Instruction/ maintenance manual of the product 3201560 Char-Broil
Go to page of 16
428021 19 (01-09-04) THIS UNIT IS HEAVY. DO NOT assemble without helper. Some parts may contain sharp edges - especially as noted in manual. Wear protective gloves if necessary. Read and follow all safety statements, warning, assembly instructions and use & care directions before attempting to assemble and cook.
ST OP! Missing a part? No need to go back to the store! The store where you made your purchase does not stock parts for this item. If you need parts, whether they are missing or damaged, call the Customer Service toll free Help Line. Call us and we will gladly ship the part you need FREE OF CHAR GE.
Attach leg braces to the outside of one leg assembly using #10-24x1¾” screws and #10-24 flange nuts . Make sure slotted (oval) hole is toward bottom of leg . Do not fully tighten screws until Step 8 is complete. 2 1 FIRST, GET A HELPER! This unit is heavy and requires a second person for lifting and moving.
3 Lay the leg assembly on its side with legs braces pointing upward. Insert the wood rack hooks into leg holes and swing rack upward, parallel to leg braces. 4 With the aid of a helper , place leg holes of remaining leg assembly over wood rack hooks and rotate leg assembly un til it meets the leg braces.
6 5 Insert a cotter pin into the hole at one end of the axle and bend the ends of the pin back so that it cannot be removed. Slide a wheel onto the axle. Slide the axle through the holes at the ends of the short legs. Slide remaining wheel onto axle and secure with remaining cotter pin.
7 8 Smokestack NOTE: Smoker chamber door not pictured for clarity . From inside the smoker chamber , slide the smokestack through the large hole. Align the two holes in the smokestack plate with the holes in the chamber and secure with two 1/4-20x3/4” hex-head bolts outside the chamber and 1/4-20 flange nuts inside.
9 10 Attach wood handle to smoker chamber door using two 1/4-20x3” screws , flat washers , handle spacers and 1/4-20 flange nuts , as shown below . Repeat to attach handle to firebox door. NOTE: Smoker chamber door not pictured for clarity . Install grate support screws in the four rear holes and two front-center holes in the smoker chamber .
NOTE: Smoker chamber door not pictured for clarity . Attach shelf brackets to outer holes on front of smoker chamber using two 1/4-20x1¼” hex-head bolts and 1 /4-20 flange nuts. DO NOT FULLY TIGHTEN. 12 11 Shelf bracket NOTE: Smoker chamber door not pictured for clarity .
14 13 If you have purchased the optional 3” Temperature Gauge, part number 40003010 , remove the attached nut, insert gauge stem into large hole in cooking chamber door and attach nut to gauge on inside of door . DO NOT OVERTIGHTEN NUT . Make sure text and graphics are aligned for easy viewing.
16 15 If logo plate is not already installed, insert logo plate pins into two holes in lower right corner of smoker chamber door . Press logo plate clips onto pins until snug against inside of door . Logo plate NOTE: Smoker chamber door not pictured for clarity .
18 17 Firebox Fire Grate Installation for Smoking or Grilling: NOTE: Firebox side door not pictured for clarity . Place remaining wire fire grate into bottom of firebox through side door . Wire fire grate (1) Firebox Cooking Grate Installation for Grilling: NOTE: Firebox door not pictured for clarity .
WARNING MOST SURF ACES ON THIS UNIT ARE HOT WHEN IN USE. USE EXTREME CAUTION. KEEP OTHERS A W A Y FROM UNIT . AL W A YS WEAR PROTECTIVE CLOTHING TO PREVENT INJUR Y . HARD WARE LIST Hardware is shown actual size. You may have spare hardware after assembly is complete.
Preparing and Using Your Silver Smoker Before cooking with your Silver Smoker , the following steps should be closely followed to both cure the finish and season the interior steel. Failure to properly follow these steps may damage the finish and/or impart metallic flavors to your first foods.
Limited Warranty Charbroil warrants the Silver Smoker for replacement or repair of parts and/or workmanship for a period of 3 months. Charbroil warrants to the original Silver Smoker owner repair or replacement of the cooking chamber only should "burn out" or "rust through" occur for a period of 1 year .
.
For warranty service CALL T OLL FREE 1-800-232-3398.
An important point after buying a device Char-Broil 3201560 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Char-Broil 3201560 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Char-Broil 3201560 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Char-Broil 3201560 you will learn all the available features of the product, as well as information on its operation. The information that you get Char-Broil 3201560 will certainly help you make a decision on the purchase.
If you already are a holder of Char-Broil 3201560, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Char-Broil 3201560.
However, one of the most important roles played by the user manual is to help in solving problems with Char-Broil 3201560. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Char-Broil 3201560 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
