001 — Removing and Replacing the Hard Disk Drive 15 Remove the two hard drive retention screws. Set them aside for use with the new hard drive. 16 Slide the hard drive to the rear of the computer until it stops. Then slide the hard drive toward the center of the computer to release it.
517212-001 — Removing and Replacing the Hard Disk Drive 7 Replacing the Hard Disk Drive 1 Remove the two guide screws from the old hard drive. 2 Install the guide screws into the new hard drive.
8 517212-001 — Removing and Replacing the Hard Disk Drive 4 Place the drive so the guide screws fit into the guide screw slots. The drive manufacturer’ s label should be visible when the drive is in place. 5 Push the hard drive back in to the bay and then to the right until it locks.
517212-001 — Removing and Replacing the Hard Disk Drive 9 8 Insert the tabs at the rear of the optical drive and cage assembly into the slots at the rear of the computer . Then lower the front of the drive and cage assembly onto the computer . 9 Replace the two optical drive cage screws.
10 517212-001 — Removing and Replacing the Hard Disk Drive 13 Align the tabs on the inside edge of the left side panel with the slots in the edge of the left side of the computer case. 14 Slide the left side panel into place. 15 Replace the screws that secure the side panel to the computer .
517212-001 — Removing and Replacing the Hard Disk Drive 11.
12 517212-001 — Removing and Replacing the Hard Disk Drive.
Removing and Replacing the Optical Disc Drive Features may var y by model..
.
517212-001 — Removing and Replacing the Optical Disc Drive 13 Removing and Replacing the Optical Disc Drive 15 to 25 minutes Before Y ou Begin Obser ve the following requirements before removing and replacing an optical disc (CD/DVD) drive. T ools Needed Flathead screwdriver Hewlett-Packard recommends using a magnetic tipped screwdriver .
14 517212-001 — Removing and Replacing the Optical Disc Drive Removing the Optical Disc Drive 1 Remove all removable media such as CDs or DVDs from the computer . 2 T urn off the computer using the shutdown procedure for your operating system. 3 Disconnect the power from the wall and from the back of the computer .
517212-001 — Removing and Replacing the Optical Disc Drive 15 9 Release the two latching tabs on the left side of the front bezel by pulling them slightly outward. When the left side of the front bezel is released, pull it away from the computer . 10 Spread a towel or soft cloth on your working surface.
16 517212-001 — Removing and Replacing the Optical Disc Drive 14 Remove the four screws (two on each side) that hold the optical drive in the drive cage. 15 Remove the drive cage from the drive. Replacing the Optical Disc Drive 1 Place the drive cage onto the drive.
517212-001 — Removing and Replacing the Optical Disc Drive 17 3 Replace the four drive cage screws. 4 Reconnect the power cable and data cable to the optical drive. 5 Insert the tabs at the rear of the optical drive and cage assembly into the slots at the rear of the computer .
18 517212-001 — Removing and Replacing the Optical Disc Drive 9 Snap the left side of the bezel in place. 10 Align the tabs on the inside edge of the left side panel with the slots in the edge of the left side of the computer case. 11 Slide the left side panel into place.
.
.
.
Copyright © 2009 Hewlett-Packar d Development Company , L.P . The information contained herein is subject to change without notice. Ve r s i o n : 2 .
An important point after buying a device Compaq 517212-001 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Compaq 517212-001 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Compaq 517212-001 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Compaq 517212-001 you will learn all the available features of the product, as well as information on its operation. The information that you get Compaq 517212-001 will certainly help you make a decision on the purchase.
If you already are a holder of Compaq 517212-001, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Compaq 517212-001.
However, one of the most important roles played by the user manual is to help in solving problems with Compaq 517212-001. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Compaq 517212-001 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
